API Healthcare PROXAW01 RFID Badge Reader User Manual AWID RFID Inst rev 100

Download:
Mirror Download [FCC.gov]
Document ID	1200998
Application ID	H6GBQqEH8AnRoDIsjfTseQ==
Document Description	module installation manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	11.77kB (147130 bits)
Date Submitted	2009-11-17 00:00:00
Date Available	2009-11-18 00:00:00
Creation Date	2009-11-05 14:07:09
Producing Software	Acrobat Distiller 7.0.5 (Windows)
Document Lastmod	2009-11-05 14:11:11
Document Title	Microsoft Word - AWID RFID Inst rev 100.doc
Document Creator	PScript5.dll Version 5.2.2
Document Author:	gsutcliffe

AWID RFID Module Installation Manual
Series 500 Reader Installation
Version 1.00
Last Revision: 11/5/2009 Copyright 2009 API Healthcare Corporation.
API Internal Document – Company Confidential Information
Page 1of 4
Purpose
This document describes the installation process of the AWID RFID Module in the Series 500 Reader. This
module is an option that may be purchased by the customer.
Model Number: RDR-69N1AKU-API
Part number: EIPCR6010
NOTICE: Installation of this module may only be made by qualified API Healthcare
employees. This is not a field upgrade, and must be done at the API factory.
FCC Notice
FCC ID: W7N-PROXAW01
Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
FCC Interference Statement (Part 15.105 (b))
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Last Revision: 11/5/2009 Copyright 2009 API Healthcare Corporation.
API Internal Document – Company Confidential Information
Page 2of 4
Installing the RFID Module
1. Place double sided foam tape on the back side of the module as shown in Figure 1
Figure 1.
2. Place the module tape side up as shown in Figure 2.
Figure 2.
Last Revision: 11/5/2009 Copyright 2009 API Healthcare Corporation.
API Internal Document – Company Confidential Information
Page 3of 4
3. Place the TA-500 main circuit board in the case in the normal manner. Press down the TA-500 board to
ensure it makes contact with the tape on the RF module.
4. Install the screws to mount the main board to the case.
Figure 3.
5. Connect the cable from the RFID module to the COM2 connector as shown in Figure 3.
6. Complete final assembly of the unit.
Testing the RFID Module
1. Apply power and wait for the unit to boot up.
2. Enter Diagnostic Mode:
a. Hold the F1 key until the display shows: DIAGNOSTIC PIN
b. Enter the PIN number by pressing the following keys: 415049
c. Press 1 (BADGE)
d. Press 1 (RAW DATA)
3. Hold the test badge near the front plate of the reader until it displays: BAR SUCCESS.
4. Verify the number displayed matches the number printed on the test card.
5. This completes test of the module.
Last Revision: 11/5/2009 Copyright 2009 API Healthcare Corporation.
API Internal Document – Company Confidential Information
Page 4of 4

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
Author                          : gsutcliffe
Create Date                     : 2009:11:05 14:07:09-06:00
Modify Date                     : 2009:11:05 14:11:11-06:00
XMP Toolkit                     : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04
Producer                        : Acrobat Distiller 7.0.5 (Windows)
Creator Tool                    : PScript5.dll Version 5.2.2
Metadata Date                   : 2009:11:05 14:11:11-06:00
Format                          : application/pdf
Creator                         : gsutcliffe
Title                           : Microsoft Word - AWID RFID Inst rev 100.doc
Document ID                     : uuid:ac5b50c9-9fa5-435a-acb2-2c7c7f7566d8
Instance ID                     : uuid:98dde182-b8bb-4e1c-8a05-11e257fd8f28
Page Count                      : 4

EXIF Metadata provided by EXIF.tools