ADC Telecommunications RPT190AA ADC's In-Building Wireless Repeaters BDA - PCS User Manual Addendum

ADC Telecommunications Inc ADC's In-Building Wireless Repeaters BDA - PCS Addendum

Contents

User Manual 3

     Mailing Address: P.O. Box 1101, Minneapolis, Minnesota 55440-1101 World Headquarters: Minneapolis, Minnesota  USA  +1.952.938.8080   www.adc.com  Addendum ADCP-75-237  ADC In-Building 850 and 1900 MHz Wireless Repeater - User Manual Addendum        PRODUCT DESCRIPTION  This publication provides basic information about the ADC In-Building 850 and 1900 MHz Wireless Repeater.  Place this addendum with ADCP-75-237.  The repeater transmits RF in both directions to provide indoor wireless coverage. The device connected via coax to a donor antenna that is typically located on a rooftop or external wall building, directed at the donor cell-site. The repeater is mounted inside the building distributes the RF over coax to an indoor antenna located in the desired coverage area.    Wireless Repeater Nominal Specifications: PARAMETER  SPECIFICATION  REMARKS System bandwidth  15 + 5 MHz   - PCS A or B Band   - Cellular   Frequency range (TX)  1930 – 1990 MHz  - PCS 869 – 894 MHz     - Cellular   Out-of-band emissions  -13 dBm per 1 MHz bandwidth from 30 MHz to 20 GHz   Passband Gain  60.0 dB   Composite RF Output power (see Note 1 at end of table)  +13 dBm (20.0 mWatts) at antenna port   Gain variation  ± 3 dB over temp and unit-to-unit   Gain flatness    Band flatness    Channel flatness   ± 1.5 dB across freq. range ± 1.0 dB across any 1.25 MHz channel  Mounting Wall mounted  Operating Temperature  -5° C to +45° C   Antenna Connector  50 ohm N-Type (Female) 50 ohm SMA-Type (Female)  50 ohm impedance Voltage Input  100-240 VAC, 47-63 Hz   Note 1: Per Industry Canada Section 5.3 - The Manufacturer's rated output power of this equipment is for single carrier operation.  For situations when multiple carrier signals are present, the rating would have to be reduced by 3.5 dB, especially where the output signal is re-radiated and can cause interference to adjacent band users.  This power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the device."
     Mailing Address: P.O. Box 1101, Minneapolis, Minnesota 55440-1101 World Headquarters: Minneapolis, Minnesota  USA  +1.952.938.8080   www.adc.com         STANDARDS CERTIFICATION  FCC:  This equipment complies with the applicable sections of Title 47 CFR Part 22 (850 MHz Cellular and Part 24 (1900 MHz PCS).  IC: This equipment complies with the applicable sections of RSS-131. The term “IC:” before the radio certification number only signifies that Industry Canada Technical Specifications were met.  Caution: Modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.  Note:  To comply with Maximum Permissible Exposure (MPE) requirements, antennas must be installed to provide at least 20 centimeters of separation from all persons per FCC 47CFR, Part 2.1091 and IC RSS-102, Section 2.5.2.

Navigation menu