Bosch Security Systems ATX-CR-RV Allplex track User Manual ALLPLEX track Coordinator

Download:
Mirror Download [FCC.gov]
Document ID	2398553
Application ID	tXRBVQRkakDOjh74Vyc0eQ==
Document Description	Users Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	25.82kB (322797 bits)
Date Submitted	2014-09-23 00:00:00
Date Available	2014-09-23 00:00:00
Creation Date	2014-07-17 12:26:36
Producing Software	Antenna House PDF Output Library 2.6.0 (Windows (x64))
Document Lastmod	2014-07-17 12:26:36
Document Title	ALLPLEX track Coordinator
Document Creator	AH Formatter V5.3 MR3 (5,3,2011,1116) for Windows (x64)

Engineered Solutions | ALLPLEX track Coordinator
ALLPLEX track Coordinator
www.boschsecurity.com
The ALLPLEX track coordinator is a device controller
for up to 15 ALLPLEX track receivers. Its primary
function is to monitor the receivers, and report
conditions and events to the central console over
wired Ethernet (TCP/IP). The coordinator can be
powered using Power over Ethernet (PoE).
Functions
Function during alarm
• When a receiver detects an alarm, it goes into an
Off‑Normal state. To quickly locate any devices which
might be in the Off‑Normal State, the coordinator
issues global commands that are interpreted
simultaneously by all of its devices approximately ten
times per second.
• The coordinator sends commands to specific devices
to determine the nature of the Off‑Normal condition.
During an alarm or test, the coordinator sends
commands to obtain the transmitter identification
number, transmitter battery condition, and received
signal strength.
• The alarm information is sent by the receiver to the
coordinator either by wired RS-485 or through
wireless radio frequency.
Device controller for up to 15 receivers
Powered using Power over Ethernet (PoE)
Wired TCP/IP to the host central console
Wired (RS-485) or wireless communication to
receiver
Selectable frequencies of 303.825 / 304 / 433.42
MHz
Remote firmware upgradable via wired TCP/IP
Built-in 2 inputs and 2 relay outputs
• The alarm information is then relayed by the
coordinator to the central console by wired Ethernet
(TCP/IP), where it graphically shows the identity and
location of the subscriber (user) sending the alarm.
Configuration
The coordinator identifies each receiver by its address.
The address is set during system installation using a
DIP switch on the receiver circuit board. Coordinators
communicate on the data bus with individual devices
by issuing commands, which contain the receiver’s
address.
Setup and testing
Upon setting up each coordinator and connected
devices, they can be tested remotely from the central
console. Also, each coordinator reports any problems,
such as low battery, immediately upon detecting them.
Alarm input and relay output control
The coordinator has two analog inputs and two relay
outputs. The analog inputs are monitored and support
4 state supervised modes. The coordinator can detect
short/open wiring conditions, and initiate an alarm if
the appropriate input devices are connected. Each
relay output provisions for normally open (NO),
normally closed (NC) and common (C) terminals.
2 | ALLPLEX track Coordinator
Certifications and approvals
Electrical
The product is classified in accordance with the
following standards:
Power Consumption
200mA @ +12VDC (max)
Operating Input
Voltage
10.8 – 13.2V
Primary Power
Source
Power over Ethernet (PoE)
(PoE standard: IEEE 802.3af-2003 and IEEE
802.3at-2009 Type 1)
Secondary Power
Source
12V DC in
• FCC part 15.231
• ETSI EN300 (433.42 Mhz)
• RCM
Installation/configuration notes
Installation
The coordinator is for indoor and outdoor use. The
coordinator mounts in one of two different sized
enclosures. Connect the receivers to the coordinator
using one 3‑wire multiplex buses: two wires for data
(A and B) and one wire for GND. Each bus supports 1
built-in receiver of the coordinator and up to 15
external receivers. A Security Escort System supports
up to 1024 coordinators and a total of 16384 devices.
Environmental
Operating
Temperature
-30°C to +65°C
(-22°F to +149°F)
Hardware
Input
2 analog inputs
(4 state supervised monitoring)
Output
2 relay outputs
(Relay dry contact, 1A @ 30V DC)
Communication
Interface
Ethernet 10/100 BaseT (central console)
RS-485 / Wireless radio frequency (receivers)
Compatibility Information
Housing Tamper
Normally closed (NC)
Central Console
Software
SE3000 Series
Reliability
AT receiver
ATX-RCV-MT01
Mean Time Between
Failures (MTBF)
AT transmitter
ATX-TRM-304T01, ATX-TRM-433T01
Transmitter
SE2 Series, SE3 Series, SE3401 and SE88
Series
Mounting Considerations
You will need a Security Hex Driver to mount the
receiver.
• Indoor Enclosure: Mount on inside walls.
• Outdoor Enclosure: Mount on the sides of buildings
and on light posts.
10 years
Ordering information
ALLPLEX track Coordinator
Controls ALLPLEX track receivers. Relays alarm and
test signals from the receivers to the central console.
Selectable frequencies of 303.825 / 304 / 433.42 MHz
by dip switch.
Parts included
Quantity
Component
ALLPLEX track Coordinator
ALLPLEX track Coordinator & Receiver Installation Manual
2.2 kΩ Axial Lead Resistors
Technical specifications
Transmission
Frequency
303.825 / 304 (default) / 433.42 MHz
selectable by Dip Switch
Trouble Output
Signal sent through the central console
Antenna Type
Internal
Sensitivity
Adjustments
-100 dB minimum
Order number ATX-COR-MT01
3 | ALLPLEX track Coordinator
Represented by:
Americas:
Bosch Security Systems, Inc.
130 Perinton Parkway
Fairport, New York, 14450, USA
Phone: +1 800 289 0096
Fax: +1 585 223 9180
security.sales@us.bosch.com
www.boschsecurity.us
Europe, Middle East, Africa:
Bosch Security Systems B.V.
P.O. Box 80002
5617 BA Eindhoven, The Netherlands
Phone: + 31 40 2577 284
Fax: +31 40 2577 330
emea.securitysystems@bosch.com
www.boschsecurity.com
© Bosch Security Systems 2014 | Data subject to change without notice
8008436747 | en, V1, 17. Jul 2014
Asia-Pacific:
Robert Bosch (SEA) Pte Ltd, Security
Systems
11 Bishan Street 21
Singapore 573943
Phone: +65 6571 2808
Fax: +65 6571 2699
apr.securitysystems@bosch.com
www.boschsecurity.asia
China:
America Latina:
Bosch (Shanghai) Security Systems Ltd. Robert Bosch Ltda Security Systems Division
201 Building, No. 333 Fuquan Road
Via Anhanguera, Km 98
North IBP
CEP 13065-900
Changning District, Shanghai
Campinas, Sao Paulo, Brazil
200335 China
Phone: +55 19 2103 2860
Phone +86 21 22181111
Fax: +55 19 2103 2862
Fax: +86 21 22182398
latam.boschsecurity@bosch.com
www.boschsecurity.com.cn
www.boschsecurity.com

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Create Date                     : 2014:07:17 12:26:36+01:00
Modify Date                     : 2014:07:17 12:26:36+01:00
Creator                         : AH Formatter V5.3 MR3 (5,3,2011,1116) for Windows (x64)
Producer                        : Antenna House PDF Output Library 2.6.0 (Windows (x64))
Title                           : ALLPLEX track Coordinator
Trapped                         : False
Page Count                      : 3

EXIF Metadata provided by EXIF.tools