Bamocar NDrive Manual
User Manual:
Open the PDF directly: View PDF
Page Count: 117 [warning: Documents this large are best viewed by clicking the View PDF Link!]
- 1.1
- 2 Basic information
- 3 Start screen
- 4 Help
- 5 Storage
- 6 Selection of the communication interface
- 7 Measured values
- 8 Conversion
- 9 Errors
- 10 Enable
- 10.1 Hardware - Enable FRG/RUN
- 10.2 Safety
- 10.3 Settings
- 10.4 Motor setting
- 10.5 Setting window for the feedback encoder
- 10.6 Setting window for the feedback encoder
- 10.7 Setting X8 as second counter input
- 10.8 Brake setting
- 10.9 Ballast circuit setting
- 10.10 Motor temperature setting
- 10.11 Setting of the power connection/bus circuit
- 10.12 Output stage temperature
- 10.13 Setting field for rated servo data
- 10.14 Setting field for rated servo data
- 10.15 Command value setting
- 10.16 BTB / RDY setting
- 11 CAN-BUS settings
- 12 Parameter
- 13 Field weakening at synchronous motors
- 14 Torque control
- 15 Position controller parameters
- 16 Frequency converter parameters
- 17 Logic
- 18 Diagnosis
- 19 Monitor
- 20 Options
- 21 Automatic setting functions
- 21.1 Setting window Auto
- 21.2 Tuning still (0x85-1)
- 21.3 Tuning rotating (0x85-2)
- 21.4 Phasing still (0x85-3)
- 21.5 Measuring the encoder offset (phase angle)
- 21.6 Preset current feed angle (0x85 – 5)/fixed motor position (0x85-5)
- 21.7 Analog offset (0x85 -6)
- 21.8 Tacho offset (0x85 -7)
- 21.9 Calc from Motorplate (0x85-8)
- 21.10 VdcBus Adjustment
- 22 Oscilloscope
- 23 Parameters