Dialog Semiconductor SC14A DECT Cordless Voice Module User Manual safety requirements
Dialog Semiconductor BV DECT Cordless Voice Module safety requirements
Contents
- 1. user manual
- 2. user manual safety requirements
user manual safety requirements
1. Safety requirements
This section provides of an overview of the safety requirements you must adhere to when working
with the Cordless Voice Module SC14CVMDECT.
1) The specific external power supply for the Cordless Voice Module SC14CVMDECT has to
fulfil the requirements according to clause 2.5 (Limited power source) of this standard EN
60950-1:2006.
2) Interconnection circuits shall be selected to provide continued conformance to the
requirements of clause 2.2 for SELV (Safety Extra Low Voltage) circuits according to EN
60950-1:2006 after making connections.
3) Interface type not subjected to over voltages (i.e. does not leave the building).
4) Requirements additional to those specified in this standard may be necessary for:
- Equipment intended for operation in special environments (for example, extremes of
temperature, excessive dust, moisture or vibration, flammable gases and corrosive or
explosive atmospheres).
- Equipment intended to be used in vehicles, on board ships or aircraft, in tropical
countries or at altitudes grater than 2000 m.
- Equipment intended for use where ingress of water is possible.
5) Installation by qualified personnel only!
6) The product is a component intended for installation and use in complete equipment. The
final acceptance of the component is dependent upon its installation and use in complete
equipment.