ELITEGROUP COMPUTER SYSTEMS TRBC1CD1 Wireless Motherboard User Manual
ELITEGROUP COMPUTER SYSTEMS CO., LTD Wireless Motherboard
User Manual
TR10CD1 Motherboard Guide FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/ TV technician for help. Operations in the 5.15-5.25GHz band are restricted to indoor usage only. CAUTION: Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. RF Exposure Information This device meets the government’s requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: "Contains FCC ID: WL6-TRBC1CD1” Information for the OEMs and Integrators The following statement must be included with all versions of this document supplied to an OEM or integrator, but should not be distributed to the end user. 1) This device is intended for OEM integrators only. 2) Please see the full Grant of Equipment document for other restrictions. This radio transmitter FCC ID: WL6-TRBC1CD1 has been approved by FCC to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. Antenna List No. Manufacturer Part No. Pulse 02H475-00 6500 Antenna Type Peak Gain Ceramic Chip Antenna 3.2 dBi for 2.4GHz Note: The antenna connector is I-PEX type. 4.2 dBi for 5 GHz Motherboard layout Main components No. Name No. CPU+PMIC+DDR+EMMC NFC Audio Codec TPM Microphone Rear facing camera Microphone Name System connectors No. Name No. Name Power key Connector Front Camera Battery Connector LCD Connector Touch panel Connector Speaker Connectors Volume key Connector SIM Card Connector I/O Ports No. Name No. Name Micro USB port Headphone plug Mini HDMI port DC-in jack Micro SD card slot Features Intel Cloverview + Dual core L2 cache up to 512KB 8bit, LP DDR2 Mobile RAM PoP 1GB Storage Single eMMC v4.512 Default 16 GB Wireless Wi-Fi 802.11 a/b/g/n Bluetooth 3.0 NFC support LVDS interface Resolution: 1280(H) × 3 (RGB) × 800(V) pixels Support multi-touch feature Processor Memory Display Cameras Control Two MIPI CSI-2 interfaces for external image sensors. Enhanced color interpolation 12-bit color resolution Video image stabilization support Flash light control Rear camera: 5.0 M Input/Output 1 x micro-USB 2.0, OTG port (Type A/B) 1 x Mic/head phone jack combo 1 x mini-HDMI (Type D) 1 x micro-SD card slot 1 x DC-in jack Micro SIM card support Speaker & Mic Build-in Speaker x 2 Internal Digital MIC x 1
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : Yes Encryption : Standard V2.3 (128-bit) User Access : Print, Extract Tagged PDF : Yes XMP Toolkit : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:14:39 Create Date : 2014:02:07 16:32:48+08:00 Creator Tool : Microsoft® Word 2010 Modify Date : 2014:02:07 17:29:14+08:00 Metadata Date : 2014:02:07 17:29:14+08:00 Format : application/pdf Creator : apple Producer : Microsoft® Word 2010 Document ID : uuid:af7e8658-091a-45db-bf0d-3b1ffe972024 Instance ID : uuid:d4243ae9-a85b-44e8-9a44-9dcbff5be5fd Page Count : 10 Language : zh-TW Author : appleEXIF Metadata provided by EXIF.tools