DJI Innovations Technology P330 Phantom R/C Controller User Manual Manual 2 of 2

Download:
Mirror Download [FCC.gov]
Document ID	1829796
Application ID	u3C9HIbozNzZm8PUlnFzIw==
Document Description	Manual 2 of 2
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	118.63kB (1482936 bits)
Date Submitted	2012-11-02 00:00:00
Date Available	2012-11-02 00:00:00
Creation Date	2012-11-02 14:38:53
Producing Software	cairo 1.10.2 (http://cairographics.org)
Document Lastmod	2012-11-02 14:41:00
Document Title	Manual 2 of 2
Document Creator	cairo 1.10.2 (http://cairographics.org)

Control mode Descriptions
GPS ATTI
Rudder
Max-angular
for 0˚ attitude, its endpoint is 45˚.
velocity is 150°/s.
Maintain the altitude best above 1 meter
when GPS signal is
Released
adequate.
Attitude
Not
stabilizing.
Recommended
Only attitude
When the GPS signal is
GPS /
10seconds, the system
position lock
enters Atti. Mode
Auto Level
Enhanced Fail-Safe
Applications
Fail-Safe
AP work
Sports flying.
Power
3.12W
Consumption
Take-off Weight
<1200g
Hovering Accuracy
Vertical: ± 0.8m
(GPS Mode)
Horizontal: ± 2.5m
Velocity
Max Tilt Angle
Max
this mode.
Voltage alarm
Safety
GPS not used
not used in
automatically.
-10°C ~ 50°C
Temperature
Max Yaw Angular
stabilization,
lost for more than
GPS Lost
NO
from ground.
Locks multi-rotor position
Stick
Operating
Multi attitude control; Stick center position
Stick Meaning
Altitude Lock
Manual
Maximum rudder angular velocity is 200°/s
Velocity
Command
ATTI
Specification
Ascent
Depends on
Descent Speed
experience.
Max Flight Velocity
200°/s
45°
±6m/s
10m/s
Extreme flying
Warning & Disclaimer
Notes
Please strictly follow these steps to use the
Make sure the positive and negative poles of the battery are connected correctly.
PHANTOM. DJI Innovations accepts no liability
Keep the antennas of TX and RX visible to each other (no obstacles).
for damage(s) or injuries incurred directly or
Avoid any impact by external forces to keep the high accuracy performance of the
multi rotor and Tx.
indirectly from the use of this product.
This manual will help you to get ready to fly. You
can download an advanced manual from the
DJI website which may lead you to know the
performance of
the phantom further and
enhance your flight experience.
Do not disassemble or modify your multi rotor or transmitter.
Not waterproof and not oil-proof.
Keep the flight away from objects, such as obstacles, human beings, high-voltage
lines, etc.
Do not get close to or even touch the rotating motors and propellers, which will
cause serious injury.
DJI and PHANTOM are registered trademarks
Do not over load the multi-rotor, i.e. do not carry heavy weight
of DJI Innovations. Names of product, brand,
Check that the propellers and the motors are installed correctly and firmly before
etc., appearing in this manual are trademarks or
flight.
registered trademarks of their respective owner
Make sure the rotation direction of each propeller is correct.
companies. This product and manual are
Make sure all parts are in good condition before flight. Do not fly with old or broken
copyrighted by DJI Innovations with all rights
parts.
reserved. No part of this product or manual shall
Please switch on the transmitter first, then power on the quad-rotor before takeoff!
be reproduced in any form without the prior
Power off the quad-rotor first, and then switch off the transmitter after landing!
written
Continuously rotating the multi rotor will cause a yaw error. In this case, you should
consent
or
authorization
of
DJI
Innovations. No patent liability is assumed with
respect to the use of the product or information
contained herein.
FCC CE ROHS
©2012
大疆创新 版权所有
stop or slow down the rotating, so as to have better flight performance.
Please use the spares / accessories approved by DJI.
Please contact customer service if you have any problems you cannot solve.
dji-innovations.com
4 |
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly approved by the party
Responsible for compliance could void the user’s authority to operate this equipment. (Example- use only
shielded interface cables when connecting to computer or peripheral devices).
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable
exposure condition without restriction.
Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
©2012
大疆创新 版权所有
5 |

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.7
Linearized                      : Yes
Create Date                     : 2012:11:02 14:38:53-07:00
Creator                         : cairo 1.10.2 (http://cairographics.org)
Modify Date                     : 2012:11:02 14:41:00-07:00
XMP Toolkit                     : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26
Creator Tool                    : cairo 1.10.2 (http://cairographics.org)
Metadata Date                   : 2012:11:02 14:41-07:00
Producer                        : cairo 1.10.2 (http://cairographics.org)
Format                          : application/pdf
Document ID                     : uuid:b7a3847b-2d49-490b-a29a-df17e13b4056
Instance ID                     : uuid:4b8b2910-0192-4077-985c-7096905ee3f6
Page Count                      : 2

EXIF Metadata provided by EXIF.tools