DawnSun Electronic Technology ZhongShan TX007R1 FAN REMOTE CONTROLLER User Manual

DawnSun Electronic Technology.Co.,Ltd.ZhongShan FAN REMOTE CONTROLLER Users Manual

Manual

FCC ID Label
MODEL: TX007-N
TX007-L
TX007-S
TX007-LS
TX007-R1
TX007-LR
FCC ID: A25-TX007R1
FCC ID: A25-TX007R1
22mm
2mm
OPERATION INSTRUCTION
①
②
③
④
Front
Back Back
:
,
◎
◎
:
.
1.Fan speed control button To control the
ceiling fan speed HIGH MEDIUM,LOW.
2.FAN/OFF button: Turn off the fan;
Press and hold for 5 seconds
to enter Light Delay Off mode.
3.LIGHT ON/OFF/DIMMER button To control light
on,off and dimmer
:
,
◎
◎
:
.
1.Fan speed control button To control the
ceiling fan speed HIGH MEDIUM,LOW.
2.FAN/OFF button: Turn off the fan;
Press and hold for 5 seconds
to enter Light Delay Off mode.
3.LIGHT ON/OFF/DIMMER button To control light
on,off and dimmer
Tact Switch: Press to learn code.
4.
Note:Install the 12-volt battery( included) to the remote control.
TX007-N TX007-L
12V
12V
MODEL: TX007-N
TX007-L
TX007-S
TX007-LS
TX007-R1
TX007-LR
12V
12V
④
④
④
④
Back
Back
Back
Back
:
,
◎
◎
:
.
1.Fan speed control button To control the
ceiling fan speed HIGH MEDIUM,LOW.
2.FAN/OFF button: Turn off the fan;
Press and hold for 5 seconds
to enter Light Delay Off mode.
3.LIGHT ON/OFF/DIMMER button To control light
on,off and dimmer
4.DIP Switch: Slide DIP switches to the same position
as set on your receiver. The code on
receiver and transmitter must be the same.
:
,
◎
◎
:
.
1.Fan speed control button To control the
ceiling fan speed HIGH MEDIUM,LOW.
2.FAN/OFF button: Turn off the fan;
Press and hold for 5 seconds
to enter Light Delay Off mode.
3.LIGHT ON/OFF/DIMMER button To control light
on,off and dimmer
Extended Function Switch
4.
:
,
◎
◎
:
.
1.Fan speed control button To control the
ceiling fan speed HIGH MEDIUM,LOW.
2.FAN/OFF button: Turn off the fan;
Press and hold for 5 seconds
to enter Light Delay Off mode.
3.LIGHT ON/OFF/DIMMER button To control light
on,off and dimmer
Tact Switch: Press to learn code.
5.DIP Switch: Slide DIP switches to the same position
as set on your receiver. The code on
receiver and transmitter must be the same.
4.
:
,
◎
◎
:
.
1.Fan speed control button To control the
ceiling fan speed HIGH MEDIUM,LOW.
2.FAN/OFF button: Turn off the fan;
Press and hold for 5 seconds
to enter Light Delay Off mode.
3.LIGHT ON/OFF/DIMMER button To control light
on,off and dimmer
Tact Switch: Press to learn code.
5.Extended Function Switch .
4.
TX007-S
TX007-R1
TX007-LS
TX007-LR
OPERATION INSTRUCTION
⑤
⑤
12V
12V
Note:Install the 12-volt battery( included) to the remote control.
●Products shall be subject to any changes without additional notices due
to DawnSun will keep innovation and optimization on the products.
FCC STATEMENT
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1)This device may not cause harmful interference
This device must accept any interference received including interference that may
cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment
.
,(2)
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and use in accordance with
the instructions, may cause harmful interference to radio communications.
However there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1.Reorient or relocate the receiving antenna.
2.Increase the separation between the equipment and receiver.
3.Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
4.Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
,
OPERATION INSTRUCTION
Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.

Navigation menu