Intermec Technologies RFID915PCC-6 RF Identification PC Card User Manual 041116H2 User Info

Intermec Technologies Corporation RF Identification PC Card 041116H2 User Info

co location user info and compliance statement

Intermec Technologies Corporation REPORT NO: 041116-2
EMC Test Laboratory DATE: November 16, 2004
DOC. NO.: 577-501-218 Page 1 of 1
Co-Locate Radio Modules, IM3 and C30XX, 15.247, RSS-210, RSS-102 FCC ID: EHARFID915PCC-6
APPENDIX H, User Information
Technologies Corporation
EMC Test Laboratory
Cedar Rapids, IA
MEASUREMENT/TECHNICAL REPORT
Intermec Technologies Corporation
IV6 Transmitter Co-Location of
FCC ID: EHARFID915PCC-6 (IC: 1223A-RFIDPCC6)
And
FCC ID: HN2-C30XX (IC: 1223A-C30XX)
REPORT NO: 041116-2
DATE: November 16, 2004
Appendix H
USER INFORMATION
Page 2 IV6 Regulatory Compliance Information Insert
578-100-0xx Revision C Page 1 of 1
*578-100-0xx*
*578-100-0xx*
Compliance Statement Insert
Device Name: Vehicle Mounted RFID Reader Model Number: IV6
The responsible party for the compliance of this device is: Intermec Technologies Corporation
6001 36th Avenue West
Everett, WA 98203 USA
(425) 348-2600
This product conforms to the following approvals. The user(s) of this product are cautioned to use accessories and peripherals
approved by Intermec Technologies Corporation. The use of accessories other than those recommended or changes to this product
that are not approved by Intermec Technologies Corporation may void the compliance of this product and may result in the loss of
the users authority to operate the equipment.
This device complies with Part 15 of the FCC rules. Operation is subject to the two following conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
FCC Digital Emissions Compliance
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at his own expense.
Canadian Digital Apparatus Compliance
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
WARNING: per the FCC and Canada RF (radio frequency) exposure requirements,
(1) The IV6 antenna must be installed as recommended by Intermec Technologies to ensure compliance to RF exposure
requirements. Correct antenna mounting is fully described within the Intermec IV6 Users Guide.
(2) When installing and using Intermec Technologies the IV6 RFID tag reader, a 20-cm (8-inch) passing distance must
be maintained from any body part of the user or near by persons and the antenna. The antenna must not be touched
during transmitter operation.
(3) RF safety requirements mandate this device cannot be co-located with other transmitters.
WARNING: Canada procedures defined in RSS-210
"The installer of this radio equipment must ensure that the antenna is located or pointed such that it does not emit RF field in
excess of Health Canada limits for the general population; consult Safety Code 6, obtainable from Health Canada’s website
www.hc-sc.gc.ca/rpb"

Navigation menu