Bang and Olufsen a s BEOCOM1 Cordless Telephone User Manual Correction 3507344 page 65

Bang & Olufsen a/s Cordless Telephone Correction 3507344 page 65

User Manual insert

Corrections to the Guide page 65For the American market only…This equipment complies with Part 68 ofthe Federal CommunicationsCommission (FCC) rules for the UnitedStates.A label is located on the underside of thebase unit containing either the FCCregistration number and RingerEquivalence Number (REN). You mustupon request, provide the followinginformation to your local telephonecompany:USOC Jack Type: RJ11REN: 0.1BShould you experience trouble with thistelephone equipment, please contact:Bang & Olufsen America, Inc.780 West Dundee RoadArlington HeightsIL  60004 U.S.A. Phone: (847) 590-4900 Main Fax: (847) 255-7805The REN is used to determine thequantity of devices which may beconnected to the telephone line.Excessive RENs on the telephone linemay result in the devices not ringing inresponse to an incoming call. In most,but not all areas, the sum of RENs shouldnot exceed five (5.0). To be certain of thenumber of devices that may beconnected to a line, as determined bythe total RENs, contact the localtelephone company.If trouble is experienced with BeoCom 1, for repair or warrantyinformation, please contact:Bang & Olufsen America, Inc.780 West Dundee RoadArlington HeightsIL  60004  U.S.A. Phone: (847) 590-4900 Main Fax: (847) 255-7805If the equipment is causing harm to thetelephone network, the telephonecompany may request that youdisconnect the equipment until theproblem is resolved.This equipment cannot be used onpublic coin phone service provided bythe telephone company. Connection toparty line service is subject to statetariffs.Your telephone company maydiscontinue your service if yourequipment causes harm to the telephonenetwork. They will notify you in advanceof disconnection, if possible. Duringnotification, you will be informed of yourright to file a complaint to the FCC.Occasionally, your telephone companymay make changes in its facilities,equipment, operation, or proceduresthat could affect the operation of yourequipment. If so, you will be givenadvance notice of the change to giveyou an opportunity to maintainuninterrupted service.Changes or modifications not expresslyapproved by the party responsible forcompliance could void the user'sauthority to operate the equipment.This equipment complies with FCCradiation exposure limits set forth for anuncontrolled environment. This devicecomplies with FCC SAR limit of 1.6mW/g. The maximum SAR valuemeasured was 0.082mW/g. This devicemust not be co-located or operating inconjunction with any other antenna ortransmitter.NOTE: This equipment has been testedand found to comply with the limits for aClass B digital device, pursuant to Part15 of the FCC Rules. These limits aredesigned to provide reasonableprotection against harmful interferencein a residential installation. Thisequipment generates, uses and canradiate radio frequency energy and, ifnot installed and used in accordancewith the instructions, may cause harmfulinterference to radio communications.However, there is no guarantee thatinterference will not occur in a particularinstallation. If this equipment does causeharmful interference to radio ortelevision reception, which can bedetermined by turning the equipmentoff and on, the user is encouraged to tryto correct the interference by one ormore of the following measures:– Reorient or relocate the receivingantenna.– Increase the separation between the equipment and receiver.– Connect the equipment into an outleton a circuit different from that towhich the receiver is connected.– Consult the dealer or an experiencedradio/TV technician for help.3507360   0309          Printed in Denmark by Bogtrykkergården a-s, Struer

Navigation menu