HBC radiomatic P10004 Crane Remote Control Transmitter User Manual 1521 statement page

HBC-radiomatic GmbH Crane Remote Control Transmitter 1521 statement page

Contents

1521 statement page

Operating Instructions
Radio Transmitter patrol ( Industrial Version )
BEPATRIUS-L.DOC [ Word 97 ] FL Page 6 / 14
HBC-radiomatic, Inc. , Cincinnati , Ohio 45242 , USA
HBC-radiomatic reserves the right to alter or amend the above information without any notice. 2001-09-13
Radio Remote Control S
y
stem
2.2 Safety Notes Regarding Operation
➪ Warning to our Users :
In accordance to the rules and regulations of the FCC, any changes or
modifications made to our transmitter or receiver by you without the express
written consent of HBC-radiomatic, Inc. could void your authority to operate the
equipment under FCC’s rule 15.21 !
➪ Before using the radio control system for the first time, read these operating
instructions completely and carefully.
➪ In case of a defect, an emergency situation and whenever a malfunction occurs in
the working area of the radio system, it is required to de-energize the radio
equipment immediately until the cause of the fault has been located and repaired !
− Switch OFF the transmitter via the EMERGENCY-STOP pushbutton.
− Disconnect the connecting cable from the receiver.
➪ During breaks and at the end of work, disconnect the transmitter by means of the
key switch or the EMERGENCY-STOP pushbutton.
➪ Be cautious when working with the radio control. – When using the radio control,
choose a stable location from which you can see the entire working area.
➪ Usage of radio remote control systems outside of manufacturer’s guidelines
(section 3) may result in invalidity of the guarantee.
2.3 Safety Notes when Operating the Transmitter
➪ Before you start working, always verify the operation of the EMERGENCY-STOP
pushbutton.
➪ It is not allowed to leave a connected transmitter and not supervise it.
➪ In case of an emergency and in case of all sorts of problems in the working range
of the machinery or in case of a technical failure of the radio control, you must
stop the crane or machine by pressing the EMERGENCY-STOP pushbutton !
➪ During breaks and at the end of work, disconnect the transmitter by means of the
"ON / OFF" toggle switch.
➪ The operation of the transmitter is permissible only with the carrying set included
with the transmitter (possibility of mixing up the controls) !

Navigation menu