HWM Water 553 USB Transceiver User Manual User Guide

HWM-Water Ltd USB Transceiver User Guide

User Guide

HWM Water Ltd Ty Coch House Llantarnam Park Way Cwmbran NP44 3AW UK DDI:+44 (0)1633 627842 Tel: +44 (0)1633 489479 USB Transceiver Quick Start Guide This guide covers only the most basic operaons. For other features and more details, see www.hwmglobal.com Part number : MAN-553-0003-A If further support or assistance is required, please contact HWM Technical Support on 01633 489479 or e-mail cservice@HWM-Water.com 2. SETUP INSTRUCTIONS 1. Aach antenna. 2. Insert USB into computer. 3. LEDs will illuminate. 3. INSTALLATION For maximum transmission range the antenna of the transmier should point upward (vercal polarizaon) and should be kept clear of obstrucons, parcularly metallic surfaces. Do not expose the USB Transceiver to moisture. USB TRANSCEIVER QUICK START GUIDE This guide covers only the most basic operaons including connecons and commissioning. 1. INTRODUCTION The USB Transceiver is a setup and conguraon tool for various HWM devices. Please refer to your main product guide for more details. HWM reserves the right to change any product specicaon without prior noce.
Warranty All equipment is warranted by HWM-Water Ltd to be free from defect in materials and workmanship under normal use for a period of one year from the data shipped to the original customer. This warranty in only valid if the equip-ment: 1. is properly installed and operated under condions of normal use in accordance with HWM’s published instrucons set out in the manual; 2. is operated in compliance with federal, state, county and local codes and, 3. is operated in accordance with standard industry pracces. 4. As the exclusive remedy for any breach of warranty, HWM will repair or replace (at HWM’s opon) the non-conforming equipment. HWM shall have no liability for incidental, special, punive or consequenal damages arising from any defect in, or malfuncon of, the equipment to any party. This warranty does not cover any costs incurred for the removal or installaon of equipment. If any problems occur, you should nofy HWM or its authorised representave, giving full details of the problem, the model and serial numbers of the equipment and the HWM invoice number the equipment was shipped against. You will receive technical advise and / or shipping instrucons depending on the nature of the problem. If the problem cannot be resolved you will be issued with an RMA number and a return address label so that the products can be shipped back to HWM for inspecon. Once we have reviewed and conrmed that the product is in warranty, we will contact you to conrm what acon we will be taking to resolve the issue. All warranty and service acvity must be undertaken by an authorised representave of HWM. The express warranty is in-lieu of all other representaons or warranes, express, implied or statutory and spe-cically excludes and warranty of merchantability or tness for a parcular purpose. There are no warranes that extend beyond the descripon on the face hereof. No pares or aliates can make any warranty, promises or representaons either wrien or oral to the quality of products other than what is set out herein. WARNINGS: FCC warning statement: This device complies with Part 15 of the FCC Rules. Operaon is subject to the following two condions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operaon. This equipment complies with FCC radiaon exposure limits set forth for an uncontrolled environment. End users must follow the specic operang instrucons for sasfying RF exposure compliance. This transmier must not be co-located or operang in conjuncon with any other antenna or transmier. Changes or modicaons not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment Under Industry Canada regulaons, this radio transmier may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmier by Industry Canada. To reduce potenal radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communicaon. This device complies with Industry Canada licence-exempt RSS standard(s). Operaon is subject to the following two condions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operaon of the device. Conformément à la réglementaon d'Industrie Canada, le présent émeeur radio peut fonconner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émeeur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l'intenon des autres ulisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une communicaon sasfaisante. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitaon est autorisée aux deux condions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'ulisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est suscepble d'en compromere le fonconnement. 4. OPERATION Power Receiving from antenna Ready Transming from antenna Antenna USB Communicang with PC—in / out  ‘Power’ LED indicates device is plugged in to the PC and is on.  ‘Ready’ shows that the device is not currently performing an acon, so is available to start receiving or transming.  ‘Receiving’ and ‘Transming’ LEDs show the device is communicang with the target device.  The ‘Communicang’ LEDs indicate that the device is communicang with the PC; Red = data in to the PC, Green = data from the PC. SIMPLIFIED DECLARATION OF CONFORMITY This simplied EU declaraon of conformity referred to in arcle 10(9) shall be provided as follows: Hereby, HWM Ltd declares that the radio equipment type transceiver is in compliance with Direcve 2014/53/EU. The full text of the EU declaraon of conformity is available at www.hwmglobal.com

Navigation menu