ENGLISH
LCD TV User’s Manual
Safety Instructions
ENGLISH
FCC Information
This equipment has been tested and found to comply with limits for a
class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment can generates, uses, and radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful inteference to radio Communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause unacceptable interference to radio and
Notes & Descriptions
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
To reduce the risk of fire, electrical shock and other injuries, keep these safety precautions in mind
when installing, using and maintaining your TV.
interference by one or more of the following measures.
Reorient or relocate the receiving antenna.
Warning : If you manipulate against the notice, it may cause serious injury or death to user.
Caution : If you manipulate against the notice, it may cause slight injury to user or appliance.
To preserve the Environment do not rubbish.
Caution : Any changes or modifications in construction of this device which are not expressly
approved by the party responsible for compliance could void the user's authority to
operate the equipment.
Ver 1.00NE
EN 2 15” TFT-LCD TV
Warning
When moving it, do not apply any forces on the set.
Disconnect the power cable and signal cable connected to the product in case
of thunder or lightning.
Do not attempt to disassemble, repair or change the product.
Whenever you need to repair, adjust or check it, refer servicing to qualified
Do not attempt to touch its power cord with wet hands.
service personnel.
ENGLISH
If any electric pin is wet or dusty, remove the moisture or dust first before use.
Do not directly spray water or rub it with inflammable substances (thinner or
It is recommended to pull out the power cord unless you use it for a long time.
benzene) when cleaning it.
Damaged power cord, plug or unfitted outlet may be very dangerous.
Do not wet or penetrate water over/into the set.
When cleaning the LCD surface, disconnect the power and use a piece of
Do not install the set close to any heating sources.
Do not place heavy articles on it or step on the product.
The product should be installed on a clean and dry place.
smooth cloth against any scratches on it. Never use wet cloth.
Caution
Make sure to pull out the power cord when cleaning or removing the product.
Ventilation should be always open and the set should be installed in a wellWhen you detect any smog, unusual noise or smell, just disconnect the electric
power and refer servicing to qualified service personnel.
Do not place any bowl with water, beverage, can or other liquid products on it.
ventilated and wide enough place (a minimum distance away from a wall 10cm
or more).
Do not install the set in a place directly exposed to sunlight.
Do not use or place any combustible sprayer or inflammable substances close
to the product.
Do not arrange the power cord close to any heating devices/sources.
Install the outdoor antenna for the set far away from high voltage cables.
EN 4 15” TFT-LCD TV
Available Temperature & Humidity
Operating Temperature
0~40˚C
Storage Temperature
-10~50˚C
10~60% RH
Storage Humidity
10~90% RH
ENGLISH
Operating Humidity
For dot defect [dead pixel] of LCD ;
TFT-LCD produced by using high-end semiconductor technology with precision of 99.9% above is
used for this TV (2,359,296 pixels).
However the pixels of R.G.B. & White color seem to be right sometimes or some of black pixels
could be seen on the LCD. This is not from bad quality or functional problem and you can use it
without any problem.
When used as a PC monitor ;
Optimal Resolution: 1024 768 @ 60Hz.
Max. Resolution: 1024 768 @ 75Hz.
EN 6 15” TFT-LCD TV
Contents
Before Use
12
Using Menus of Picture,
Sound and Others
1-2. Panels
13
4-1. Setting Picture Mode
42
1-3. Remote Control
16
4-2. Setting Sound Mode
44
1-4. Menu Configuration
18
4-3. Setting Option
45
1-5. Jog Shuttle Button
20
1-6. Inserting the Batteries in the Remote Control
21
1-1. Accessories
CHAPTER 4.
CHAPTER 5.
CHAPTER 2.
CHAPTER 3.
EN 8 15” TFT-LCD TV
Connection
Using PC MENU
5-1. Auto Adjustment
48
5-2. Setting Picture
49
2-1. Connecting Power
24
5-3. Setting Sound
50
2-2. Connecting TV Antenna
24
5-4. Setting Option
51
2-3. Connecting PC
25
5-5. Setting Color Temperature
52
2-4. Connecting DTV
25
2-5. Connecting DVD
26
2-6. Connecting VIDEO / S-VIDEO
27
2-7. Connecting Headphone (Speaker)
28
CHAPTER 6.
ENGLISH
CHAPTER 1.
Specifications
6-1. Dimensions
54
6-2. Specifications
55
Using TV Menus
CHAPTER 7.
Services & Others
3-1. Watching TV
30
3-2. Channel Search
33
7-1. Troubleshooting
58
3-3. Fine Tune
34
7-2. Concerning Services
60
3-4. Add/Remove Channel
35
3-5. Channel Swap
36
3-6. Change TV Channel Mode
37
3-7. Closed Caption
38
3-8. V-chip Function
39
CHAPTER 1
ENGLISH
Before use
1-1. Accessories
1-2. Panels
1-3. Remote Control
1-4. Menu Configuration
1-5. Jog Shuttle Button
1-6. Inserting the Batteries in the Remote Control
EN 10 15” TFT-LCD TV
11
1-1. Accessories
1-2. Panels
Please make sure the following items are included with your LCD TV.
1) Front Panels
If any items are missing, contact your dealer.
ENGLISH
AA-type battery( 2)
User’s Manual
DC Adaptor
Power Cord
RF Cable
Remote Control
Power/Menu
Power-On/Off
Channel Button
AUTO / Move above Menu
Sound Cont. / Menu Set
SOURCE / Move under Menu
Remote Control Sensor
Exit Menu
LED
Load Menu
AUTO button searches automatically TV channels if set as TV, and it adjusts
automatically for PC mode.
Power button is jog shuttle type button and it operates different functions by pushing it
to Up/Down/Left/Right.
EN 12 15” TFT-LCD TV
13
2) Rear Panels
3) Side Panels
ENGLISH
DVD Audio Input (L R)
DVD Input (Pb Y Pr)
Power Input
PC Input
DTV Input (Pb Y Pr)
DTV Audio Input (L, R)
Audio (PC Input/Headphone Output)
TV Antenna Input
EN 14 15” TFT-LCD TV
Audio Input (L, R)
S-Video Input
Video Input
15
1-3. Remote Control
Functions by remote control buttons
Button
POWER
TV Input Button
PC Input Button
Numeric Buttons
Display Mode Control Button
Button
MUTE
Function
Sound off Temporarily
CH + / -
Move TV channels / Move MENU up and down
VOL + / -
Control Volume / Move Menu / MENU settings
MENU
Enter Main MENU
TV
TV Input
PC
PC Input
0~9
Numberic Buttons
ENT
Input selected channels
PRE
Previous Channel
PICTURE
Control Picture Mode
SCALE
Control Picture Scale
MEMORY
Add/Remove a TV CH
AUTO
TV : Channel search / PC : Auto Adjustment
DISPLAY
Display screen status
SLEEP
Sleeping Timer setting
Control Brightness
DTV
DTV Input
DVD
DVD Input
VIDEO/S-VIDEO
VIDEO/S-VIDEO Input
ENGLISH
MENU Control Button
Channel & Volume Control Button
Function
Power On/Off
The remote control provided is available up to 7m from the optical receive part within Left/Right
30 degrees.
EN 16 15” TFT-LCD TV
17
1-4. MENU Configuration
2) Using Remote Control
Most functions of the TV set can be controlled by MENU and selection buttons on the
remote control, so learning how to operate them would be convenient for you.
Press MENU button to display main menu.
1) Menu Configuration
ENGLISH
Press VOL button to move to sub menu of a selected main
menu.
Main Menu
Sub Menu
Settings
To move among menus, use CH button.
To change a selected menu setting, use CH button.
Press VOL button to return from sub menu to main menu or
from main menu to menu removal.
EN 18 15” TFT-LCD TV
19
1-5. JOG Shuttle Button
1-6. Inserting the Batteries in the
Remote Control
Push MENU button right to display main menu.
Remove the cover of the remote control.
Push it right again to display sub menu.
ENGLISH
Check the polarity of batteries and insert them in right directions.
Replace the cover.
Available batteries : 2 DC 1.5V AA-type batteries
Push MENU button left to return to main menu.
Since incorrect insertion of batteries may cause breakage, leakage or injuries, check
the polarities before the insertion.
Separate and collect used batteries for the protection of environment.
Do not use alkaline and manganese batteries together.
Push it left again to clear menu.
Push the button up and down to move among menus.
If pushing it upward when menu is not displayed, it
controls TV channel search or automatic PC settings.
If pushing it downward when menu is not display, it
changes input signals.
EN 20 15” TFT-LCD TV
21
CHAPTER 2
ENGLISH
Connection
2-1. Connecting Power
2-2. Connecting TV Antenna
2-3. Connecting PC
2-4. Connecting DTV
2-5. Connecting DVD
2-6. Connecting VIDEO / S-VIDEO
2-7. Connecting Headphone (Speaker)
EN 22 15” TFT-LCD TV
23
2-1. Connecting Power
2-3. Connecting PC
The product automatically adjusts voltage.
In case 110V is used, connect 110V Conversion adaptor before use.
Power Cable should be firmly connected to an outlet or DC adaptor in order not to
be pulled out or shake.
ENGLISH
2-2. Connecting TV Antenna
When round cable (75Ω coaxial cable) is used, copper part of the cable should not
Connect D-Sub Cable to D-Sub port on the TV and PC.
be bent.
Connect Audio Cable (not included) to Audio output of a PC (stereo jack) and PC
Audio Input Port of the TV (stereo jack).
TV Wall-outlet
TV antenna
2-4. Connecting DTV
Digital TV Broadcasting Receiver
RF cable
Connecting RF
cable
copper wire
Antenna converter
Connecting
feeder cable
feeder cable
TV Wall-outlet
Cautions
Pb
Pr
Pb
Pr
Source Exif Data:
File Type : PDF
File Type Extension : pdf
MIME Type : application/pdf
PDF Version : 1.2
Linearized : No
Page Count : 31
XMP Toolkit : XMP toolkit 2.9.1-13, framework 1.6
About : uuid:9ab74f4c-69ee-418e-b623-9289dfa27326
Producer : Acrobat Distiller 4.0 for Macintosh
Modify Date : 2005:06:22 10:59:20+09:00
Create Date : 2005:05:18 16:26:06Z
Creator Tool : QuarkXPress3.3k: AdobePS 8.5.1
Metadata Date : 2005:06:22 10:59:20+09:00
Document ID : uuid:aa5f6354-df37-4298-b39c-e1d2a31a3227
Format : application/pdf
Title : #NEO15¹ÌÁÖÇâEN
Creator : µðÀÚÀγÝ
Author : µðÀÚÀγÝ
