Cisco Systems 01 IP Camera with wireless technologies User Manual Modcam Manual

MODCAM AB IP Camera with wireless technologies Modcam Manual

User Manual

MOD​.01UserManual >RevisionR3-2015-09-14
Federal Communication Commission Interference Statement FCC Part 15 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1. Reorient or relocate the receiving antenna. 2. Increase the separation between the equipment and receiver. 3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4. Consult the dealer or an experienced radio technician for help. FCC Caution This equipment must be installed and operated in accordance with provided instructions and a minimum 20 cm spacing must be provided between computer mounted antenna and person’s body (excluding extremities of hands, wrist and feet) during wireless modes of operation. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the authority to operate equipment.
Federal Communication Commission (FCC) Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm (8 inches) during normal operation. The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The equipment version marketed in US is restricted to usage of the channels 1-11 only.
Industry Canada Statements This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. This equipment complies with the safety requirements for RF exposure in accordance with RSS-102 §2.5.2. This equipment must be installed and operated in accordance with the provided instructions and a minimum 20 cm spacing must be provided between the antenna and any person’s body during wireless modes of operation. Cet appareil est conforme avec Industrie Canada exempt de licence Rss standard(s). Son fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil ne peut causer d’interférences, et (2) cet appareil doit accepter toute interférence, y compris des interférences qui peuvent provoquer un fonctionnement indésirable du périphérique. Ce dispositife est conforme à la norme de sécurité en matière d'exposition RF conformément à la RSS-102 §2.5.2. Ce dispositif doit être installé et utilisé conformément aux instructions fournies et à 20 cm espacement minimal doit être prévu entre l'antenne et le corps de toute personne pendant les modes sans fil de fonctionnement. (i) The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems; (ii) Users should also be advised that high-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices (I) Le dispositif pour fonctionner dans la bande 5150-5250 MHz est uniquement pour une utilisation en intérieur afin de réduire les risques d'interférences nuisibles à la co-canal des systèmes mobiles par satellite; (II) Les utilisateurs doivent également être informés que les radars à haute puissance sont désignés comme utilisateurs principaux (c.-à-utilisateurs prioritaires) des bandes 5250-5350 MHz et 5650-5850 MHz et que ces radars pourraient provoquer des interférences et / ou endommager LE-LAN dispositifs
R&TTE Compliance Statement This equipment complies with all the requirements of DIRECTIVE 1999/5/EC OF THE EUROPEAN PARLIAMENT AND THE COUNCIL of March 9, 1999 on radio equipment and telecommunication terminal Equipment and the mutual recognition of their conformity (R&TTE). The R&TTE Directive repeals and replaces in the directive 98/13/EEC (Telecommunications Terminal Equipment and Satellite Earth Station Equipment) As of April 8, 2000. Safety This equipment is designed with the utmost care for the safety of those who install and use it. However, special attention must be paid to the dangers of electric shock and static electricity when working with electrical equipment. All guidelines of this and of the computer manufacture must therefore be allowed at all times to ensure the safe use of the equipment. EU Countries Intended for Use The ETSI version of this device is intended for home and office use in Austria, Belgium, Denmark, Finland, France, Germany, Greece, Ireland, Italy, Luxembourg, the Netherlands, Portugal, Spain, Sweden, and the United Kingdom. The ETSI version of this device is also authorized for use in EFTA member states: Iceland, Liechtenstein, Norway, and Switzerland. EU Countries Not intended for use None.
IntroductionAboutModcamIntelligentandopen–thebeginningofaneweraincomputervision.Overtheyears,thehyper-growthinthemobileindustryhaspusheddowncostofcomponentsimmenselyandopenedupforagreatdevelopercommunity.AtModcam,wehaveusedthisopportunityandappliedlogicsfromthesmartphoneindustrytodevelopanewsolutionforcomputervision.Modcamprovidesanoutstandingplatformforintelligentcomputervisionapplications.Wehavecreatedasmartpieceofhardwareandanopensoftwarearchitecturetobreednewexcitingopportunitieswithincomputervision.Theplatformenablesvideosandpixelstobetranslatedintoinformation,beforebeingdistributedtoanetwork.Ourplatformistailoredforvideocontentanalyticsapplicationsthroughouruniqueknowledgeaboutimageprocessingandtheinteractionbetweensoftware,hardware,andcamerasensor.Modcamgivesyoutheabilitytosee,understandandreact.AbouttheMOD.01TheMOD.01isapowerfulquadcoreARMv7platformwitha5megapixelcamerasensor,GPS,accelerometer,compass,microphoneandenoughstorageandmemorytorunadvancedcomputervisionapplicationswithoutpause.Itisphysicallybuiltandadaptedtobeasversatileaspossiblewithregardstomountingneedsandenvironmentalconditionsandpackagedinasleekandnon-intrusivedesign.ItcomeswithfullWiFiandBluetooth4.0stacksandthereareoptionsforEthernetadapterswithPoEsupportforlargerinstallation.WhiletheMOD.01ismainlydesignedtobecontinuouslypoweredviait’smicro-usbconnector,itcomeswitha800mAhbatteryinsidethatwillbothallowittoretainoperationduringpoweroutagesandlastforuptoafulldaywhereexternalpowersupplyislimited.ThisdocumentThisdocumentdescribesbasicproperties,usageandhandlingoftheMOD.01hardwareproduct,includingsetupexperience,installationandmountingoptions. >RevisionR3-2015-09-14
GeneralproducthandlingUnpackingandgeneralconsiderationsIncludedwithyourMOD.01deviceshouldbeathreemetres,charging-only,Micro-btoType-AUSBcable,a1AUSBType-Apoweradapterforyourregionandastandardtwo-partMOD.01ceilingmountintendedfortop-downcoverage .1Boot,shutdownandLEDpatternsTheMOD.01devicewillautomaticallybootwheneveritreceivespowerthroughitsmicro-bUSBcontact.Thismeansthatasasafe-guardagainstpoweroutages,ifpowerisinserted,itwillautomaticallybootevenwhenmanualshutdownhasbeenperformed.Uponboot,thedevicewillgothroughaseriesofpatternswiththefourLEDssituatedaroundthecameralensoftheunit.ShutdownToturnoffthedevice,removeanypowersourceandpressthebuttonforatleast6seconds.Duringthistime,theLEDswillshowacountdownpattern(afteracoupleofseconds).ThecountdownendswithafourLEDwhiteflash,indicatingthattheshutdowniscomplete.StandardLEDbehaviour1. Blue​lowerright/leftlight-Pre-bootphase.2. Blue​lights,spinning-Booting.3. Four​orange​lights,flashing-Notconnectedtonetwork,scanningforQRcode.4. Four​green​lights,flashing-QRcodescanned.5. Orange​lights,spinning-Connectingtonetwork.6. Orange​lights,alternatelyflashingleft/right-Networkconnectionfailed.7. Yellow​lights,pulsating-Connected,installationnotfinished,videostreampossible.8. Whitelights,slowlypulsating-Connected,installedandready.Note:​Spinningredlightsindicateanongoingover-the-air(OTA)upgrade.Nevershutdownthedeviceduringthisprocess!Configuration1TheactualcontentsofyourpackagemayvarydependingofOEM-packagingandpointofresale.>RevisionR3-2015-09-14
OnceyourdevicehascompletedbootingitwillstartflashingorangewithallfourLEDs,indicatingthatitisreadytoreadaQRcodeforconfiguration.Inabrowser,navigateto​https://setup.modcam.com​andfollowtheinstructions!UpgradesThedeviceupgradesitselfover-the-airwhenevernewsoftwareisreadytobedeployedtothedevice.Anautomaticupdatecheckisperformedimmediatelyafteracquiringanetworkconnectionandthenonceevery24hours.Thetimeframefortheupdatecheckisbydefaultbetween3and4inthemorning,localtime.Note:​Donotshutoffthedeviceonceithasstartedupgradingthesystem,indicatedbyspinningredLEDs.InstallationWhenthedeviceisceiling-mountedyoucancalculatetheapproximatefloorcoverageareaA​forheight​H​withtheformula:.78HA = 1 2Ifthesensorhastheoptionalwideanglelensattached,theformulatouseis0.37HA = 1 2Thismeansthatforaceilingheightof4metres,theapproximatefloorcoverageis~28m​2​,or~166m​2​withthewideanglelens.ApplicationsForapplicationsrunningontheMOD.01,pleaserefertotheapplication-specificdocumentation. >RevisionR3-2015-09-14
SpecificationsApplicationprocessorMOD.01isbuiltonaBroadcomchipset-BCM23550,compliantwithARMTrustZone®andGlobalPlatformforsystem-levelsecurity.●Quad1GHzA7CPUwithARM®NEON​TM​technology●High-performanceVideoCoreIVGPU●Integratedimagesignalprocessor(ISP)withsupportupto12megapixels●HighqualityH.264fullHD(1080p30)camcorderandvideoplayback●PowermanagementtechniquesthatincreaseefficiencyandoptimizeperformancebasedonworkloaddemandsMemorysubsystemMOD.01holdsmemoryinpackagebasedonSamsung’sMCP(MultiChipPackage)technologythatallowsintegrationofmultiplememorychipsofdifferenttypes,suchasNANDflash,eMMCandmobileDRAM,inasinglepackage.MCP-basedmemoryenablestherestoftheapplicationtoviewthememorysubsystemasasingle,unified"block",lettingthememorysubsectionofferthehighestlevelsofperformanceforthedevice.●Density:eMMC(4GB)+LPDDR2(1GB)●Maxspeed:1066Mbps(LPDDR2)SensorsubsystemCameraMOD.01isusinga5megapixelcamerawithfixedfocus.●Resolution:2592x1944pixels–5.0MP●1/4”CMOSSensor(OmnivisionOV5648)●Lenstype–fixedfocus(distance60cm)●ViewAngle:87.9±3°●Outputformat:8-/10bitRGBRAWoutput●MaxS/Nratio:34dB●DynamicRange:67dB@8xgain●Transferrate:○QSXGA(2592x1944)@15fps○1080p@30fps>RevisionR3-2015-09-14
○720p@60fps○VGA@90fps●Sensitivity:600mV/Lux-sec●RollingshutterAccelerometer/GyroMOD.01isusingaBoschBMI055ultra-small,6axisinertialsensorwithverylow-noisemeasurementofangularratesandaccelerationsin3perpendicularaxesandthussensestilt,motion,shockandvibration.●digital,triaxial12bitaccelerationsensor●digital,triaxial16bit,±2000°/sgyroscope.eCompassMOD.01isusingaBoschBMM150standalonegeomagneticsensorforconsumermarketapplications.Itallowsprogrammableandflexiblemeasurementsofthemagneticfieldinthreeperpendicularaxeswithultra-lowvoltageoperation.MicrophoneMOD.01isusinganomnidirectional,highsensitivity-“Ultra‑Mini”SiSonic​TM​Microphoneforsensingnoiseinthesurroundingenvironment. >RevisionR3-2015-09-14
FurtherquestionsandsupportForfurtherquestionsandsupport,pleasecontactModcamABdirectly.contact@modcam.com>RevisionR3-2015-09-14
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!User!Login:!Please!login!at!:!dashboard.modcam.com!!!!!User!Interface!and!People!count!!Depending!on!credentials!and!applications!the!user!have!bought!the!UI!is!looking!as!below!–!the!user!has!the!possibility!to!watch,!compare,!extract!data!for!multiple!sensors!!!

Navigation menu