InnoSenT IPQ05R05 Stereo K-Band Transceiver Module User Manual IPQ 05 Rev 05
InnoSenT GmbH Stereo K-Band Transceiver Module IPQ 05 Rev 05
InnoSenT >
User Manual
Innovation in radar sensing Making happen what others only dream of _____________________________________________________________________________________________________ USER MANUAL Product Family: Range of use: K-Band Transceiver advanced door applications Module Number: IPQ-05_Rev.05 _____________________________________________________________________________________________________ Description: Basic Features IPQ-05_Rev.05 radar-based motion detector centered @ 24.125 GHz advanced PHEMT-oscillator with low current consumption split transmit and receive path for maximum gain stereo (dual channel) operation for direction of motion identification integrated IF-pre-amplifier enable input for oscillator shut down small outline dimensions two electronically selectable antenna patterns EN 61508:2001 certification requires that the transceiver is built into a housing rated 0. min. IP20 for indoor use 1. min. IP54 for outdoor use Electrical Characteristics Parameter transmit frequency output power (EIRP) temperature drift I/Q balance IF-output IF-amplifier 1 switching voltage 2 supply voltage supply current threshold for enable input 3 turn-on time oscillator turn-off time oscillator Symbol ftransmit Pout ∆f amplitude phase voltage offset gain typ. 24.125 15 -1 60 1.0 90 max. 24.175 20 120 4.0 23 units GHz dBm MHz/°C dB ° dB bandwidth DC 220 * kHz high level low level VCC ICC min off max on ton toff GND 4.75 5.5 0.5 5.25 50 mA µs µs step response operating temperature outline dimensions min. 24.075 VCC-0.2 5.0 35 0.5 0.5 40 TOP - 20 ~ 40 x 25 x 24 mV + 60 °C mm comment * typical upper frequency limit narrow antenna pattern broad antenna pattern absolute value (Delta S1)+ absolute value (DeltaS2) Output-Impedance Rout(IF1, IF2) = 100 Ω no Pullup or Pulldown-Resistor Internal Pullup-Resistor with 10kΩ Innovation in radar sensing Making happen what others only dream of 1 von 3 USER MANUAL IPQ-05_Rev.05 2008-05-19 Version 1.0 Innovation in radar sensing Making happen what others only dream of Antenna Characteristics (radiation pattern) Rx1 Tx Rx2 vertical horizontal Parameter antenna pattern Tx (3dB) antenna pattern Tx (10dB) side lobe suppression Tx antenna pattern Rx1 (3dB) antenna pattern Rx1 (10dB) side lobe suppression Rx1 antenna pattern Rx2 (3dB) antenna pattern Rx2 (10dB) side lobe suppression Rx Symbol horizontal vertical horizontal vertical horizontal vertical horizontal vertical horizontal vertical horizontal vertical horizontal vertical horizontal vertical horizontal vertical min. typ. 76 35 135 62 max. 76 35 135 62 49 40 89 69 13 13 13 13 13 13 units ° ° ° ° dB dB ° ° ° ° dB dB ° ° ° ° dB dB comment azimuth elevation azimuth elevation azimuth elevation azimuth elevation azimuth elevation azimuth elevation azimuth elevation azimuth elevation azimuth elevation Interface The sensor provides a 2 mm pitch 6 pin connector Molex 51004-0600. Pin # Description enable VCC GND IF1 IF2 switch In/Out input input input output output input Comment active low supply voltage (+5 V) analog ground Signal I(nphase) Signal Q(uadrature) mates with: Molex P/N 53014, 53015 and 53025 Mechanical Outlines all dimensions in mm for details compare with drawing 41-1190.42 Innovation in radar sensing Making happen what others only dream of 2 von 3 USER MANUAL IPQ-05_Rev.05 2008-05-19 Version 1.0 Innovation in radar sensing Making happen what others only dream of I/Q-Definition Signal Q is leading if an object moves towards the radar transceiver. Certification and Environment Protection InnoSenT GmbH has established and applies a quality system for: Development, production and sales of radar sensors for commercial and industrial sensors An audit was performed, Report No. 010350 Proof has been furnished that the requirements according to DIN EN ISO 9001:2000 are fulfilled. This InnoSenT product is compliant to the restriction of hazardous substances (RoHs – European Union directive 2002/95/EG). FCC-Approval • This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. • Warning: Changes or modifications made to this equipment not expressly approved by InnoSenT GmbH may void the FCC authorization to operate this equipment. • Manufacturers of mobile or fixed devices incorporating IPQ-05 modules are authorized to use the FCC Grants and IC Certificates of the IPQ-05 modules for their own final products according to the conditions referenced in these documents. In this case, the FCC label of the module shall be visible from the outside, or the host device shall bear a second label stating "Contains FCC ID: UXS-IPQ05R05" and "Contains IC: 6902A-IPQ05R05". Contact Information: InnoSenT GmbH Am Roedertor 30 97499 Donnersdorf Germany Phone: +49 (0) 9528-9518-0 Fax: +49 (0) 9528-9518-99 E-Mail: info@InnoSenT.de Web: www.InnoSenT.de Innovation in radar sensing Making happen what others only dream of 3 von 3 USER MANUAL IPQ-05_Rev.05 2008-05-19 Version 1.0
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : No Page Count : 3 Producer : GNU Ghostscript 7.06 Author : Zirk_Andreas Create Date : 2008:05:20 15:41:37 Creator : PDFCreator Version 0.8.0 Modify Date : 2008:05:20 15:41:37 Subject : Title : IPQ-05_Rev.05 User ManualEXIF Metadata provided by EXIF.tools