Digi XBee3 Cellular LTE Cat 1 Smart Modem User Guide LTEC1 Users 90002253
User Manual:
Open the PDF directly: View PDF
Page Count: 178 [warning: Documents this large are best viewed by clicking the View PDF Link!]
- Digi XBee3 Cellular LTE Cat 1 Smart Modem User Guide
- Get started with the XBee Smart Modem Development Kit
- Connection examples
- Get started with MicroPython
- Technical specifications
- Hardware
- Antenna recommendations
- Design recommendations
- Cellular connection process
- Modes
- Sleep modes
- Power saving features
- Serial communication
- SPI operation
- File system
- Socket behavior
- Supported sockets
- Socket timeouts
- Socket limits in API mode
- Enable incoming TCP connections
- API mode behavior for outgoing TCP and SSL connections
- API mode behavior for outgoing UDP data
- API mode behavior for incoming TCP connections
- API mode behavior for incoming UDP data
- Transparent mode behavior for outgoing TCP and SSL connections
- Transparent mode behavior for outgoing UDP data
- Transparent mode behavior for incoming TCP connections
- Transparent mode behavior for incoming UDP connections
- Transport Layer Security (TLS)
- AT commands
- Special commands
- Cellular commands
- Network commands
- Addressing commands
- Serial interfacing commands
- I/O settings commands
- D0 (DIO0/AD0)
- D1 (DIO1/AD1)
- D2 (DIO2/AD2)
- D3 (DIO3/AD3)
- D4 (DIO4)
- D5 (DIO5/ASSOCIATED_INDICATOR)
- D6 (DIO6/RTS)
- D7 (DIO7/CTS)
- D8 (DIO8/SLEEP_REQUEST)
- P0 (DIO10/PWM0 Configuration)
- P1 (DIO11/PWM1 Configuration)
- P2 (DIO12 Configuration)
- P3 (DIO13/DOUT)
- P4 (DIO14/DIN)
- PD (Pull Direction)
- PR (Pull-up/down Resistor Enable)
- M0 (PWM0 Duty Cycle)
- I/O sampling commands
- Sleep commands
- Command mode options
- MicroPython commands
- Firmware version/information commands
- Diagnostic interface commands
- Execution commands
- File system commands
- Operate in API mode
- API frames
- Configure the XBee Smart Modem using Digi Remote Manager
- Troubleshooting
- Regulatory information