FitLinxx CB Wireless Cardio Network Adapter User Manual Wireless Signal Meter WSM

FitLinxx Wireless Cardio Network Adapter Wireless Signal Meter WSM

Exhibit D Users Manual per 2 1033 b3

PROPRIETARYCBM User Guide Doc Number: 930-00003-01 Proprietary InformationRevision HistoryDATE REVISION DESCRIPTION AUTHOR4/04/2007 01 Initial release Steven Oliver4/23/2007 02 Saftey approval updates and FCC modifications John MacLeanApprovalsThe information contained in this document is the sole property of FitSense Technology. Any reproduction in part or whole without the written permission of FitSense Technology is prohibited. FitSense Technology
CSAFE BODYLAN MODULE DOC #: 930-00003-01 REVISION: 011 User Guide1.1 Introduction:The CSAFE BodyLan Module (CBM) provides wireless communication between a CSAFE equipped fitness equipment and the Local Acess Point or Remote Acess Point. Included with a CBM is a 12 inch flat data cable. 1. Installation:Installaton and Serviceing is only to be performed by a qualified technician trained by FitLinxx in the installation of this module.1. Locate the CSAFE port on the fitness equipment console.2. The CBM needs to be placed near the CSAFE port and just below the top of the equipments console3. With a cleaning solvent clean the area on the console where the CBM is going to be placed.4. On the back of the CBM, peel off the protective cover of the Velcro adhesive and attach it to the console.5. Insert the small connector end of the data cable into the CBM and the larger end connector into the CSAFE port on the console.© 2006 FITSENSE TECHNOLOGY CONFIDENTIAL PAGE 2 OF 3
CSAFE BODYLAN MODULE DOC #: 930-00003-01 REVISION: 011.3 Operation:The following LED configurations represent the operation modes of the CBM.(●)(●)(●)(●)GREEN Solid CSAFE port is providing power(●)(●)(●)(●)GREEN SolidYELLOW SolidCSAFE port is providing powerCSAFE port is communicating with the CBM(●)(●)(●)(●)GREEN SolidYELLOW SolidYELLOW SolidCSAFE port is providing powerCSAFE port is communicating with the CBMWireless communication between the CBM and the LAP or RAP(●)(●)(●)(●)GREEN Blinking CBM is in low power mode(●)(●)(●)(●)RED Solid Attention required1.4 Regulatory:This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operations.Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the device. WARNING Rating 4.7V - 20V 20ma - - - No operator serviceable parts© 2006 FITSENSE TECHNOLOGY CONFIDENTIAL PAGE 3 OF 3

Navigation menu