Guangzhou Chiyuan Electronic HT8 Quadcopter RF Module User Manual Manual 2 2

Guangzhou Chiyuan Electronic Co.,Ltd Quadcopter RF Module Manual 2 2

Contents

Manual 2-2

Download: Guangzhou Chiyuan Electronic HT8 Quadcopter RF Module User Manual Manual 2 2
Mirror Download [FCC.gov]Guangzhou Chiyuan Electronic HT8 Quadcopter RF Module User Manual Manual 2 2
Document ID1884108
Application IDJxtWeknYouydMB4Cec2aIA==
Document DescriptionManual 2-2
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize357.63kB (4470313 bits)
Date Submitted2013-01-22 00:00:00
Date Available2013-01-22 00:00:00
Creation Date0000-00-00 00:00:00
Producing Softwarecairo 1.10.2 (http://cairographics.org)
Document Lastmod0000-00-00 00:00:00
Document TitleManual 2-2
Document Creatorcairo 1.10.2 (http://cairographics.org)

REV
NOR
NOR
NOR
NOR
100% / 100%
100%/ 100%
100%/ 100%
120%/ 120%
100%/100%
1. Install the battery pack in the
battery compartment
7.1 Installation of battery pack
Install the battery to the pack
2. Connect the power cable of
FF120 to receive signal from
transmitter
7. Steps of flight
1. XC-IS2 Charger is suitable for 1 or 2 cell (3.7V) Li-ion or li-polymer battery.
Please plug the pin of your battery into the jack of the XC-IS2 Charger.
2.Please plug the pin of your battery into the jack of the USB first and then connect to
the power. Otherwise, the LED may not become red and the voltage may be hight than
3.8V. You need to disconnect the USB power supply and reconnect it.
3. When USB power supply is well connected and battery is charging, the LED will
become red. After your battery is full charged, the LED will not become Green.
6. Instruction for XC-IS2 Charger
FUTABA radio controller
1 AILE
2 ELEV
3 THRO
4 RUDD
5 GEAR
[REVERSE]
1 AILE
2 ELEV
3 THRO
4 RUDD
5 GEAR
[END POINT]
Fist, set FUTABA radio controller to Plane Mode, then adjust the radio controller to PPM transmit
format.
2. Advice parameters to RF Module with FUTABA radio controller
Ff120 Manual
Solutions
Replace faulty receiver or transmitter and re-code pair
Replace the FF120 battery with a fresh pack and
re-code pair
Replace transmitter battery and re-codepair(re-bind)
Pull down the throttle stick to the lowest position and
re-code pair
Turn transmitter off then on and re-connect Ff120
power cable
3. When moving the rudder stick left or right,
the head of FF120 accordingly flies left or
right.
1. When moving the aileron stick left or right,
the FF120 accordingly flies left or right.
Mode 1 (throttle stick at right hand)
8.1 Flight in Normal Status
4. When moving the elevator stick up or
down, the FF120 accordingly flies forward
or backward.
2. When moving the throttle stick up or down,
the FF120 accordingly flies up or down.
8. Flight Control diagram
No function in receiver or transmitter
The FF120 battery is low and empty
The transmitter battery is low and empty
The throttle stick of transmitter is not at
the lowest position
Code paring failed
Possible causes
7.3 Trouble shooting a flashing receiver LED after connecting the power cable
7.2 Matters needing attention
(1) Please followe this rules: "Open the radio first, connect the Quadcopter FF120
power last". After open the radio power button, please connect the FF120 power in 10S,
the signal indicator light begins flashing, the light will solid after 1-3 seconds, and the
four motor will self-checking rotation, then the receiver has received the signal of the
radio successfully, binding finished.
(2) If more than 10 seconds passed before the power cable was connected binding will
fail.When binding fails, disconnect the battery.
Ff120 Manual
4. When moving elevator stick up or down,
the FF120 according flies forward or
backward.
3. When moving the rudder stick left or right,
the head of FF120 accordingly flies left or
right.
10
1. When moving the aileron stick left or right,
the FF120 accordingly rolls left or right..
Mode 1 (throttle stick at right hand)
2. When moving the elevator stick up or down,
the FF120 accordingly rolls forward or
backward.
1. Choose a spacious ground with soft grass to practice.
2. Select roll flight mode
3. Advise beginner to increase servo distance of ELEV and AILE of the transmitter to
100%-110%. And can adjust according to personal skill level. The default setting is
100%.
4. Practice of throttle stick: when FF120 roll from normal status, the throttle stick need to
be pulled down slowly; push up the throttle when it exchanged normal status to roll.
Please adjust according to personal skill level.
8.2 Roll flight practice
Ff120 can finish excited stunts actions, such as the front and back, right and
left rolls.
Matters need to be attention when the first flight
2. When moving the throttle stick up or down,
the FF120 accordingly flies up or right
1. When moving the aileron stick left or right,
the FF120 accordingly flies left or right
Mode2 (throttle stick at left hand)
Ff120 Manual
2.When moving the elevator stick up or
down, the FF120 accordingly rolls
forward or backward.
3.Remove the battery
left
back
front
right
anticlockwise
clockwise
11
1. The front propellers are in orange color while the rear propellers are in black.
2. After connecting the power of the FF120, left rear / right front blade rotates clockwise,
left front / right rear blade rotates Counterclockwise.
3. You can adjust the radio trim button(except the throttle trim) if the quadcopter flight
drift.
clockwise
2.Turn off the transmitter
10. Addition Instruction
anticlockwise
1.Disconnect the power
cable of FF120
9. Steps of Ending flight
1. When moving the aileron stick left or right,
the FF120 accordingly rolls left or right.
Mode 2 (throttle stick at left hand)
Ff120 Manual
4
12
10
11
Ff120 Manual
10
12
11
13
11
11
10
11.Exploding View
10
13
12
11
10
Li-po battery 3.7V 250mAh 25C
Quadcopter pedestal
Quadcopter carbon fibre pipe 3x3x50
Quadcopter receiver board
Quadcopter screws ST 1.2x3PA
Quadcopter screws ST 1.2*5PA
Quadcopter canopy
Quadcopter positive motor φ7.0*20mm
Quadcopter positive blade
Quadcopter pedestal plug
Quadcopter inverted motor φ7.0*20mm
Quadcopter motor pedestal
Quantity
Quadcopter inverted blade
Part Name
NO
12.Parts List
13
Ff120 Manual
13.Accessories list
14
Parts No:800087 Parts Name: FF120
Quadcopter positive motor accessories
Parts No:800088 Parts Name: FF120
Quadcopter inverted motor accessories
Quadcopter black positive inverted blade.
Quadcopter orange positive inverted blade.
Parts No:800089 Parts Name: FF120 Parts No:800090 Parts Name: FF120
Parts No:800057 Parts Name: FF120 Parts No:800060 Parts Name: FF120 Parts No:800061 Parts Name:FF120 Parts No:800058 Parts Name: FF120
Quadcopter transmitter
Quadcopter XC-1S2 Charger
Quadcopter Canopy
Quadcopter receiver board
Quadcopter Li-po battery
Parts No:800053 Parts Name: FF120 Parts No:800054 Parts Name: FF120 Parts No:800055 Parts Name: FF120 Parts No:800056 Parts Name: FF120
Quadcopter wire
Quadcopter screws bag
Quadcopter cross screwdriver
Quadcopter motor pedestal plug
Parts No:800049 Parts Name: FF120 Parts No:800050 Parts Name: FF120 Parts No:800051 Parts Name: FF120 Parts No:800052 Parts Name: FF120
Quadcopter Canopy
Quadcopter positive motor
Quadcopter inverted motor
Parts No:800045 Parts Name: FF120 Parts No:800046 Parts Name: FF120 Parts No:800047 Parts Name: FF120 Parts No:800048 Parts Name: FF120
Quadcopter green positive inverted blade. Quadcopter motor pedestal
Quadcopter pipes
Quadcopter pedestal
Ff120 Manual
1. Adapt the newest stable six-axis system, high sensitivity and efficiency.
2.Mini body design, light and anti-throw
3. Stable flight, can realize front and back, left and right rolls
Overall Length: 127.7mm
Overall height: 36mm
All-up weight : 35g
Main rotor blade Dia: 56mm
Overall rotation Dia: 176mm
Battery: 3.7V 250mAh 20c
Radio controller: CY400
Flight time: 6~7min
Specifications and features:
Specifications and Features
Quadcopter
F F120
15
Ff120 Manual
16
Ff120 Manual
other antenna or transmitter.
This device and its antenna(s) must not be co-located or operating in conjunction with any
accept any interference received, including interference that may cause undesired operation.
conditions: (1) This device may not cause harmful interference, and (2) this device must
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
for compliance could void the user's authority to operate this equipment.
FCC Caution: Any changes or modifications not expressly approved by the party responsible

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
Page Count                      : 5
Creator                         : cairo 1.10.2 (http://cairographics.org)
Producer                        : cairo 1.10.2 (http://cairographics.org)
EXIF Metadata provided by EXIF.tools
FCC ID Filing: V6KHT8

Navigation menu