Advanced Mobile Payment AMP6500 AMP 6500 User Manual

Advanced Mobile Payment Inc. AMP 6500 Users Manual

Users Manual

RF exposure assessment has been performed to prove that this unit will not RF exposure information: The EIRP power of the device at maximal case is below ~ 45Jan 20186500The Microfit cable650065001. The device should be covered by a pin shield over the pin entry area.2. Avoiding the direct sunlight and the rain.3. Place the device in a ventilated locality and keep good a heat dissipation condition.Microfitpower or MDB power jack 65006500High Performance 4 Core Processor + Secure CPU1GB RAM, 8GB Flash memory, Support Micro TF Card, up to 32GB5”, 720x1280 pixels, support capacitate touch screenRS-232, Ethernet 10/100M, MDBPCI PTS 5.X, EMV LEVEL 1&2, EMV Contactless, CE, FCC, Pay Pass1 SAM, 1 TF card reader, MDB interface, Mircrofit port, proximity detector12V DC, 2A (when using Micro fit), 24 ~ 45V DC (when using MDB)(195x122x94mm)-(7.7x4.8x3.7’’)LxWxH1 key for reset, 1 key for setupAndroid OS 5.X720g(1.6lbs)-20℃ ℃(-4℉~ 113℉), 10% ~ 90% (non-condense)-25℃ ~ 75℃(-13℉~167℉), 0% ~ 95% (non-condense)IP65IK08 6500WATERPROOF PROTECTIONSAMTFSIMUSB - hostMicrofit7MDBAudioRS232USB-deviceEthernetPort coverMenu for setupResetSIM/SAM card coverTag label9Magnetic stripe cardUser smart card slotLCDNFC ledsAntenna inductive zoneCameraInfrared LEDInfrared sensorWaterproof ring54 core1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference.(2) This device must accept any interference received, including interference that may cause undesired operation.2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates uses and can radiate radio frequency energy and, if not installed andused in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:　 Reorient or relocate the receiving antenna.　 Increase the separation between the equipment and receiver.　 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.　 Consult the dealer or an experienced radio/TV technician for help.The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.6500-CB ~ 45MODULATION NFC 13.56MHzthe exemt condition, 20mW specified in EN62479: 2010. generate the harmful EM emission above the reference level as specified in EC Council Recommendation(1999/519/EC).

Navigation menu