G4S Technology S680A S680 Proximity Card Reader User Manual

G4S Technology Limited S680 Proximity Card Reader

User Manual

1Mount the ReaderInstallation and User Instructions for S680 & S690 ReadersYou can remove the front cover by easing it off gently with a screwdriver at this point2Reader ConnectionsNote: (For UL Listed Products)1). Consult local AHJ (Authority Having Jurisdiction) when installing access control readers and locking mechanisms to any portal in an egress path.2). The use of Fail Closed / secure configuration shall be determined by local building codes and the local AHJ.3). Wiring methods shall be in accordance with NEC (National Electrical Code) ANSI/NFPA 70.4). All Interconnected devices must be UL listed.5). For UL294 Installations the S680 and S690 Readers have only been determined compatible to be used with the M2150 Series Control and Elevator Units.You should find that the backplate has holes for connection to most standard electrical back boxes.The S680 and S690 readers arereaders that are capable of reading HID format card, with LED’s. The readers use For additional information regarding the installation, configuration and proper use of this product please refer to:M2150 Design Guide, P/N 9600-0420 Issue 1.6.4 or later and SMS Software User Guide, P/N 9600-0429 Issue 7.0.4 or later. 125kHz proximity card ®20mA current loop communications.Mount the backplate using countersunk headed screws adjacent to the opening edge of the door.
Present the card face-on to the reader until you hear a "bleep". The reader is now working correctly. Cards canbe presented in rapid succession; there is no need, for example, to wait for "GREEN LED’s" to disappear before presenting another.When faulted, the reader can not accept a card read. Check wiring for faults or replace reader. 9600-0199. Installation and User Instructions for S680/690 Readers, Issue 2.0x1 5th November 2013. G4S Technology, 2013. FCC Notice: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Any unauthorized modification to this device may void the authority of the user to operate it. All trademarks acknowledged.©LED Status IndicatorGREEN – The lock is released and you may open the door.RED – You do not have access rights to gain entry, or the reader did not read your card properly (in this case, present it again).SpecificationsInput voltage: 12Vdc. Input current: 100mA Max. Operating temperature: -13 to 158°F (-25 to 70°C)Operating humidity: 90%, non-condensing.Maximum read range: 4" (100mm).Approvals: EN300330, EN3014894Using / Testing the Reader3Reader Connections contd.TX-RX+RX-680/690 Reader20mA current loopConnect shield at controller end only.Shielded Belden 9537 7x24 awg cable UL Listed style 2464 (DUZX) cable.Maximum distance 150m12V0VTX+RX-TX+TX-12V0VRX+ControllerNote: Brown wire not usedRedBlackGreenOrangeWhiteBlue

Navigation menu