Andrew Wireless Innovations Group RPT-MR703 Bi-Directional Amplifier for Small Area Indoor Coverage User Manual Appendix to

Andrew Wireless Innovations Group Bi-Directional Amplifier for Small Area Indoor Coverage Appendix to

Contents

Appendix to user manual

Appendix A : Installation Checklist:MR703D Users Guide Manual 149678 (m0041a3a, 5\00) Page A-1Appendix A : Installation ChecklistThe following checklist provides a summary of the procedures for installing a MR703D system:Step Item/ Action Description ♦1MR703D Site Drawing Master copy of the site plan noting the MR703D location andserial number, and the location of the indoor coverageantenna(s)). This should characterize the design parametersfor the system including cable paths and lengths.2Equipment List: Quantity: MR703D AC Power Outlet Coverage Antenna* Donor Antenna 50-ohm Donor Antenna Cable 50-ohm Donor Jumper* 50-ohm Coverage Antenna Cable3Installation tools: Cable connector Tools* Crimper, knife, etc. Multimeter To ensure no cable shorts. Handset with Power Indicator To verify coverage after commissioning.4Run Cable Install Cable in the site.5Attach Connectors* Measure across center pin and outer shell (ground) to ensureno short.6Verify “Donor andCoverageAntennas ” locations areconsistant with RF exposure warning(see above and below).Be sure to record the antennas location status for futurereference.7Record Serial Numbers and Locationson site Drawing. Note: this is to aid the Mikom Technical Support Specialists,should you need their assistance.8Mount the Equipment Including indoor coverage antennas for metal case models.9Connect the 50-ohm Cables as shownon the Site Plan Use caution when connecting semi-flexible cables to themounted MR703D and antennas. Excessive force on antennaor MR703D connectors will result in serious equipmentdamage.10 Supply AC Power, and commissionthe System. Check the MR703D status as described in previous section .11 Check Power Levels Check power indication of handheld mobile at variouslocations within the coverage area.* As RequiredWARNING! While this device is in operation, a separation distance ofat least 20 centimeters must be maintained between radiating antennasand the body of the user or nearby persons in order to meet the FCC RFexposure guidelines.WARNING! While this device is in operation, a separation distance ofat least 20 centimeters must be maintained between radiating antennasand the body of the user or nearby persons in order to meet the FCC RFexposure guidelines.

Navigation menu