Intermec Technologies 2610CF 2610CF User Manual 6632 1 page fcc

Intermec Technologies Corporation 2610CF 6632 1 page fcc

Compliance Insert

Compliance Statement Insert
Device Name: Data Collection Computer Model Number: CN2B
The responsible party for the compliance of this device is: Intermec Technologies Corporation
6001 36th Avenue West
Everett, WA 98203 USA
(425) 348-2600
This product conforms to the following approvals. The user(s) of this product are cautioned to use accessories and peripherals approved by
Intermec Technologies Corporation. The use of accessories other than those recommended, or changes to this product that are not approved by
Intermec Technologies Corporation, may void the compliance of this product and may result in the loss of the users authority to operate the
equipment.
FCC Digital Emissions Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the radio or television receiving antenna.
Increase the separation between the computer equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the radio or television receiver is connected.
Consult the dealer or an experienced radio television technician for help.
15.19(a)(3)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.
Canadian Digital Apparatus Compliance
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
Radio Wave Exposure and Specific Absorption Rate (SAR) Information for Model CN2B
The Model CN2B Mobile Computer has been designed to comply with applicable safety requirements for exposure to radio waves. These requirements are based on
scientific guidelines that include safety margins designed to assure the safety of all persons, regardless of age and health. The radio wave exposure guidelines employ a unit
of measurement known as the Specific Absorption Rate or SAR. Tests for SAR are conducted using standardized methods with the device transmitting at its highest
certified power level. While there may be difference between the SAR levels of various products, they are all designed to meet the relevant guidelines for exposure to the
radio waves.
This radio has been tested and meets the FCC RF exposure guidelines when used with the Intermec accessories supplied or designated for this product. Use of other
accessories may not ensure compliance with the FCC RF exposure guidelines. The highest SAR value for the CN2B Mobile Computer, as tested by Compliance
Certification Services, for single or collocated configuration is 0.442 W/kg.
Compliance Battery Recycling Information
This product contains a lithium ion (Li-ion) main battery. When the battery reaches the end of its useful life, the spent battery
should be disposed of by a qualified recycler or hazardous materials handler. Do not mix this battery with the solid waste stream.
Contact your Intermec Technologies Service Center for recycling or disposal information.
This product contains a Nickel Metal Hydride (NiMH) backup battery. When the battery reaches the end of its useful life, the
spent battery should be disposed of by a qualified recycler or hazardous materials handler. Do not mix this battery with the solid
waste stream. Contact your Intermec Technologies Service Center for recycling or disposal information.
Note: In the U.S., the EPA does not consider spent Li-ion or NiMH batteries as hazardous waste.
NiMH
NiMH
578-100-138 Revision A Page 1 of 3
*578-100-138A*
*578-100-138A*
578-100-138 Revision A Page 2 of 3
*578-100-138A*
*578-100-138A*
DECLARATION OF CONFORMITY
(According to ISO/IEC Guide 22 and EN 45014)
PAGE ONE OF ONE
THE PRODUCT HEREWITH COMPLIES WITH THE REQUIREMENTS OF :
THE LOW-VOLTAGE DIRECTIVE 73/23/EEC.
THE EMC DIRECTIVE 89/336/EEC.
THE R&TTE DIRECTIVE 1999/05/EC.
Manufacturer’s Name: European Representative:
Intermec Technologies Corporation Intermec International Incorporated
6001 36th Avenue West Sovereign House, Vastern Road
Everett, WA 98203 Reading, Berkshire
RG1 8BT England
Declares that the product listed below:
Product Type: ITE/Residential, Commercial, and Light Industrial
Product Name: CN2B
Model Number: CN2B Options: All
Beginning Serial Number: All Date Issued: December 23, 2005
Conforms to the following product specifications:
Safety: IEC 60950-1 / EN 60950-1
IEC 60825-1 / EN 60825-1 Class 1 LED Product
EMC: EN 55022 : 1998 / CISPR Publication 22 : 1997, Class B Limits and Methods
EN 55024 : 1998 (CISPR 24) Information Technology Equipment – Immunity Characteristics –
Limits and Methods of Measurement
EN61000-3-2 : 1995 + A1 : 1998 + A2 : 1998 + A14 : 2000 – Harmonic Current Emissions
EN61000-3-3 : 1994 – Voltage Fluctuation and Flicker
ETSI EN 301 489-17
Radio: ETSI EN 300 328-2
I, the undersigned, hereby declare that the equipment specified above conforms to the above Directive(s) and
Standard(s).
Company Official: Michael Abel Position: Vice President
Signature: Signed Copy on File Date: _23-DEC-2005_______
European Contact: Intermec International Incorporated, Sovereign House, Vastern Road, Reading, Berkshire, RG1 8BT England;
Phone INT+44 118 987 9400; Fax INT+44 118 987 9401
578-100-138 Revision A Page 3 of 3
*578-100-138A*
*578-100-138A*
PROHLÁŠENÍ O DODRŽOVÁNÍ TECHNICKÝCH NAŘÍZENÍ
(V souladu se směrnicí 22 ISO/IEC a EN 45014)
STRÁNKA JEDNA Z JEDNÉ STRÁNKY
ZDE UVEDENÝ VÝROBEK SPLŇUJE POŽADAVKY:
SMĚRNICE 73/23/EEC PRO NÍZKONAPĚŤOVÁ ZAŘÍZENÍ
SMĚRNICE EMC 89/336/EEC
SMĚRNICE R&TTE 1999/05/EC
Jméno výrobce: Evropský zástupce:
Intermec Technologies Corporation Intermec International Incorporated
6001 36th Avenue West Sovereign House, Vastern Road
Everett, WA 98203, USA Reading, Berkshire
RG1 8BT England
prohlašuje, že níže uvedený výrobek:
Typ výrobku: Vybavení informační technologie/rezidenční, komerční a lehké průmyslové
Název výrobku: CN2B
Číslo výrobku: CN2B Varianty: Všechny
Počáteční sériové číslo: Všechna Datum vydání: 23.Prosinec.2005
Splňuje následující parametry výrobku:
Bezpečnostní: IEC 60950-1 / EN 60950-1
IEC 60825-1 / EN 60825-1 Jakost 1 LED Produkt
EMC: EN 55022 : 1998 / CISPR vyhláška 22: 1997, Limity a metody třídy B
EN 55024: 1998 (CISPR 24) Vybavení informační technologie – charakteristiky odolnosti –
Limity a metody měření
EN61000-3-2: 1995 + A1: 1998 + A1: 1998 + A1: 2000 – Vyzařované harmonické proudy
EN61000-3-3: 1994 – Kolísání napětí a blikání
ETSI EN 301 489-17
Radio: ETSI EN 300 328-2
Já, níže podepsaný, tímto potvrzuji, že výše uvedené vybavení splňuje požadavky výše uvedených nařízení a
standardů.
Zástupce společnosti: Michael Abel Pozice: viceprezident
Podpis: Podepsaná kopie v evidenci Datum: 23.Prosinec.2005
Evropský kontakt: Intermec International Incorporated, Sovereign House, Vastern Road, Reading, Berkshire, RG1 8BT England;
Telefon: MEZIN. +44 118 987 9400; Fax MEZIN.+44 118 987 9401
Kontakt v České republice: Global AmeriTech Corporation, Rytířská 10, 110 00, Praha 1, Česká republika;
Telefon: MEZIN. +420-224 210 493; Fax MEZIN. +420-224 211 729

Navigation menu