Controlled Entry Distributors DOLGDO433D Remote Controller User Manual Print
Controlled Entry Distributors, Inc. Remote Controller Print
Users Manual
| Download: |  |
| Mirror Download [FCC.gov] | |
| Document ID | 2632558 |
| Application ID | a4ywbWcAWYbAs0Wb1YDPJg== |
| Document Description | Users Manual |
| Short Term Confidential | No |
| Permanent Confidential | No |
| Supercede | No |
| Document Type | User Manual |
| Display Format | Adobe Acrobat PDF - pdf |
| Filesize | 18.37kB (229680 bits) |
| Date Submitted | 2015-06-01 00:00:00 |
| Date Available | 2015-06-01 00:00:00 |
| Creation Date | 2015-04-17 13:45:42 |
| Producing Software | Adobe PDF library 9.90 |
| Document Lastmod | 2015-04-17 13:49:51 |
| Document Title | |
| Document Creator | Adobe Illustrator CC 2014 (Macintosh) |
Dolphin Wireless Garage Door Keypad 433 MHz Dip Switch Keypad Instructions Product # DOLGDO433D Thank you for your purchase of the Transmitter Solutions Dolphin wireless keypad. The DOLGDO3433D will accommodate one 4 digit PIN to activate a signal transmission. Package contains: Keypad 9 volt battery 2 screws + wall anchors Keypad instructions Please follow the detailed instructions below in order to set up the Dolphin keypad to operate with your garage door opener or receiver. 2. OPERATIONAL FEATURES Pressing any key illuminates the keypad for 5 seconds. A "buzzer" indicates each button depression. After 20 incorrect key entries, the keypad will “lock up” for 40 seconds. If the battery is low the single LED flashes rapidly for 5 seconds, indicating it is time to replace the battery. After you have entered a valid code, the keypad LED will flash during the 5 second "time out" period. During the “time out” period you may press any key and the keypad will send another signal to your receiver each time you press a key. The key resets your entry. If you make a mistake while entering your PIN, pressing the key resets your entry so you can start over. HINT: If you always begin your PIN with the faulty operation. you will reduce the likelihood of 3 TO CHANGE TO RADIO CODE: DIP switch must be set to match the code on the 10 position switch on the garage door operator receiver. TO CHANGE TO ACCESS CODE: 1-2-3-4 (Old Access Code) 1-3-5-7 (New Access Code) LEDS: Indicator LED: Indicator LED ON: Into change access code mode 2-3 S3 310 MHz 300 MHz Indicator LED blink The code is enter incorrectly Keypad LED: Keypad LED blink Access code passed S2 8 Port 10 Port Frequency V2 V3 Output Code S3 DIP Indicator LED Keypad LED blink rapidly 5sec Battery low (7V) Dip Switch PRESET FACTORY CODES: Access code : * - 1 - 2 - 3 - 4 - # Keypad LED (Note: To reset the access code remove 9 volt battery form unit, Depress any key on the keypad and wait 5 seconds before installing LED 4 LED 2 LED 5 LED 3 4 Position the keypad on the garage door frame with the provided screws. Lift up the cover and insert the long screw above the keypad in the slot provided (a). Remove the battery cover and insert the second long screw in the lower slot (b). Replace the battery cover. cover 5. RETURN TO DEFAULT SETTINGS Return to Default Settings 1. Desconnect the power by removing the battery. 2. Press the 1 , 4 , and 7 keys simultaneously. 3. Re-connect the battery to power up the keypad. 4. Release the 1 , 4 , and 7 keys. Note: The keypad is returned to the defaul “Master Code” 1 2 3 4 . And all User Entry Codes are deleted. Multi-color status LED ORANGE - Key depress GREEN - Code was entered correctly and the keypad is transmitting GREEN - Programming Mode RED - (Flashing 3 times) Error was made in either programming mode or in code entry. If this transmitter triggers other doors in your neighborhood, change all your transmitters and receivers to a new code setting. DO NOT let children use the keypad without adult supervision. Children can injure themselves, or others, if left unsupervised. Make sure all the required safety devices are installed before operating any door. The keypad is approved by the FCC and it complies with Part 15 of the FCC Rules. Its operation is subject to the following 2 conditions: 1. This device may not cause harmful interference. 2. The device must accept any interference that may cause undesired operation. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. FCC ID: SU7DOLGDO433D 8 The warranty period of this product is 24 months, beginning from the manufacturing date. During this period, if the product does not operate correctly, due to a defective component, the product will be repaired or replaced at the sole discretion of Transmitter Solutions. This warranty does not extend to the product casing which can be damaged by conditions outside of the control of Transmitter Solutions. EXCEPT AS SET FORTH ABOVE, TRANSMITTER SOLUTIONS MAKES NO WARRANTIES REGARDING THE GOODS, EXPRESS OR IMPLIED, INCLUDING WARRANTY OF MERCHANTABILITY OR WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE. BUYER MAKES NO RELIANCE ON ANY REPRESENTATION OF TRANSMITTER SOLUTIONS, EXPRESS OR IMPLIED, WITH REGARD TO THE GOODS AND ACCEPTS THEM “AS-IS/WHERE-IS”. TRANSMITTER SOLUTIONS SELLS THE GOODS TO BUYER ON CONDITION THAT TRANSMITTER SOLUTIONS WILL HAVE NO LIABILITY OF ANY KIND AS A RESULT OF THE SALE. BUYER AGREES THAT TRANSMITTER SOLUTIONS SHALL HAVE NO LIABILITY FOR DAMAGES OF ANY KIND, WHETHER DIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING INJURIES TO PERSONS OR PROPERTY, TO BUYER, ITS EMPLOYEES OR AGENTS, AS A RESULT OF THE SALE. BUYER ALSO AGREES TO HOLD TRANSMITTER SOLUTIONS HARMLESS FROM ANY CLAIMS BUYER, OR ANY THIRD PARTY, MAY HAVE AS A RESULT OF BUYER’S USE OR DISPOSAL OF THE GOODS. BUYER HAS READ THIS DISCLAIMER AND AGREES WITH ITS TERMS IN CONSIDERATION OF RECEIVING THE GOODS.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : Yes XMP Toolkit : Adobe XMP Core 5.6-c014 79.156821, 2014/08/29-03:07:50 Format : application/pdf Title : Print Metadata Date : 2015:04:17 13:49:51-06:00 Modify Date : 2015:04:17 13:49:51-06:00 Create Date : 2015:04:17 13:45:42-06:00 Creator Tool : Adobe Illustrator CC 2014 (Macintosh) Thumbnail Width : 148 Thumbnail Height : 256 Thumbnail Format : JPEG Thumbnail Image : (Binary data 13897 bytes, use -b option to extract) Instance ID : uuid:cc69f29c-ab0b-e047-9296-7f602e7bf9d6 Document ID : xmp.did:a2c4c9bd-eac9-4ce6-a670-dacfa3149985 Original Document ID : uuid:5D20892493BFDB11914A8590D31508C8 Rendition Class : proof:pdf Derived From Instance ID : xmp.iid:aabe48b7-527b-47dd-be67-b90a0c68efe6 Derived From Document ID : xmp.did:aabe48b7-527b-47dd-be67-b90a0c68efe6 Derived From Original Document ID: uuid:5D20892493BFDB11914A8590D31508C8 Derived From Rendition Class : proof:pdf History Action : saved, saved History Instance ID : xmp.iid:F97F1174072068118083BB4F5E257D2C, xmp.iid:a2c4c9bd-eac9-4ce6-a670-dacfa3149985 History When : 2012:05:25 10:05:01-06:00, 2015:04:17 13:45:43-06:00 History Software Agent : Adobe Illustrator CS5, Adobe Illustrator CC 2014 (Macintosh) History Changed : /, / Manifest Link Form : EmbedByReference Manifest Reference File Path : /Users/graphicdesign/Documents/Projects/Transmitter Solutions/300-310 keypad/keypad.jpg Ingredients File Path : /Users/graphicdesign/Documents/Projects/Transmitter Solutions/300-310 keypad/keypad.jpg Startup Profile : Print Has Visible Overprint : False Has Visible Transparency : False N Pages : 1 Max Page Size W : 5.500000 Max Page Size H : 8.500000 Max Page Size Unit : Inches Font Name : HelveticaNeue-MediumItalic, HelveticaNeue, HelveticaNeue-Medium, HelveticaNeue-Bold Font Family : Helvetica Neue, Helvetica Neue, Helvetica Neue, Helvetica Neue Font Face : 66 Medium Italic, Regular, Medium, Bold Font Type : Type 1, TrueType, TrueType, TrueType Font Version : 001.100, 10.0d36e1, 10.0d36e1, 10.0d36e1 Font Composite : False, False, False, False Font File Name : HelveNeuMedIta; 66 Helvetica MediumItalic.t1, HelveticaNeue.dfont, HelveticaNeue.dfont, HelveticaNeue.dfont Plate Names : Cyan, Magenta, Yellow, Black, PANTONE 187 C Swatch Groups Colorants Tint : 100.000000 Swatch Groups Group Name : Brights Swatch Groups Group Type : 1 Swatch Groups Colorants Swatch Name: C=60 M=90 Y=0 K=0 Swatch Groups Colorants Mode : CMYK Swatch Groups Colorants Type : PROCESS Swatch Groups Colorants Cyan : 60.000000 Swatch Groups Colorants Magenta : 90.000000 Swatch Groups Colorants Yellow : 0.003100 Swatch Groups Colorants Black : 0.003100 Producer : Adobe PDF library 9.90 Page Count : 4 Creator : Adobe Illustrator CC 2014 (Macintosh)EXIF Metadata provided by EXIF.tools