DewertOkin RF339 REMOTE CONTROL User Manual
DewertOkin GmbH REMOTE CONTROL
User Manual
ShenZhen C&D D Electro onics CO O.Ltd. Add: Buildin ng 2, Xiayoussong Mounta aintop Industtrial District,Y YousongVilla age,LongHua Town, Baoan District She enZhen Chin na Zip 51810 09 Tel: 86-755- 28142422 Fax: 86-755--28142699 E-mail: expport@cn-cdrc.com Rem mote con ntrol speecificatioon 文 文件编号 号 docum ment se eries number: 产品 品名称 productt name 2.4G 遥控器 器 remotte contrrol 产品 品型号 product t model RF339 批准 approvval /日期 datee 审核 checke ed /日期 datee 拟制 制 made /日期 datee 客户确认(盖章 章)cusstomerr appro oval 客 客户名称 称 custtomer DEEWERTT 版 版本记录 录 versio on recorrd: 审核 审 批 批准 ch heck ap pproval version date name V0.1 2015‐5‐5 remark 初稿 draft 2、目录 Index NO. appellation 规格书封面 目录 检验内容及要求 产品效果图 无线发射距离(RF transmit distance) 软件功能(software function) 原理图(Schematic diagram) 爆炸图 尺寸图(dimension drawing) 10 包装图(packing drawing) (Approval Sheet Cover) (Index) (Verification content & Requirement) (Product Cosmetics drawing) (Explosion drawing) 深圳市创荣发电子有限公司 SHENZHEN C&D ELECTRONICS CO., LTD. 3.检验内容及要求 (Verification content & Requirement) 1、 一般项目(General Items) 1.1、 适用范围 Apply for: RF339 1.2、 工作环境 Working Environment: 0℃~40℃、8﹪~90﹪RH 1.3、 存储温度 Storage Environment:‐40℃~70℃,5﹪~90﹪RH 1.4、 试验环境 Test Environment:5℃~35℃、45﹪~75﹪RH、86~106Kpa 1.5、 额定电压 Rating Voltage:DC4.5V 1.6、 适用电池 Power: AAA*3 pcs 1.7、 重量范围 Weight:145g 2、 可视检测项目 Visible Test Item 测试条件 Test Conditions A:正面在标准光源下 30CM 距离 10 秒以内目测 Put the top face under the standard light source and test by sight from the 30cm distance for 10 seconds B:其余面标准光源下 50CM 距离 5 秒以内目测 Put other sides under the standard light source and test by sight from the 50cm distance for 5 seconds 序 号 项目 Item 测试要求 Test Requirements No. 2.1 2.2 划伤、沾污、割裂、变形 Scratches, Stain and distortion of the Unit 印刷图形及文字 内容正确、清晰、均匀、整齐 Hot Stamped Graphics and Letters Correct, in focus and comply with the drawing 2.3 壳体配合 Match of top case and bottom case 2.4 表面 Appearance 3、 无上述各种现象 No described situations 无翘起、变形、开裂、断差 No distortion and Crack between the twoparts 材质正确、顔色一致 Correct material and color 电气性能 Electric Capability 序 号 项目 测试要求 Test Requirements 3.0 主控芯片 IC 3.2 工作电压 Working Voltage DC4.5V 3.3 待机电流 Static Current <10uA 3.4 工作电流 Working Current 按键时工作电流 22mA±3mA nordic NRF24LE1 Page 3/14 深圳市创荣发电子有限公司 SHENZHEN C&D ELECTRONICS CO., LTD. 3.7 工作原理图 详见工作原理图 Refer to Schematic Diagram Schematic Diagram 3.11 载波频率偏移 偏移±150KHz 3.12 天线增益 0dB 性能测试 每个按键需操作有效 Actual performance test No Failure in each key Operation 3.15 3.2 机械性能 Mechanical Capacity 序 号 项目 Item 测试要求 Test Requirements No. 4.1 4.2 跌落测试 Drop Test 振动测试 Vibration Test 80CM 高度 6 面各一次,自由跌落至厚度 3CM 硬质木板上,再行检测: a、接受电池和卡套与产品分离 b、重装电池后功能正常 c、结构无 损伤 d、上述电气性能正常 Drop the 6 faces of the bare unit from the height of 80cm of the steel which is 3cm thick and test: A> the battery separate from the remote is acceptable. B> the remote works well after reinstall. C> no damages on mechanical. d. the above electronic capacity work well 水平和垂直方向,每个方向两种频率各 5 个循环:a、频率 10~30~10Hz 位移距离 0.75mm b、频率 30~55~30Hz 位移距离 0.15mm,测试后检 测结构无损伤, 电气性能正常 5 recycle of 2 frequencies in the horizontal and vertical direction: a. frequency 10~30~10Hz to move 0.75mm. b. frequency 30~55~30Hz to move 0.15mm, no damages in mechanical and electronic capacity 1. 3M 胶纸(600)5 次无脱落现象 4.3 喷油丝印附着力测试 Print a Adhesion Test 3M tape(600) 5 times, the print is complete 2. RCA 测试:以 225gf 力测试纸带长度 100CM 无脱落现象 RCA test: use 225gf force, 100CM length tape, the print is complete 4.4 4.5 喷油丝印耐腐鉵测试 Print corrosion test 声音要求 Sound Request 1. 用棉布浸泡 99%工业酒精 1min,500gf 来回 20 次擦试无脱落现象 Sink the cotton in 99% alcohol 1 minutes with 500 gf for to scrub the print 20 time 遥控器晃动是不能有异响。 There shall be no rattling when the remote is shaken. Page 4/14 深圳市创荣发电子有限公司 SHENZHEN C&D ELECTRONICS CO., LTD. 3.3 环境测试 Environmental Test 序 号 项目 Item 测试要求 No. 操作温度 遥控器在 0ºC~ +40ºC 环境下可以正常操作。 5.1 Operating Temperature 操作湿度 The RCU shall be capable of operating in an ambient temperature range of 0ºC to +40ºC. 遥控器在 8%º~90%湿度环境下可以正常操作,不冷凝。 5.2 Operating Humidity The device shall be capable of operating in a relative humidity range of 8% to 90%, non‐condensing. 存放温度 遥控器在放置于‐40º ~+70ºC 的高低温环境后仍可正常操作。 Storage Temperature The RCU shall be capable of operating after being stored in an ambient temperature range of ‐40º to +70ºC. 存放湿度 遥控器在放置于 5%~ 90%的湿度环境后仍可正常操作。 Storage Humidity The RCU shall be capable of operating after being stored in a relative humidity range of 5% to 90%, non‐condensing. 5.3 5.4 3.4 产品认证 Compliant 序 号 项目 Item 规格 Specs No. 6.1 6.2 FCC FCC ID 认证 IC IC ID 认证 Page 5/14 深圳市创荣发电子有限公司 SHENZHEN C&D ELECTRONICS CO., LTD. 4.产品效果图 ID drawing Page 6/14 深圳市创荣发电子有限公司 SHENZHEN C&D ELECTRONICS CO., LTD. 5、无线距离 distance: RF distance 距离 直线距离 direct distance 15m 非直线距离 indirect distance 10m 6、功能 function test: 1、 配对 pairing: 设备正确连接后,连续按下两次配对键,此时 RF181B 接收器上的绿色指示灯会亮起。然后在 RF181A 发 射器上同时按下 S20 键进行配对。配对成功后,RF181A 发射器上的 LED 灯和 RF181B 接收器上的绿色指示 灯会同时熄灭。此时,设备已经成功配对。 Afrer connecting, to pressed the pairing button continuously for two time on RF181B, and the indicator lights,then press the button S20 on RF181A to pair with this receiver,if both the green LED indicator on RF181B and the pairing indicator on RF181A will be off at the same time,the pairing is successful. 2、 按键测试 button test 按键 功能描述 按下 S2 按键,背景灯亮。 The keypad backlight is on 按下按键,H1 黄灯亮。 H1 lights yellow 按下按键,H2 黄灯亮。 H2 lights yellow 按下按键,H3 黄灯亮。 H3 lights yellow 按下按键,H11 和 S2 LED 亮的时间一样。 H11 light on as long asS2 is pressed 测试亮灯结果一样,则功能测试通过。Test lights result match the function description, then the test pass. Page 7/14 深圳市创荣发电子有限公司 SHENZHEN C&D ELECTRONICS CO., LTD. 7、遥控器原理图 Schematic diagram: 7.1 原理图 Schematic diagram Page 8/14 深圳市创荣发电子有限公司 SHENZHEN C&D ELECTRONICS CO., LTD. 7.2 Connecting Plan Page 9/14 深圳市创荣发电子有限公司 SHENZHEN C&D ELECTRONICS CO., LTD. 8、爆炸图 Explosion drawing Page 10/14 深圳市创荣发电子有限公司 SHENZHEN C&D ELECTRONICS CO., LTD. 9、尺寸图 dimension drawing Page 11/14 深圳市创荣发电子有限公司 SHENZHEN C&D ELECTRONICS CO., LTD. Page 12/14 深圳市创荣发电子有限公司 SHENZHEN C&D ELECTRONICS CO., LTD. 10.包装图 packing drawing Page 13/14 深圳市创荣发电子有限公司 SHENZHEN C&D ELECTRONICS CO., LTD. FCC Warning / IC Warning FCC: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: Any changes or modifications not approved by the party responsible for compliance could void the user's authority to operate the equipment. IC: This device complies with Industry Canada RSS-210 standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device." Leprésent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio Exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement." Page 14/14
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : Yes XMP Toolkit : 3.1-701 Producer : Acrobat Distiller 7.0 (Windows) Creator Tool : PScript5.dll Version 5.2 Modify Date : 2015:06:04 23:33:44+08:00 Create Date : 2015:06:04 23:33:44+08:00 Format : application/pdf Title : Microsoft Word - Dewert RF339 Remote specification 201505071 Creator : Administrator Document ID : uuid:a4944537-fb42-4022-a1a5-69c863fc2c8e Instance ID : uuid:38e96797-cae7-4975-8e94-83b89ac41d4a Page Count : 14 Author : AdministratorEXIF Metadata provided by EXIF.tools