Honda Lock Mfg HLIK-1R Part 15 Remote Security Transmitter User Manual

Download:
Mirror Download [FCC.gov]
Document ID	653716
Application ID	RbNt4VVzqoavktI8klwhug==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	9.41kB (117604 bits)
Date Submitted	2006-05-03 00:00:00
Date Available	2006-08-01 00:00:00
Creation Date	2006-03-27 11:37:34
Producing Software	Acrobat Distiller 4.05 for Macintosh
Document Lastmod	2006-04-10 18:30:34
Document Title	User Manual

０５／０５／２６
１７：１７：３５
３１ＳＮＡ６００
００７９
Immobilizer System
The immobilizer system protects
your vehicle from theft. If an
improperly-coded key (or other
device) is used, the engine’s fuel
system is disabled.
The system may not recognize your
key’s coding if another immobilizer
key or other metal object (i.e. key
fob) is near the ignition switch when
you insert the key.
When you turn the ignition switch to
the ON (II) position, the immobilizer
system indicator should come on
briefly, then go off. If the indicator
starts to blink, it means the system
does not recognize the coding of the
key. Turn the ignition switch to the
LOCK (0) position, remove the key,
reinsert it, and turn the ignition
switch to the ON (II) position again.
If the system repeatedly does not
recognize the coding of your key,
contact your dealer.
As required by the FCC:
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.
Do not attempt to alter this system
or add other devices to it. Electrical
problems could result that may make
your vehicle undriveable.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s
authority to operate the equipment.
If you have lost your key and cannot
start your engine, contact your
dealer.
This device complies with Industry
Canada Standard RSS-210.
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must
accept any interference that may cause
undesired operation of the device.
76
06/03/20 16:43:07 32SDRT00_089
Remote Transmitter
4. Remove the old battery from the
back of the inner cover, and insert
a new battery into the back of the
cover with the ＋ side facing down.
5. Install the parts in reverse order.
An improperly disposed battery
can hurt the environment.
Always confirm local regulations
for battery disposal.
Chinese Regulations for Controlling
Short Range Radio Equipment
Keyless Entry Function
Modulation Mode: FSK
Frequency Range: 313−314 MHz
Transmitting Power: ≦6000 V/m (3
m)
Occupied Bandwith: ≦300 kHz
Spurious Emission Limits: ≦600 V/m
(3 m)
The user shall not change the
transmission frequency, amplify the
output capacity by such means as
installing a transmission amplifier,
install another aerial, or replace the
original transmission aerial without
permission of the Authority.
The equipment shall not cause any
harmful interference with various
authorized radio communication. If
such interference is detected,
operation of the equipment shall be
suspended until a measure is taken to
remove such interference.
84
Instruments and Controls
When using radio equipment with
very small output capacity, the
equipment must accept any
interference caused by the emission
of various radio communication
equipment as well as industrial,
scientific and medical facilities.
Use of such radio equipment is
prohibited in an aeroplane and around
an airport.
０５／０５／２６
１７：１９：２４
３１ＳＮＡ６００
００９０
Remote Transmitter
BATTERY
TAB
3. Inside the transmitter, separate
the inner cover from the keypad
by releasing the two tabs on the
cover.
4. Remove the old battery from the
back of the inner cover, and note
the polarity. Make sure the
polarity of the new battery is the
same (＋ side facing down), then
insert it into the back of the cover.
Instruments and Controls
As required by the FCC:
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s
authority to operate the equipment.
This device complies with Industry
Canada Standard RSS-210.
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must
accept any interference that may cause
undesired operation of the device.
5. Install the parts in reverse order.
87

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Modify Date                     : 2006:04:10 18:30:34+09:00
Create Date                     : 2006:03:27 11:37:34+09:00
Page Count                      : 4
Has XFA                         : No
Mod Date                        : 2006:04:10 18:30:34+09:00
Creation Date                   : 2006:03:27 11:37:34+09:00
Producer                        : Acrobat Distiller 4.05 for Macintosh
Metadata Date                   : 2006:04:10 18:30:34+09:00

EXIF Metadata provided by EXIF.tools