ooma SENSE001 DECT module User Manual Ooma QSG Door Window Sensor EN 2016 09 28 R4 indd
ooma, Inc. DECT module Ooma QSG Door Window Sensor EN 2016 09 28 R4 indd
ooma >
Contents
- 1. Manual
- 2. Manual - Door Window Sensor
- 3. Manual - Water Sensor
Manual - Door Window Sensor
Quick Start Guide
700-0163-100
Step 1 Step 2
Key Features Additional Information Need Help? Pair Your Sensor Mount Your Sensor
To get started, download and install the Ooma Home
Monitoring app on your iOS or Android device.
The app can be found at: ooma.com/app
When the app is installed, log in using your Ooma
phone number and My Ooma password. If you forgot
your password, reset it at: my.ooma.com
Complete the initial setup in the app, and then follow
the instructions on your screen to pair your sensor.
Status indicator light
Pairing button
Magnet tab
Tamper sensor
Mounting plate
Quick release button
Starting pairing mode
Your sensor automatically enters pairing mode when
you insert the batteries. You can also press and hold
the pairing button for ve seconds to start pairing
mode. Status indicator light blinks quickly when
in this mode.
Checking battery level
Tap the pairing button to check the battery level.
A long ash indicates that the battery is good.
A slow blink indicates that the battery is low.
Using the included adhesive pads or screws, mount
one piece of the sensor onto the moving part of your
door or window, and then mount the other onto
your door or window frame. These pieces should be
mounted so that when the door or window is closed
the dots are no more than 3/4 inch apart.
Keep the front side of both pieces
even with each other if possible.
If needed, attach additional
risers (included) to raise the
height of the magnet tab.
3/4” maximum
Top view Support articles
www.ooma.com/support
User manuals
www.ooma.com/userguide
Community forum
forums.ooma.com
Live customer care:
1-888-711-6662 (US)
1-866-929-5552 (Canada)
Legal
For warranty, safety, and other legal information,
visit ooma.com/legal
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) This device must accept any interference
received, including interference that may cause
undesired operation.
Status indicator reference
Pairing mode
Quick red ashes
Battery good
Long red ash
Battery low
Short red ashes
Software update
Slow red double ashes
1 42 53 6
A
D
D
B
E
E
FF
GG
A
A
A
B
F
E
D
G
Ooma-QSG-Door-Window-Sensor_EN 2016-09-28-R4.indd All Pages 9/30/16 9:20 PM