Valeo Comfort and Driving Assistance A08TAA A08TAA, A08TAB User Manual A08TAA Owner Manual rev
Valeo Comfort and Driving Assistance A08TAA, A08TAB A08TAA Owner Manual rev
Owner Manual
Valeo Sécurité Habitacle Product Group Interior Electronics Business Group Comfort & Driving Assistance Owner Manual (draft) Model: Transmitter (CD4 IKT) Model No.: A08TAA, A08TAB FCC ID: N5F-A08TAA IC: 3248A-A08TAA (preliminary draft, some change may appear in the final version) [1/5] Remote Keyless Entry - Top view - UnLock button Lock button Trunk opening button Panic button Model A08TAB A08TAB (4 buttons) Model A08TAA A08TAA (3 buttons) - Botton view - Car Maker logo (brand) [2/5] 1. OPERATION LOCK Press this button once to lock all doors. Some exterior lights will flash once (to be confirmed). Doors can not be locked if any door is not fully closed or the key is in the ignition switch. UNLOCK Press this button once to unlock the driver’s door. Push it twice to unlock the other doors. Some exterior lights will flash twice (to be confirmed) each time you press the button. This button does not work when the key is in the ignition switch. TRUNK RELEASE (on certain version) Press this button for about 1 second (to be confirmed) to release the trunk. Trunk can not be opened if the key is in the ignition switch. PANIC Press this button for about 1 second (to be confirmed) to attract attention;the horn will sound, and the exterior lights will flash for about 30 seconds (to be confirmed). To cancel panic mode, press any other button on the remote transmitter, or insert the key. 2. TRANSMITTER CARE ♦ ♦ ♦ ♦ Avoid dropping or throwing the transmitter. Protect the transmitter from extreme temperature. Do not immerse the transmitter in any liquid. If you lose a transmitter, the replacement needs to be reprogrammed by your dealer. [3/5] 3. BATTERY REPLACEMENT The battery is not rechargeable. To replace the battery: ① Push the button on the transmitter to extend the key blade. ② Remove the battery cover by prying it with a finger. Note the polarity. ③ Remove the battery by pushing on the battery and sliding it toward the key blade. ④ Insert the new battery, positive side facing up. Push the battery down until it is held in place. Replace with a CR2032 or equivalent battery. ⑤ Snap the battery cover back on to the transmitter Avoid touching the new batteries with your fingers. Do not touch the printed circuit board or the PCB battery holder [4/5] REGULATORY INFORMATION For USA & Canada FCC ID: N5F-A08TAA IC: 3248A-A08TAA English: This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standards. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTICE: Changes or modifications made to this equipment not expressly approved by other than an authorized service facility may void the FCC authorization to operate this equipment. Français: Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. [5/5]
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Page Count : 5 Producer : GPL Ghostscript 8.54 Create Date : 2012:12:04 15:57:28+02:00 Modify Date : 2012:12:04 15:57:28 Title : A08TAA_Owner Manual_rev. Creator : PDFCreator Version 0.9.3 Author : hugotj Subject :EXIF Metadata provided by EXIF.tools