ARRIS 5200AC Wireless 802.11 uDSL Residential Gateway User Manual Warning statements insert
Pace Americas Wireless 802.11 uDSL Residential Gateway Warning statements insert
ARRIS >
Contents
- 1. User Manual
- 2. RF warnings Insert
- 3. Warning statements insert
Warning statements insert
![Declaration of conformityThe following sections describe regulatory compli-ance by region.FCC/Industry Canada complianceThis device has been tested and certied as compli-ant with the regulations and guidelines set forth in the Federal Communication commission - FCC part 15, FCC part 68 and Industry Canada - ICES003 and RSS-210 Radio and telecommunication regulatory requirements.Le présent materiel est conforme aux specications techniques applicables d’Industrie Canada. Cet appareil numérique de la classe [*] est conforme à la norme NMB-003 du Canada.Manufacturer: Pace Americas Models: 5268ACPart 15 of FCC rulesThis device complies with part 15 of the FCC Rules and Industry Canada license-exempt RSS stan-dard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation of the device.Le présent appareil est conforme aux normes CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:(1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouil-lage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.Users should be advised that high-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350 MHz and 5470-5725 MHz and that these radars could cause interference and/or damage to the LE-LAN device.Les utilisateurs doivent être avisés que les radars de haute puissance sont désignés utilisateurs princi-paux (c.-à-d., qu’ils ont la priorité) pour les bandes 5250-5350 MHz et 5650-5850 MHz et que ces radars peuvent causer du brouillage et/ou des dommages aux dispositifs LAN-EL.The device for operation in the band 5150-5250MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems.Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une utilisation à l’intérieur an de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux.Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential for radio interference to other users, the antenna type and its maximum gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for success-ful communication.Conformément à la réglementation d’Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d’un type et d’un gain maximal (ou inférieur) approuvé pour l’émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l’intention des autres utilisateurs, il faut choisir le type d’antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l’intensité nécessaire à l’établissement d’une communication satisfaisante. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connect-ed.• Consult the dealer or an experienced radio/TV technician for help.Caution: Changes or modications not expressly approved by the party responsible for compliance could void your authority to operate this equipment.Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential for radio interference to other users, the antenna type and its maximum gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than necessary for successful communication.Conformément à la réglementation d’Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d’un type et d’un gain maximal (ou inférieur) approuvé pour l’émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l’intention des autres utilisateurs, il faut choisir le type d’antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l’intensité nécessaire à l’établissement d’une communication satisfaisante.TIA 968 (Part 68 of FCC rules)/IC CS-03This equipment complies with the Telecommuni-cation Industry Association TIA-968 (FCC part 68) and Industry Canada CS-03 Telecommunication re-quirements. On the product is a label that contains, among other information, the IC and FCC registra-tion number and ringer equivalence number (REN) for this equipment. If requested, this information may be provided to the telephone company.The REN is used to determine the quantity of devices that may be connected to the telephone line. Excessive RENs on the telephone line may result in the device not ringing in response to an incoming call. In most, but not all areas, the sum of the RENs should not exceed ve (5.0)L’indice d’équivalence de la sonnerie (IES) sert à indiquer le nombre maximal de terminaux qui peu-vent être raccordés à une interface téléphonique. La terminaison d’une interface peut consister en une combinaison quelconque de dispositifs, à la seule condition que la somme d’indices d’équivalence de la sonnerie de tous les dispositifs n’excède pas 5.To be certain of the number of devices that may be connected to the line, as determined by the total RENs, contact the telephone company to determine the maximum RENs for the calling area.This product cannot be used on telephone-compa-ny-provided coin service. Connection to Party Line Service is subject to state taris.An FCC-compliant telephone cord and modular plug is provided with this equipment. This equipment is designed to be connected to the telephone network or premises wiring using a compatible modular jack that is Part 68 compliant. If this equipment causes harm to the telephone network, the telephone com-pany will notify you in advance that temporary dis-continuance of service may be required. If advance notice is not practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to le a complaint with the FCC if you believe it is necessary. The telephone company may make changes in its facilities, equip-ment, operations, or procedures that could aect the operation of this equipment. If this happens, the telephone company will provide advance notice in order for you to make the necessary modications to maintain uninterrupted service. If trouble is ex-perienced with this equipment, please contact Pace Americas, or your local Pace Americas distributor or service center in the U.S.A. for repair and/or warrant information. If the trouble is causing harm to the telephone network, the telephone company may request you to remove this equipment from the network until the problem is resolved. No repairs can be done by a customer on this equipment. It is recommended that the customer install an AC surge arrestor in the AC outlet to which this device is con-nected. This is to avoid damage to the equipment caused by local lightning strikes and other electrical surges.MPE/SAR/RF exposure informationThis device was veried for RF exposure and found to comply with Council Recommendation 1999/519/EC and FCC OET-65 RF exposure requirements. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.WARNING: While this device is in operation, a sepa-ration distance of at least 20 cm (8 inches) must be maintained between the radiating antenna inside the EUT and the bodies of all persons exposed to the transmitter in order to meet the FCC RF exposure guidelines. Making changes to the antenna or the device is not permitted. Doing so may result in the installed system exceeding RF exposure requirements. This device must not be co-located or operated in conjunction with any other antenna or radio transmitter.Cet appareil répond aux directives d’exposition RF 1999/519/EC et FCC OET-65 sur la limitation d’expo-sition du public général aux champs électromag-nétiques. MISE AN GARDE: Pour satisfaire aux exigences de la FCC et IC concernant l’exposition aux radiof-réquences, une séparation de 20 cm ou plus doit être maintenue entre cet appareil et des personnes lors de fonctionnement du dispositif. Pour assurer la conformité, des opérations au plus près que cette distance n’est pas recommandée. L’antenne utilisée pour cet émetteur ne doit pas être co-localisée ou fonctionner conjointement avec une autre antenne ou transmetteur.](https://usermanual.wiki/ARRIS/5200AC.Warning-statements-insert/User-Guide-2257561-Page-1.png)
