Chungear Co CE10307 Ceiling fan remote Controller (Transmitter) User Manual

Chungear Industrial Co Ltd Ceiling fan remote Controller (Transmitter)

User Manual

DC POWER CEILING FAN REMOTE CONTROL MANUALLEARNING PROCESSNOTE:This unit is to be used for the control of DC power ceiling fan and in an AC110/120V 60Hz powersupply only.Step: 1 Open the remote battery cover andinstallCR2032*2pcs Lithium batteries.Step: 2. Within 30 seconds of turning the ReceiversACpower ON. use a ball pen to press and hold the Set keyabout5 seconds.Once the receiver has detected the frequency,thereceiver will make sound, Bi Bi, twice. This will indicatethereceiver has learned the frequency that waspreviouslyselected on the transmitter.Note: After the AC power is on, do not press any other button on the transmitter before setting learning. Doing so willcause the procedure to fail.After completing the steps above, you should be able to operate the ceiling fan and light. If the fan is not respondingto the transmitter, please turn the power off to the receiver. And repeat step 2.LIGHT FUNCTION SELECT SWITCHIf installed energy light onto ceiling fan, please slide thedipswitch,lightfunctionselect switch, to “O” position. If installed tungsten light onto ceiling fan,pleaseslide the “light function select switch” to “D” position.FUCNCTIONS OF WALL REMOTE CONTROLLED for show fan or light’s function settingFAN key : press and turn fan off: fan speed control keypress the key or key each time for change fan speedlight control key:ON/OFF- Press and release immediately to turn on or off dwon light.DIMMER-Press or and hold to dim or brighten light to the desired levelandrelease.(Tungsten only and light function select switch on dimmer position.)1hr：Setting up that the ceiling fan will turn off after 1 hour automatically3hr：Setting up that the ceiling fan will turn off after 3 hours automatically6hr：Setting up that the ceiling fan will turn off after 6 hours automaticallyHome Shield – Press and hold the buttons for 3 seconds. Fan will be off and the light willrandomly turn on and off while you are away home.TR205A
: Walk Away Light Delay – Tap once ‐the light and fan turn off after 1 minute automatically.Press the key for set fan speed for making natural wind.Press the key for forward airflow of ceiling fanTouch icon for reverse airflow of ceiling fan.To assure continued FCC compliance:FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENTThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipment off and on, the useris encouraged to try to correct the interference by one or more of the following measures:--Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver.--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consultthe dealer or an experienced radio/TV technician for help.CAUTION:Any changes or modifications not expressly approved by the grantee of this device could void the user's authority tooperate the equipment.FCC ID：This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) Thisdevice may not cause harmful interference, and (2) this device must accept any interference received, includinginterference that may cause undesired operation.

Navigation menu