Beijing Smartmi Electronic Technology CJXJSQ02ZM Smartmi Evaporative Humidifier User Manual

Beijing Smartmi Electronic Technology Co., Ltd. Smartmi Evaporative Humidifier

User Manual

小米生态链产品包装图纸历史版本版本号:修改点:修改人:版本号:修改点:修改人:版本号:修改点:修改人:版本号:修改点:修改人:版本号:修改点:修改人:纹理方向专色:PANTONE Cool Gray 11C材质工艺要求比例 1:1 单位 mm智米纯净型加湿器使用说明书英文2018.04.18韩博物料编号:材质:太空梭哑粉105g工艺:单色印刷、风琴4折印刷要求:色相正确、印迹牢固、套印准确、各色套印不露杂色,套印误差≤ 0.1mm说明书边角为直角,不做R角V0.9商品ID SKU编码 商品名称 69码 产品型号智米纯净型加湿器Product IntroductionSafety InstructionsSpecificationsRegulatory compliance informationProduct Introduction UsageUsage UsageRepair and InstallationControl Panel Instructions Adding WaterTurning the Machine On and Off, and Changing ModesAir Dry modeAdjusting Brightness  Reseing the Wi-Fi Cleaning the Water TankIf Air Dry mode is on:Add water through the refilling port Add water into the water tankWater Level Indicator Mode IndicatorLight Status Light StatusWater Level Current Mode2 3Control PanelExhaust / Water Refilling PortUpper CasingEvaporating BasinEvaporating Basin KnobWater TankWater Level LimitLower CasingTemperature andHumidity SensorWater Level Indicator  Mode IndicatorSuitable Water: Tap Water, Mineral Water, Purified WaterNote: If you fill past the maximum water level, the water level indicator lights will flash and the machine will give o warning beeps, and water should be stopped adding immediately.Note: If you frequently use the humidifier, we recommend cleaning it once a week.You can rinse the water tank with clean water, or wipe it down with a so cloth to ensure the cleanliness of your humidifier, and prevent strange odors produced by stagnant or dirty water. You can directly add water through the refilling port while the purifier is powered on. The water will flow down into the tank, and the water level indicator will change to reflect how much water has been added. Stop when all the lights are on. Take o the top half of the purifier, and directly add water into the tank. Take care not to fill past the maximum water level indicator. Press the Power / Mode Buon to turn the machine on. The first time you start the machine, it will default to automatic mode. You can press the buon again to switch modes. Holding the buon for 2 seconds will turn the machine o. Press the Wi-Fi / Light Buon to adjust brightness between high, low, and o. Quick Set-up This product is compatible with the Mijia Smart Platform. It can be controlled through the Mijia app, supports the MIUI system, and can connect with other Mijia smart products. Search for “Mijia” through your app store, or scan the QR code below to install the Mijia app.Enable your phone’s Bluetooth, and go to the front page of the Mijia app. Press the + in the upper right corner, select Add a Device, and select “Smartmi 2-in-1 Purifier and Humidifier”. Aer adding the device, you should see it on the front page of the Mijia app. Note: The machine will not turn on if the water level in the tank is lower than the minimum water level. You will have to add water to turn the machine on. Note: You can turn the Air Dry mode on or o through the Mijia app.When the water level drops lower than 10%, the humidifier will continue to operate for about 8 hours to dry out the water tank, avoiding strange odors caused by stagnant water. If Air Dry mode is off:When the water level drops lower than 10%, the humidifier will automatically turn o. Power / Mode BuonWi-Fi / Light BuonOn On Blinking  OOWater Level < 10%10% ≤ Water Level < 40%40% ≤ Water Level < 60%60% ≤ Water Level < 80%80% ≤ Water Level < 100%Water Level 100% Over Max Water Level Automatic ModeSpeed 1: Low Speed 2: Medium Speed 3: HighAutomatic Mode: Automatically adjusts humidifier based on current temperature and humidity inside the room.Speed 1: LowSpeed 2: MediumSpeed 3: HighHandlingProduct Name Rated Voltage CapacityWi-FiNetwork standby power consumption:HumidificationRateRated FrequencyRated WaageNoise GeneratedProduct TypeModel NumberDimensionsGross WeightNet WeightSmartmi Evaporative HumidifierInstallationPower CableWhile in UseUsage RestrictionsPlease turn o and disconnect the machine before moving it.Please empty the water tank before moving the machine. To avoid risk of fire, shock, or damage:Please install the machine according to the instructions provided to avoid electrical shock, fire, bodily harm, or other dangers. Do not connect the power cable until you have finished seing up the machine.Plug the power cable into an appropriate socket.Do not pull or stretch the power cable.Disconnect the power cable before performing maintenance, or moving the machine.If the power cable is damaged, send it to the manufacturer or a repair facility to be replaced by professionals.   This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:—Reorient or relocate the receiving antenna.—Increase the separation between the equipment and receiver.—Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.—Consult the dealer or an experienced radio/TV technician for help.CAUTION: To comply with the limits of the Class B digital device, pursuant to Part 15 of the FCC Rules, this device is comply with Class B limits. All peripherals must be shielded and grounded. Operation with non-certified peripherals or non-shielded cables may results in interference to radio or reception.MODIFICATION: Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the device.FCC RF EXPOSURE STATEMENT:This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.FCC ID: 2AP98-CJXJSQ02ZMIf the purifier is tilted, it may misread the water level in the tank, or cause spills. Please ensure that the device is even before use.    This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.Do not use under the following circumstances to avoid shock, fire, or other dangers:Wi-Fi Indicator LightIntake PortPower CableWater Level Detector11475The Smartmi 2-in-1 Purifier and Humidifier humidifies using evaporation, so it won’t produce a visible mist. 6··If the product starts producing a strange sound, odor, or gets very hot, cease use immediately. Do not put your finger or other foreign objects inside the protective covering, intake port, exhaust port, or other movable parts.Do not allow hair or loose threads to get caught in the intake or exhaust ports. Do not sit or lean on the machine.Ensure adequate ventilation when used alongside household gas appliances (such as gas stoves or water heaters) to avoid carbon monoxide poisoning. If the alarm stops working, it may be caused by water accumulation in the upper casing. It will not aect use. It should resume working normally aer the water has evaporated.·············100-240V240mL / hCJXJSQ02ZM 50/60HzEvaporative Humidifier240 240 363 mm 8WApprox. 4.3kgApprox. 5.1kg≤ 47dB(A)< 2.0WWi-Fi IEEE802.11 b/g/n 2.4GHzApprox. 4.0LManufacturer: Beijing Smartmi Electronic Technology Co., Ltd.  Address: 11-1102, Oce Building Rainbow City, NO.68 Qinghe Mid-Street, Haidian District, BeijingSmartmi Evaporative HumidifierRead this manual carefully before use, and retain it for future reference Standard: Q/BJZMK0008-2018YT-V1.0(20180531)160640FASTENLOOSEN212If your phone is unable to connect to the purifier, press and hold both the Wi-Fi / Light buon and the Power / Mode buon for 5 seconds. Once you hear a beep, the Wi-Fi has been successfully reset. Cleaning the Evaporating BasinYou can remove the evaporating basin and use a so cloth to wipe down, or clean water to rinse o the basin. You can also twist o the knob on the evaporating basin to clean the individual discs that comprise the basin. As illustrated below, you can twist o the knob on the basin to remove the individual disks that comprise the basin. Turn the humidifier o and disconnect the power cable before cleaning the device

Navigation menu