shengzhen commercial and trade GDR15 Garage Remote Control User Manual INSTRUCTION GD R15

User Manual

INSTRUCTIONSTOPROGRAMAREMOTE:

1. Locatethegaragereceiveranddeterminetheunique8digitcode.Youmaysetanewcodeatthistime.Keep

noteoftheuniquecode.Thereceivershouldbeclosetotheopenerinyourgarage.

TIP:Usearandomsequenceofnumberstomakethecodeassecureaspossible!Avoideasytoguess

sequences.

2. Removethefrontpanelfromtheremotecontrolwhichwillexposethe8digitcodeselector.

3. Usingapapercliporpenmatchthecodetoyourreceiverwhichwasdeterminedinstep1.Theswitchhasan

onandoffpositionwhichisselectedbygentlypressingupordown.

*Repeatsteps1‐3foranyadditionalremotesyouwishtoprogram.The8digitcodeonallremotecontrolsmust

matchwhatwasselectedinstep1!

4. Replacefrontpanelandtestoperation.Standbackapproximately50ft(awayfromallmovingpartsand

doors,seewarningbelow)andpressthetransmitbutton.Thedoorshouldopenandcloseatthistime.Ifit

doesnotconfirmtheremotecontrolhasafunctioningbatteryandthe8digitcodematchesthereceiver.

INSTRUCTIONSTOERASEARemoteControlTransmitter:

Youmayeraseatransmitterbyselectinganewuniquecodeonyourreceiver.Alternatelyyoucanalterthe8digit

codeonthetransmittersoitDOESNOTmatchthereceiver.

Garage Remote Control User Manual

FCC Statement

Any Changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause

undesired operation.