G4S Technology S822 S822 Access Control Proximity Reader User Manual S822 User Instructions

G4S Technology Limited S822 Access Control Proximity Reader S822 User Instructions

S822 User Instructions

Installation and User Instructions for S822 Readers1Mount the BackplateTo mount the backplate:1) Detach the main body of the reader from thebackplate by releasing the two securing screwsalong the bottom edge of the reader.2) Mount the backplate adjacent to the opening edgeof the door and at a convenient height. Feed thecable to the reader through the backplate.The backplate has suitable holes for connection to most standard electrical backboxes.The S822 is a contactless smart-card reader, which usesp . TheS822 is able to read HID i smart cards, and thecard serial number on Philips MIFARE smart cards.For either type of card, the S822 supports the use ofunencoded cards (where only the unique card serialnumber is read). In the case of HID i cards, anencoded card number can be read. Encoding formatssupported include HID's own formats and the "smartMAX"format.CLASSCLASSTM20mA current loop seudo-random communications®®®
9600-0305. Installation and User Instructions for S822 Readers,Issue 1.0x10 18th November 2003. AMAG Technology, 2003.of HID Corporation.Philips and MIFARE are registered trademarks of PhilipsElectronics, NV.FCC Notice: This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions: (1) Thisdevice may not cause harmful interference, and (2) this devicemust accept any interference received, including interference thatmay cause undesired operation.Any unauthorized modification to this device may void theauthority of the user to operate it.All trademarks acknowledged. HID is a registered trademark ofHID Corporation. i is a trademarkCLASS©SpecificationsInput voltage: 9-14V.Input current: 100mA @ nominal 12Vdc supply.Operating temperature: -13 to 158 F (-25 to 70 C).Operating humidity: 15 to 90%, non-condensing.Maximum read range: 2.5" (65mm).Approvals: EN50133, R&TTE, IP656.°°3Using the ReaderPresent the card face-on to the reader until you hear a "bleep". If the green indicator is lit, the cardhas been accepted and the door is unlocked. If the red indicator is lit, either the card has not beenaccepted, or you do not have access through the door. If the read and green indicators flashalternatively, please wait.cards can be presented in rapid succession - there is no need to wait for the green or redLED to extinguish before presenting another card.Note:2Reader Connections20mA Current Loop Reader Connections0VConnect shield atcontroller end only(connect to case)Tx-Tx+Rx-Rx+12VController connections(20mA reader port)RedBlackWhiteBlueGreenOrangeNote: the brownwire is not usedReader

Navigation menu