FLYSKY RC MODEL TECHNOLOGY FLYSKYT4B 4CH Radio Control System User Manual FS CT6A

Download:
Mirror Download [FCC.gov]
Document ID	1696521
Application ID	8qinHybp1KHYpHQqbhA2Lw==
Document Description	User manual part II
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	111.21kB (1390100 bits)
Date Submitted	2012-05-14 00:00:00
Date Available	2012-05-14 00:00:00
Creation Date	2012-05-10 09:22:11
Producing Software	Corel PDF Engine Version 3.0.0.667
Document Lastmod	2012-05-10 09:22:11
Document Title	FS-CT6A说明书
Document Creator	CorelDRAW
Document Author:	杨诚

Notes
Model: FS-T4B
2.4G 4 Channel remote system
10. 2. 4G Operation notes
This is 2.4 G Frequency model products make of automatic address code.It use digital
transmission mode, and this prevent outside interference effective active and passive.
10. 01 Matching (code)
Our products are well matched in the factory, you do not need to match by yourself.
But if your are going to match the receiver with other transmitter, please follow the
following steps:
1. Install the battery to 2.4G transmitter and shut it down.
2 . Insert the matching lines to the channel Bat port of the receiver. ( Figure. 1）。
3 . Connect the receiver battery to any one of the channel port, on the same time the
two LED are flashing and this means the receiver are going to the match status.
4.Press and hold the button on the transmitter, and then switch on the power supply.
5 . Observe the LED on the receiver, if found that the LED is not flash anymore and
that means successful matched.（This process about 10s )
6 . Release the match button on the transmitter, take out the match line.
7 . Install the server and then test.
8 . If the tests fail, please repeat the action above.
9 . If the tests success, then insert the power supply port into BAT, match complete.
(The above ways of match is only suitable on FLYSKY 2.4G products)
Match line
Match key
Figure 1
10. 02 Boot
1. Connect every part.
2. Switch on the power supply.
3. Connect the power supply.
4. Receive LED light solid.
5. Finish and use.
Notes
Model: FS-T4B
2.4G 4 Channel remote system
Boot
Rx power ON
Tx power ON
10. 03 Shut down：
1. Cut off the receiver power supply.
2. Cut off the transmitter power supply.
Shut down
Rx power off
Tx power off
Notes
Model: FS-T4B
2.4G 4 Channel remote system
11.Functional description
11. 01. 1 Channel control
This channel is for aileron control .
Right
Left
Move left
Figure1
If you move the transmitter stick to the left,
The airplane will inclined to the left and the
airplane move left.（Figure.1）
If you move the transmitter stick to the right,
the airplane will inclined to the right and the
airplane move right.（Figure.2）
Move right
11. 02. 3 Channel control
This channel is use for throttlecontrol.
Figure2
上
下
Rise
Figure3
Drop
Figure4
If you move the transmitter stick upward
the power of airplane will increase and the
airplane rise.（Figure.3）
If you move the transmitter stick downward
the power of airplane will decrease and the
airplane drop.（Figure.4）
10
Notes
Model: FS-T4B
2.4G 4 Channel remote system
11. 03. 2 Channel control
This channel is use for forward and backward control.
Up
Figure1
Move forward
Down
If you move the transmitter stick upward,
the airplane will move forward.（Figure.1）。
If you move the transmitter stick downward,
the airplane will move backward.（Figure.2）。
Figure2
Move backward
11. 04. 4 Channel control
This channel is use for left and right turning control.
If you move the trans mitter stick to the left,
The airplane will turning to the left.（Figur e.3）
Left
If you move the trans mitter stick to the left,
The airplane will turning to the left.（Figur e.4）
Right
Figure.3
Left turning
Figure.4
Right turning
11
Notes
Model: FS-T4B
2.4G 4 Channel remote system
12.Professional terminology
AIL:副 翼
ELE:升 降 舵
THR:油 门
RUD:方 向 舵
GEAR:
PITCH :螺 距
FM:调 频
PPM:脉 冲 相 位 编 码
PCM:脉 冲 数 据 编 码
MODUL E :调 制
RF:射 频
DR:双 重 比 率
TRAIN E R :教 练
STICK :操 纵 杆
NULL:无 功 能
REV:反 向
NOR:一 般
TRIM:微 调
SUB.T R I M :辅 助 微 调
HELI:直 升 机
ACRO:飞 机
VR:电 位 器
SW:开 关
UP:上
DOWN:下
DES:目 标
SOURC E :起 源
IDEL:特 技
12
Notes
Model: FS-T4B
2.4G 4 Channel remote system
13.Packaging with content list
NO:
Model
16 cha nn el 2.4G
tran smitter（FS -T4B )
16 channel 2. 4G
receiver( FS- R6A)
Sum
Remarks
Match(code)line
Charger
Optional
Server( FS-S036)
Optional
Manual( FS-T4B)
13
Http: www. flyskychina. com
Copy right 2007@ flysky co. ,ltd
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
Has XFA                         : No
XMP Toolkit                     : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04
Modify Date                     : 2012:05:10 09:22:11+01:00
Create Date                     : 2012:05:10 09:22:11+01:00
Metadata Date                   : 2012:05:10 09:22:11+01:00
Creator Tool                    : CorelDRAW
Format                          : application/pdf
Title                           : FS-CT6A说明书
Creator                         : 杨诚
Document ID                     : uuid:ca575ced-4248-40b4-9c21-909d0ed318f6
Instance ID                     : uuid:c3b3a042-f00e-4f89-8f9e-d6a43e5eadf4
Producer                        : Corel PDF Engine Version 3.0.0.667
Page Count                      : 8
Author                          : 杨诚

EXIF Metadata provided by EXIF.tools