COP Security System 5800A 5.8GHz Wiress Camera Adaptor User Manual

Download:
Mirror Download [FCC.gov]
Document ID	1129237
Application ID	G7AafVxM9wuu10shidSxgg==
Document Description	Users Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	9.87kB (123355 bits)
Date Submitted	2009-06-25 00:00:00
Date Available	2009-06-25 00:00:00
Creation Date	2009-06-06 17:44:21
Producing Software	Acrobat Distiller 8.1.0 (Windows)
Document Lastmod	2009-06-06 17:44:21
Document Title	Microsoft Word - SGS -15-5800_TX英文_使用手冊_V1.0c.doc
Document Creator	PScript5.dll Version 5.2
Document Author:	ian.yang

5.8GHz WIRELESS A/V/ALARM TRANSMITTER USER MANUAL
MODEL: 15-5800VT/15-5800VH
1. Panel View
○
○
○
○
○
○
○
○
○
1. DC+12V IN: Power input DC+12V/1.5A.
2. DC+12V OUT: DC+12V/750mA for box camera only, and with a over current protector.
(Note: If you don’t use this port for cameras, you can use the DC+12V/500mA adaptor.)
3. ALARM IN: Connected to alarm sensor, e.g.: PIR Detector, Magnetic Reed Switch Detector.
4. AUDIO IN: RCA female for input video signal.
5. VIDEO IN: BNC female for input audio signal.
6. POWER/State LED: Indicated to power on and ARM status.
Indications
Power On
ARM
Power/State LED
On
High speed Flashing
7. DISARM: DISARM at 15-5800VT/15-5800VH transmitter’s side only.
8. CH SELECT (A B C D): 5.8GHz transmission channel selection.
Bit 1
Bit 2 Bit 3 Bit 4 CH Frequency(MHz)
5740
5760
5780
5800
5820
5840
5860
5740
(1 = DIP SW ON, X= don’t care)
9. ID AND ALARM MUTE: ID address setting is use for paring with 15-5800VR receivers. The alarm mute
function is use for muting built-in buzzer at 15-5800VT/15-5800VH side only.
Bit 1
10.
Bit 2
Bit 3
ID Address
(Pairing with RX)
(1 = SW ON, 0 = SW OFF)
Bit 4
Alarm
Mute
ON
OFF
ANT: RP-SMA connector for connected to 5.8 GHz antenna.
REMARK: When the frequency channels have the interference, adjust antenna or change the channel of
transmitter and don’t close to 802.11 a/b/g AP router.
2. Caution for Installation
2.1 Be careful, never let any water in this equipment.
2.2 If necessary, use a soft cloth moistened with alcohol to wipe off the dust.
2.3 Be extra careful not to shake the unit.
2.4 Avoid places where temperatures exceed 50 o C or higher.
2.5 Avoid places where there are frequent vibrations or shocks.
2.6 When any abnormalities occur, make sure to unplug the unit and contact your local dealer.
3. Packing
3.1 Transmitter
3.2 Antenna
3.3 User manual
3.4 Screws
3.5 Plastic-Conical-Anchor
3.6 Power Adaptor
×1
×1
×1
×4
×4
×1 [Option]
4. Specification
CHANNAL
FREQUENCY
RF ANT. IMPEDANCE
POWER
CURRENT
DC OUTPUT
OUTPUT POWER
VIDEO INPUT
AUDIO INPUT
ALARM INPUT
DIMENSIONS
CH1
CH2
CH3
CH4
5740 5760 5780 5800
MHz
MHz MHz
MHz
50 Ω Typical
DC12V/1.5A Adaptor
350mA
DC12V/750mA
10mW
1 Vp-p Composite @ 50Ω
2 Vp-p @ 600Ω Typical
TTL/CMOS (Level Detection)
L:85 mm
H:30 mm
CH5
5820
MHz
CH6
5840
MHz
CH7
5860
MHz
CH8
5740
MHz
D:16 mm
FCC Part 15 Notice:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
1.
This Transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
2.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.
3.
Any changes or modifications (including the antennas) made to this device that are not expressly
approved by the manufacturer may void the user’s authority to operate the equipment.
Q2009/06/06

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
XMP Toolkit                     : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:14:39
Format                          : application/pdf
Title                           : Microsoft Word - SGS -15-5800_TX英文_使用手冊_V1.0c.doc
Creator                         : ian.yang
Create Date                     : 2009:06:06 17:44:21+08:00
Creator Tool                    : PScript5.dll Version 5.2
Modify Date                     : 2009:06:06 17:44:21+08:00
Producer                        : Acrobat Distiller 8.1.0 (Windows)
Document ID                     : uuid:64a51912-bdc1-4622-9d9a-2e11bf32ce4f
Instance ID                     : uuid:ebf69511-bef2-43f2-9be6-ca9fcc12a454
Page Count                      : 2
Author                          : ian.yang

EXIF Metadata provided by EXIF.tools