HID Global 0006A Proximity Reader User Manual 5395 902 manual

Download:
Mirror Download [FCC.gov]
Document ID	118376
Application ID	zD0aUUvsYIrIlIzWYkWUYA==
Document Description	5395 902 manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Microsoft Word - pdf
Filesize	6.27kB (78337 bits)
Date Submitted	2000-09-22 00:00:00
Date Available	2000-09-11 00:00:00
Creation Date	2000-09-22 16:53:09
Producing Software	Acrobat Distiller 4.0 for Windows
Document Lastmod	2000-09-22 16:53:11
Document Title	5395 902 manual

REV
DESCRIPTION
DATE
REVISED PER EO #E5395-15
APPROVED
NOTE: Cover sheet is for Revision Control only, and is not to be sent with document.
REV
SHEET
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
59
50
51
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
REV STATUS
OF SHEETS
10
11
12
13
14
15
REV
SHEET
TOLERANCES
APPROVALS
DATE
HID CORPORATION
.XX = +/- .03”
DWN E. DeQuiroz
081597
IRVINE, CALIFORNIA
.XXX = +/- .010”
CHK
GRIFFIN
082297
Installation Manual,
ANGLES = +/- 1°
APVD OKUDA
082297
ThinLine II Reader
MATERIAL N/A
APVD SIMPSON
082297
FINISH N/A
SCALE N/A
THIS DOCUMENT CONTAINS PROPRIETARY
INFORMATION. IT MAY NOT BE DISCLOSED TO
OTHERS OR USED FOR MANUFACTURING
PURPOSES WITHOUT THE PERMISSION OF HID
CORPORATION.
P/N
SIZE
5395-902
REV D
SHEET 0 OF 3
Install Manual – 5395-902 Rev D
ThinLine IITM Installation Manual
_____________________________________________________________________________________________________
HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL (949) 598-1600 (800) 237-7769 FAX (949) 598-1690
Web page, E-mail - www.hidcorp.com - ThinLine II Installation Manual 5395-902 Rev D
1 of 3
PARTS LIST (Included)
Quantity
Connecting the Reader to the Host
- THINLINE II Reader with snap-on cover and 18”
cable
- #6-32 x 1” self-tapping panhead screw
- Installation manual
PARTS LIST (Not-Included)
Quantity
- Wire splice
- DC Power supply 5.0 VDC or 12 VDC
Mounting Instructions
• Determine an appropriate mounting location. The
reader may be mounted to any surface, including
metal.
• Drill two (2) 3/32-inch (2.5mm) holes approximately
1 inch deep for mounting the reader.
• Drill a 5/8-inch (16mm) hole for the cable.
• Remove the snap-on cover from the reader and
secure the reader to the mounting surface.
• Route the cable from the reader and/or power
supply to the host. A linear type power supply is
recommended. Check all electrical codes for proper
cable installation.
• For best operation, the drain wire should be
disconnected at the power supply end of the cables.
• For the cable connection to the Panel - Use Alpha
#1299C or equivalent.
• Test the operation of the reader. After completion of
the test, replace the snap-on cover.
• See sheet 3 of this manual for the appropriate
dimensioned drawings.
Connect the reader to the host according to the wiring
table below and the host installation guide.
Wiegand
Clock & Data
Wire Color
+DC
+DC
Red
Ground
Ground
Black
Data0
Data
Green
Data1
Clock
White
Shield Ground
Shield Ground
Drain
Green LED
Green LED
Orange
Red LED
Red LED
Brown
Beeper
Beeper
Yellow
Hold
Hold
Blue
--Card Present
Violet
Testing and Operation
_____________________________________________________________________________________________________
HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL (949) 598-1600 (800) 237-7769 FAX (949) 598-1690
Web page, E-mail - www.hidcorp.com - ThinLine II Installation Manual 5395-902 Rev D
2 of 3
• When power is applied to the reader the LED will
flash green three (3) times while the beeper beeps
simultaneously. The LED will then turn red. This
indicates that the microcontroller is operating
properly.
• Present an ID card to the reader. The LED will
momentarily turn green while the beeper beeps
once, indicating that the card was read successfully.
Important Product Specifications
Power requirements (linear supply)
Operating Voltage Range
5.0 – 16.0 VDC
Absolute Maximum Voltage
18 VDC
Peak Current
80 Ma
Average Current 5V or 12V
20 Ma
Maximum cable distance
To host
500 ft (153 m)
FCC Compliance Statement: This device complies with
part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept
any interference received, including interference that
may cause undesired operation.
_____________________________________________________________________________________________________
HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL (949) 598-1600 (800) 237-7769 FAX (949) 598-1690
Web page, E-mail - www.hidcorp.com - ThinLine II Installation Manual 5395-902 Rev D
3 of 3
Front, side, and back view
Figure 1
_____________________________________________________________________________________________________
HID Corporation 9292 Jeronimo Road Irvine, CA 92618-1905 USA TEL (949) 598-1600 (800) 237-7769 FAX (949) 598-1690
Web page, E-mail - www.hidcorp.com - ThinLine II Installation Manual 5395-902 Rev D
4 of 3

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : Yes
Create Date                     : 2000:09:22 16:53:09
Producer                        : Acrobat Distiller 4.0 for Windows
Modify Date                     : 2000:09:22 16:53:11-04:00
Page Count                      : 5

EXIF Metadata provided by EXIF.tools