Compare Electronics CP318 Wireless USB module User Manual CP318 V2 2 SPEC

Download:
Mirror Download [FCC.gov]
Document ID	1589234
Application ID	jvMo+dw1c1Pyg0dsYmnxYQ==
Document Description	Users manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	26.98kB (337266 bits)
Date Submitted	2011-11-28 00:00:00
Date Available	2011-11-28 00:00:00
Creation Date	2011-08-08 17:23:21
Producing Software	pdfFactory Pro 3.21 (Windows XP Professional Chinese)
Document Lastmod	0000-00-00 00:00:00
Document Title	CP318 V2.2 SPEC.doc
Document Creator	pdfFactory Pro www.fineprint.cn
Document Author:	Administrator

SHENZHEN COMPARE ELECTRONICS CO., LTD.
ＯＭＰＡＲＥ
深圳市宝安区西乡街道固戍朱坳工业园中泰工业区D栋7楼
TEL：0755-29063503
FAX：0755-29063506
网址:www.szcompare.com
邮编:518040
Compare IEEE 802.11 b/g/n WLAN –
USB
Product Specifications
Model: CP318
VER:V2.2
DATE:2011/4
SHENZHEN COMPARE ELECTRONICS CO., LTD.
ＯＭＰＡＲＥ
深圳市宝安区西乡街道固戍朱坳工业园中泰工业区D栋7楼
TEL：0755-29063503
FAX：0755-29063506
网址:www.szcompare.com
邮编:518040
1 Introduction
CP318 is a WLAN module supporting IEEE 802.11 b/g/n standards with PH
connector supporting USB 2.0 signaling. This is a low cost compact WLAN module，
designed in the product with embedded system for the wireless connectivity.
CP318 both support RTL8188CUS
1.1 Scope:
CP318 WLAN Module is designed to operate in 2.4GHz ISM frequency
band. This Module complies with IEEE 802.11b/g/n standards.
1.2 Features
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
Ÿ
1T1R mode with 150Mbps with PHY rates for both transmit and receiving
Dynamic data rate: Maximum data rate up to 150Mbps. 11n: Legacy, Mixed
and Green Field modes, 11g: 54/48/36/24/12/9/6 Mbps (Auto Sensing);
11b:11/5.5/2/1 Mbps (Auto Sensing)
support 20MHz/40MHz Bandwidth
Security support for 64/128 bit WEP, WPA/WPA2, WPA-PSK/WPA2-PSK
(TKIP/AES)
Reverse Direction Grant Data Flow and Frame Aggregation
Cisco CCX Support
USB2.0
Operating Frequency 2.412GHz~ 2.462GHz
Transmit Output Power: 802.11g/n 14+/-1dBm 802.11b 14+/-1dBm
Receive Sensitivity 11b: -75dBm @ 11Mbps (Typical)；11g: -65dBm @
54Mpbs (Typical)
Antenna can choose external
Operating Voltage 3.3VDC± 5%
Antenna Port Impedance 50ohm
SHENZHEN COMPARE ELECTRONICS CO., LTD.
ＯＭＰＡＲＥ
深圳市宝安区西乡街道固戍朱坳工业园中泰工业区D栋7楼
TEL：0755-29063503
FAX：0755-29063506
网址:www.szcompare.com
邮编:518040
2. General Specification
Model Name
Standard
CP 318
802.11b/g/n
Data Transfer Rate
1,2,5.5,6,11,12,18,22,24,30,36,48,54,60,90.120and
maximum of 150Mbps
Modulation Method
Frequency Band
BPSK/QPSK/16-QAM/64-QAM
2.4GHz ISM Band
Spread Spectrum
IEE 802.11b:DSSS(Direct Sequence Spectrum)
IEE802.11g/n:OFDM(Orthogonal
Frequency
Division Multiplexing)
RF Output Power
<15dBm@11n ,<15dBm @11g，<15dBm@11b
Operation Mode
Ad hoc, Infrastructure
Receiver Sensitivity
11Mbps-80dbm@8%,54Mbps-70dBm@10%,
130Mbps-64dbm@10%
Operation Range
LED
OS Support
Security
Interface
Power Consumption
Operating Temperature
Storage Temperature
Operating Humidity
Storage Humidity
Dimensions
Up to 180 meters in open space
Power
Windows xp/ vista/Win7/Mac /Linux
WEP,TKIP,AES,WPA,WPA2
USB 2.0
DC3.3V
Transmit + Receive: average120mA(3.3V) power
consumption 0.4W
0~55℃
-20℃~70℃
10%~90% non-condensing
5%~90% non-condensing
25x12x2.2mm(LxwxH)
SHENZHEN COMPARE ELECTRONICS CO., LTD.
ＯＭＰＡＲＥ
深圳市宝安区西乡街道固戍朱坳工业园中泰工业区D栋7楼
TEL：0755-29063503
FAX：0755-29063506
网址:www.szcompare.com
邮编:518040
3.Pictures
CP318 V2.2
CP318 V2.2
3.3V external antenna
SHENZHEN COMPARE ELECTRONICS CO., LTD.
深圳市宝安区西乡街道固戍朱坳工业园中泰工业区D栋7楼
TEL：0755-29063503
FAX：0755-29063506
网址:www.szcompare.com
邮编:518040
ＯＭＰＡＲＥ
： Information
4. Hardware
Block Diagram
RTL8188CUS
Figure 1: System Block Diagram of CP318 WLAN Module
SHENZHEN COMPARE ELECTRONICS CO., LTD.
ＯＭＰＡＲＥ
深圳市宝安区西乡街道固戍朱坳工业园中泰工业区D栋7楼
TEL：0755-29063503
FAX：0755-29063506
网址:www.szcompare.com
邮编:518040
5．1 The external circuit for WiFi activity LED display
5.2
uses a push or toggle switch. r-down function input (optional)The external
circuit for power
6． Antenna Connection Information
Antenna can choose external
SHENZHEN COMPARE ELECTRONICS CO., LTD.
ＯＭＰＡＲＥ
深圳市宝安区西乡街道固戍朱坳工业园中泰工业区D栋7楼
TEL：0755-29063503
FAX：0755-29063506
网址:www.szcompare.com
邮编:518040
7. Mechanical Information
7.1 Dimensions
Size: 25mm(Length)x12mm (Width)
Mechanical Drawing:
Pin Definition
3.3V
D4
D+
GND
RF/LED
7.2 USB Connection Information
6 pin pin to pin=2.0mm
SHENZHEN COMPARE ELECTRONICS CO., LTD.
ＯＭＰＡＲＥ
8．Dimension
深圳市宝安区西乡街道固戍朱坳工业园中泰工业区D栋7楼
TEL：0755-29063503
FAX：0755-29063506
网址:www.szcompare.com
邮编:518040
FCC STATEMENT
Part 15.19
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Part 15.21
2. Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Part 15.105
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
If the FCC identification number is not visible when the module
is installed inside another device, then the outside of the device
into which the module is installed must also display a label
referring to the enclosed module. This exterior label can use
wording such as the following: “Contains Transmitter Module
FCC ID: A2TCP318
When the module is installed inside another device, the user manual
of this device must contain below warning statements;
1.This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference
that may cause undesired operation.
2.Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
This modular could be installed in the fix or mobile devices only, installed in
the portable device, like USB dongle like transmitters is forbidden.
This modular complies with FCC RF radiation exposure limits set forth for
an uncontrolled environment. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter. This modular must
be installed and operated with a minimum distance of 20 cm between the
radiator and user body.
Regulatory Information
The devices must be installed and used in strict accordance with the
manufacturer's instructions as described in the user documentation that
comes with the product. modular could be only used in mobile or fix device,
and could not be used in any portable device.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Title                           : CP318 V2.2 SPEC.doc
Author                          : Administrator
Creator                         : pdfFactory Pro www.fineprint.cn
Producer                        : pdfFactory Pro 3.21 (Windows XP Professional Chinese)
Create Date                     : 2011:08:08 17:23:21+08:00
Page Count                      : 9

EXIF Metadata provided by EXIF.tools