Guangzhou Chiyuan Electronic HT8 Quadcopter RF Module User Manual Manual 2 2

Guangzhou Chiyuan Electronic Co.,Ltd Quadcopter RF Module Manual 2 2

Contents

Manual 2-2

98 ManualFf120 ManualFf1203. When moving the rudder stick left or right, the head of FF120 accordingly flies left or right.4. When moving the elevator stick up or down, the FF120 accordingly flies forward or backward.[END POINT]1 AILE 100% / 100%2 ELEV 100%/ 100%3 THRO 100%/ 100%4 RUDD 120%/ 120%5 GEAR 100%/100%[REVERSE]1 AILE NOR2 ELEV NOR3 THRO NOR4 RUDD REV5 GEAR NOR 2. Advice parameters to RF Module with FUTABA radio controllerFist, set FUTABA radio controller to Plane Mode, then adjust the radio controller to PPM transmitformat.FUTABA radio controller1. XC-IS2 Charger is suitable for 1 or 2 cell (3.7V) Li-ion or li-polymer battery. Please plug the pin of your battery into the jack of the XC-IS2 Charger.2.Please plug the pin of your battery into the jack of the USB first and then connect to the power. Otherwise, the LED may not become red and the voltage may be hight than 3.8V. You need to disconnect the USB power supply and reconnect it.3. When USB power supply is well connected and battery is charging, the LED will become red. After your battery is full charged, the LED will not become Green.6. Instruction for XC-IS2 Charger 7. Steps of flight7.1 Installation of battery packInstall the battery to the pack1. Install the battery pack in the battery compartment2. Connect the power cable of FF120 to receive signal from transmitter (1) Please followe this rules: "Open the radio first, connect the Quadcopter FF120 power last". After open the radio power button, please connect the FF120 power in 10S, the signal indicator light begins flashing, the light will solid after 1-3 seconds, and the four motor will self-checking rotation, then the receiver has received the signal of the radio successfully, binding finished. (2) If more than 10 seconds passed before the power cable was connected binding will fail.When binding fails, disconnect the battery.1. When moving the aileron stick left or right, the FF120 accordingly flies left or right.2. When moving the throttle stick up or down, the FF120 accordingly flies up or down.7.2 Matters needing attention 8.1 Flight in Normal StatusMode 1 (throttle stick at right hand)7.3 Trouble shooting a flashing receiver LED after connecting the power cable 8. Flight Control diagramPossible causes SolutionsCode paring failedThe throttle stick of transmitter is not at the lowest positionTurn transmitter off then on and re-connect Ff120 power cablePull down the throttle stick to the lowest position and re-code pairThe transmitter battery is low and empty Replace transmitter battery and re-codepair(re-bind)The FF120 battery is low and empty Replace the FF120 battery with a fresh pack and re-code pairNo function in receiver or transmitter Replace faulty receiver or transmitter and re-code pair
9. Steps of Ending flight10. Addition InstructionMode 1 (throttle stick at right hand) 1.Disconnect the power cable of FF120 2.Turn off the transmitter 3.Remove the battery clockwiseanticlockwise clockwise anticlockwise10 11 ManualFf120 ManualFf120frontbackleft right1. The front propellers are in orange color while the rear propellers are in black.2. After connecting the power of the FF120, left rear / right front blade rotates clockwise, left front / right rear blade rotates Counterclockwise.3. You can adjust the radio trim button(except the throttle trim) if the quadcopter flight drift. Mode2 (throttle stick at left hand)8.2 Roll flight practiceFf120 can finish excited stunts actions, such as the front and back, right and left rolls.Matters need to be attention when the first flight1. Choose a spacious ground with soft grass to practice.2. Select roll flight mode3. Advise beginner to increase servo distance of ELEV and AILE of the transmitter to 100%-110%. And can adjust according to personal skill level. The default setting is 100%.4. Practice of throttle stick: when FF120 roll from normal status, the throttle stick need to be pulled down slowly; push up the throttle when it exchanged normal status to roll. Please adjust according to personal skill level.1. When moving the aileron stick left or right, the FF120 accordingly flies left or right2. When moving the throttle stick up or down, the FF120 accordingly flies up or right3. When moving the rudder stick left or right, the head of FF120 accordingly flies left or right.4. When moving elevator stick up or down, the FF120 according flies forward or backward.1. When moving the aileron stick left or right, the FF120 accordingly rolls left or right..2. When moving the elevator stick up or down, the FF120 accordingly rolls forward or backward.Mode 2 (throttle stick at left hand)1. When moving the aileron stick left or right, the FF120 accordingly rolls left or right.2.When moving the elevator stick up or down, the FF120 accordingly rolls forward or backward.
12.Parts List ManualFf120 ManualFf12011.Exploding View12 1319482NO22QuantityPart Name 1344546272110111213 1441Quadcopter positive bladeQuadcopter positive motor φ7.0*20mmLi-po battery 3.7V 250mAh 25CQuadcopter pedestalQuadcopter receiver boardQuadcopter canopyQuadcopter screws ST 1.2*5PAQuadcopter pedestal plugQuadcopter inverted motor φ7.0*20mmQuadcopter screws ST 1.2x3PAQuadcopter motor pedestalQuadcopter inverted blade Quadcopter carbon fibre pipe 3x3x50712352644111010 1189121343214625101111 10
ManualFf120 ManualFf12014 1513.Accessories listOverall Length: 127.7mmOverall height: 36mmAll-up weight : 35gMain rotor blade Dia: 56mmOverall rotation Dia: 176mmBattery: 3.7V 250mAh 20cRadio controller: CY400Flight time: 6～7minQuadcopterF120FSpecifications and features:1. Adapt the newest stable six-axis system, high sensitivity and efficiency.2.Mini body design, light and anti-throw3. Stable flight, can realize front and back, left and right rollsSpecifications and FeaturesParts No:800045 Parts Name:Quadcopter pipesFF120 Parts No:800046 Parts Name:Quadcopter pedestalFF120 Parts No:800047 Parts Name: FF120 Quadcopter green positive inverted blade.Parts No:800048 Parts Name:Quadcopter motor pedestalFF120Parts No:800049 Parts Name:Quadcopter motor pedestal plugFF120 Parts No:800050 Parts Name:Quadcopter CanopyFF120 Parts No:800051 Parts Name:Quadcopter positive motorFF120 Parts No:800052 Parts Name:Quadcopter inverted motorFF120Parts No:800053 Parts Name:FF120 Quadcopter Li-po batteryParts No:800054 Parts Name: Quadcopter wireFF120 Parts No:800055 Parts Name: Quadcopter screws bagFF120 Parts No:800056 Parts Name: Quadcopter cross screwdriverFF120Parts No:800057 Parts Name:FF120Quadcopter transmitterParts No:800060 Parts Name:Quadcopter XC-1S2 ChargerFF120 Parts No:800061 Parts Name: Quadcopter CanopyFF120 Parts No:800058 Parts Name: Quadcopter receiver boardFF120Parts No:800087 Parts Name:Quadcopter positive motor accessoriesFF120 Parts No:800088 Parts Name:Quadcopter inverted motor accessoriesFF120 Parts No:800089 Parts Name: FF120 Quadcopter black positive inverted blade.Parts No:800090 Parts Name: FF120 Quadcopter orange positive inverted blade.
ManualFf12016FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.

Navigation menu