INID NGRPAOLF RFID Reader User Manual INID docs v6

Download:
Mirror Download [FCC.gov]
Document ID	1664893
Application ID	U8zMo/L1hDMbb+R7qazCYg==
Document Description	module installation instructions
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	23.93kB (299108 bits)
Date Submitted	2012-03-28 00:00:00
Date Available	2012-03-29 00:00:00
Creation Date	2012-03-20 14:50:44
Producing Software	OpenOffice.org 3.2
Document Lastmod	0000-00-00 00:00:00
Document Title	INID-docs-v6
Document Creator	Writer
Document Author:	Mark Olde

NGRP-AOLF Installation manual
DISCLAMER:
This procedure is only allowed by
personnel trained and authorized by
INID.
10.
Replace the electronics cover over the
four pins with the square opening over
the tamper sensor near pin 1 of the
8 pin connector.
11.
Replace and tighten the four
electronics cover screws in the reverse
order listed in step 4. Avoid excessive
force to prevent damage to the
housing and screw posts.
Connect power to the reader, load the
parameters for the low frequency
module and perform a functionality
test with the appropriate ISO14443
and low frequency proximity cards.
The reader will beep on a successful
card read.
Add additional product label:
Prerequisites:
Perform these actions on a workbench in a
suitable location. Take appropriate measures
against ESD damages of the equipment.
Always disconnect the power supply of the
unit.
Step by step instructions
1.
Place the reader with it's front on the
workbench.
2.
Remove the backplate if present.
3.
Ensure the power to the reader is
disconnected – remove the eight pin
connector from the reader if any wires
are connected to it.
4.
Remove the four screws that keep the
electronics cover on the reader in the
order specified:
12.
13.
5.
6.
Remove the electronics cover.
Remove the printed circuit board from
the reader.
7. Fit the NGRP-AOLF module on the
reader printed circuit board. Pay
attention to the correct orientation:
8.
9.
14.
Remount or repackage the reader with
the appropriate labels.
Make sure that all pins are properly
lined up and inserted:
Place the reader printed circuit board
with the NGRP-AOLF module back in
the reader enclosure.
INID BV
Mariettahof 27
2033 WS Haarlem
The Netherlands
T: +31 (0)23 53 35 420
F: +31 (0)23 53 53 096
E: info@inid-reader.com
W: www.inid-readers.com
NGRP-AOLF installation manual v1.01 march 2012 (c) INID BV All rights reserved

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Page Count                      : 1
Language                        : en-US
Tagged PDF                      : Yes
Part                            : 1
Conformance                     : A
Title                           : INID-docs-v6
Creator                         : Mark Olde
Producer                        : OpenOffice.org 3.2
Creator Tool                    : Writer
Create Date                     : 2012:03:20 14:50:44+01:00
Author                          : Mark Olde

EXIF Metadata provided by EXIF.tools