Fleetwood Group V240B Low Power RF and IR Module User Manual CERTIFICATE OF COMPLIANCE
Fleetwood Group Inc Low Power RF and IR Module CERTIFICATE OF COMPLIANCE
User Manual
Rhein Tech Laboratories, Inc. 360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com Appendix L: Client: Model: Standards: FCC/IC ID: Report #: Fleetwood Group, Inc. V240B FCC 15.249/IC RSS-210 FBRV240B/1859A-V240B 2010232 Manual Please refer to the following pages. Page 29 of 39 USER MANUAL VL4B Module Copyright 2007 Fleetwood Group, Inc., Electronics Division. All rights reserved. Licensed software products are owned by Fleetwood Group, Inc. or its suppliers and are protected by United States copyright laws and international treaty provisions. Fleetwood Group, Inc. products are covered by U.S. and foreign patents, issued and pending. Information in this publication supersedes that in all previously published material. Specifications and pricing are subject to change without notice. Printed in the U.S.A. Fleetwood Group, Inc. Electronics Division 11832 James St. Holland, Michigan 49424 www.fleetwoodgroup.com Sales: 1-800-257-6390 Technical Service: 1-888-GO-REPLY (467-3759) Reply® is a registered trademark of Fleetwood Group, Inc. Other trademarks contained herein are the property of their respective holders. Revision History: ii Rev Date Description 12/8/2010 Original Table of Contents 1.0 V240B MODULE .................................................................................................................................................. 4 1.1 DESCRIPTION ....................................................................................................................................................... 4 1.2 BATTERY REPLACEMENT ..................................................................................................................................... 4 1.3 FCC AND IC ......................................................................................................................................................... 4 1.4 STANDARDS AND GUIDELINES ............................................................................................................................. 4 1.5 FCC/IC COMPLIANCE .......................................................................................................................................... 5 iii 1.0 VL4B Module 1.1 Description The V240B is a low power real time locating system badge. The V240B module is used to identify the location of an individual or asset location. It communicates at 2.4GHz, to a ceiling sensor module or a link module, and uses IR emitters that communicate with the ceiling sensor to determine its location. The overall operation of the V240B module is controlled by a microcontroller. This microcontroller is powered from approximately 3V and uses a 16 MHz reference. The microcontroller handles control of the RF and IR communications, indicator LEDs, external I/O, and keypad inputs. RF communications use a 2.4 GHz transceiver. The transceiver chip uses a 16 MHz reference oscillator that is shared with the microcontroller for TX/RX and is also powered by 3V. The transceiver uses an integral antenna on the PCB. 1.2 Battery Replacement The V240B is powered from a 3V battery. The battery is replaceable. To replace battery, open the case, remove the old battery, and replace with a new battery noting its polarity. The negative side of the battery should be facing the PCB. 1.3 FCC and IC V240B Module Responsible Party Pertaining to the Declaration of Conformity Fleetwood Group, Inc. 11832 James Street Holland, MI 49424 Attn: Product Service Coordinator Phone: 888-467-3759 1.4 Standards and Guidelines This device complies with the following USA/Canada Regulations: The USA Federal Communications Commission (FCC) Rules and Regulations Industry Canada Rules and Regulations This device complies with the following national and international standards: FCC Part 15B, 15.249 (10-01-09) IC RSS-210 Issue 7 1.5 FCC/IC Compliance This device complies with Part 15 of the FCC Rules and RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) this device may not cause interference and (2) this device must accept any interference, including interference that may cause undesired operation of the device. The user is cautioned that changes or modifications to the device that are not approved by the manufacturer could void the user’s authority to operate the device.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : Yes Author : Systems Administrator Create Date : 2010:12:20 12:57:54-07:00 Modify Date : 2010:12:20 12:58:12-07:00 XMP Toolkit : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04 Metadata Date : 2010:12:20 12:58:12-07:00 Creator Tool : Acrobat PDFMaker 9.1 for Word Format : application/pdf Title : CERTIFICATE OF COMPLIANCE Creator : Systems Administrator Document ID : uuid:4d06de6b-a75a-4370-b236-96a6397dc0a8 Instance ID : uuid:097b47de-d766-413c-a346-9ae659debf40 Producer : Adobe PDF Library 9.0 Page Count : 6EXIF Metadata provided by EXIF.tools