CDA3000 Lust CDA Inverter Servo Drive Manual

• CDA3000 Operation Manual
• ID no.: 0840.00 B.5-00 • 08/2005
• 1 Safety
  • Pictograms used in this manual
  • 1.2 Intended use
  • 1.3 Responsibility
• 2 Mechanical installation
  • 2.1 Notes for operation
  • 2.2 Mounting variants
  • 2.3 Wall mounting
  • 2.4 Cold plate
  • 2.5 Push-through heat sink (Dx.x)
• 3 Installation
  • 3.1 Overview
  • 3.2 compliant installation
    • Assignment of drive controller with internal line filter
    • Assignment of drive controller with external line filter
  • 3.3 Grounding lead connection
  • 3.4 Motor connection
  • 3.5 Mains connection
  • 3.6 DC network
  • 3.7 Braking resistor (RB)
  • 3.8 Control connections
    • 3.8.1 Choice of terminal assignment
    • 3.8.2 Specification of control terminals
    • 3.8.3 Terminal assignment 1
    • 3.8.4 Terminal assignment 2
    • 3.8.5 Terminal assignment 3
    • 3.8.6 Encoder
• 4 Commissioning
  • 4.1 Choice of commissioning
  • 4.2 Standard commissioning
  • 4.3 KeyPad commissioning
  • 4.4 DriveManager commissioning
    • Test setting
  • 4.5 Direction check
  • 4.6 Serial commissioning
    • 4.6.1 Serial commissioning with KeyPad
    • 4.6.2 Serial commissioning with DriveManager
  • 4.7 Operation with KeyPad KP200
  • 4.8 Operation with DriveManager
  • 4.9 Parameter list (selection)
• 5 Diagnosis/Fault rectification
  • 5.1 LEDs
  • 5.2 Error messages
    • Helpline
    • Service/support
  • 5.3 User errors in KeyPad operation
  • 5.4 User errors in SmartCard operation
  • 5.5 Errors in power switching
  • 5.6 Reset
• A Appendix
  • Inverter modules for 230 V systems
  • Inverter modules for 400/460 V systems:
  • A.2 Technical data
    • CDA32.004 to CDA34.006
    • CDA34.008 to CDA34.060
    • CDA34.072 to CDA34.250
  • A.3 Ambient conditions
  • A.4 Project planning notes, Cold plate
  • A.5 Project planning notes for multi- motor operation
    • A.5.1 Engineering note „Motor contactor“
  • A.6 through use of a line choke
    • Mains load (example)
    • Mains voltage asymmetry (example)
  • A.7 Line filter
  • A.8 UL approbation
    • Measures to maintain UL approbation
    • Minimum cross-section of the grounding lead to DIN VDE 0100 Part 540
  • A.9 Layouts of all sizes