Checkpoint Systems EVOLVEM ELECTRONIC ARTICLE SURVEILLANCE (EAS) User Manual 9031090111 AMG OEM Users Manu

Download:
Mirror Download [FCC.gov]
Document ID	1126075
Application ID	2umM0SpxsDDKDIGIu6+cfA==
Document Description	USERS MANUAL 2
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	2.99kB (37326 bits)
Date Submitted	2009-06-18 00:00:00
Date Available	2009-06-18 00:00:00
Creation Date	2009-04-16 09:19:26
Producing Software	Acrobat Distiller 8.1.0 (Windows)
Document Lastmod	2009-04-16 09:19:26
Document Title	9031090111 AMG OEM Users Manu...
Document Creator	PScript5.dll Version 5.2.2
Document Author:	verner

User’s Manual
S1
S2
S3
1 ON
1 OFF
Large detector area like an EAS antenna
Small detector area like the PlexPost detector
2 ON
2 OFF
Narrow distance between the detectors (less than 1.2 - 1.4 meter)
Wide distance between the detectors (greater than 1.2 - 1.4 meter)
3 ON
3 OFF
Detector size adjustment preset 2
Detector size adjustment preset 1
4 ON
4 OFF
High metal sensitivity
Normal metal sensitivity
5 ON
5 OFF
AM filter OFF
AM filter ON
1 ON
1 OFF
Received signal opposite phase with TX1
Received signal in phase with TX1
2 ON
2 OFF
Alarm time = 8 sec
Alarm time = 4 sec
3 ON
3 OFF
Extern Alarm reset ON (Spare in)
Extern Alarm reset OFF (Spare in)
4 ON
4 OFF
TX1 opposite phase with TX sync (only when slave)
TX1 in phase with TX sync (only when slave)
5 ON
5 OFF
TX2 opposite phase with TX1
TX2 in phase with TX1
6 ON
6 OFF
TX1 ON
TX1 OFF
7 ON
7 OFF
TX2 ON
TX2 OFF
8 ON
8 OFF
Slave
Master
1 ON
1 OFF
Advance detection (Receiver phase = Red flash(ANT SIZE))
Simple detection
2 ON
2 OFF
Trolley rejection enabled
Trolley rejection disabled
3 ON
3 OFF
Select Alarm accept time window (ATW) in Advance mode
Select Alarm accept time window (ATW) in Advance mode
4 ON
4 OFF
Select Alarm accept time window (ATW) in Advance mode
Select Alarm accept time window (ATW) in Advance mode
S3 Selection
Accept Time Window (ATW) for
passing the gate
in
out
Moving door
Radar
Radar detection zones
Function
Simple / Trolley
advance off/on ATW ATW
S3 (1)
S3 (2) S3 (3) S3 (4)
OFF
OFF
OFF
ON
Type of
detection
Simple
Simple
Accept
Time
Window
Alarm delay
0.1 sec
1 sec
Use when
No moving door
No moving door + Trolley
Moving door radar
detection zone
ON
ON
ON
ON
OFF
OFF
OFF
OFF
OFF
ON
OFF
ON
OFF
OFF
ON
ON
Advance
Advance
Advance
Advance
0.65 sec
1.3 sec
2.6 sec
2.6 sec
0.1 sec
0.1 sec
0.1 sec
0.1 sec
Moving door
Moving door (standard setting)
Moving door
Moving door
2+3
2+3
ON
ON
ON
ON
ON
ON
ON
ON
OFF
ON
OFF
ON
OFF
OFF
ON
ON
Advance
Advance
Advance
Advance
0.65 sec
1.3 sec
2.6 sec
2.6 sec
1 sec
1 sec
1 sec
2 sec
Moving door + Trolley
Moving door + Trolley
Moving door + Trolley
Moving door + Trolley
Note> This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may course harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by tuning the equipment off and on, the user is encouraged to try
to correct the interference by one of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
--Consult the dealer or an experienced radio/TV technician for help.
WARNING!
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
FCC ID: S8OMEDET3420 and S8OMEDET3480 - IC ID: 5849A-MEDET3420 and IC ID: 5849A-MEDET3480
Article number: 9031090111
Federal Communications Commission Statement
This device complies with part 15 of the FCC Rules and RSS-210 of the Canadian Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
XMP Toolkit                     : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:14:39
Creator Tool                    : PScript5.dll Version 5.2.2
Modify Date                     : 2009:04:16 09:19:26+02:00
Create Date                     : 2009:04:16 09:19:26+02:00
Format                          : application/pdf
Title                           : 9031090111 AMG OEM Users Manu...
Creator                         : verner
Producer                        : Acrobat Distiller 8.1.0 (Windows)
Document ID                     : uuid:b49cb9c2-2668-47fc-b858-b2e5d7177e1b
Instance ID                     : uuid:394de206-98b4-406d-aecc-e20cc556e09b
Page Count                      : 1
Author                          : verner

EXIF Metadata provided by EXIF.tools