KAB Enterprise TR-022 Remote Controller User Manual RC 019 TR 022 20150819
Kab Enterprise Co., Ltd. Remote Controller RC 019 TR 022 20150819
User Manual
210x220MM Indoor Wireless Remote Control Operating Instructions This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation of the device. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. ON OFF Set Up 1. Plug the receiver into a standard 125-volt AC electrical outlet. 2. Confirm that the electrical specifications of an item you wish to use with this product do not exceed those specified in the "Electrical Ratings" section. Plug the item into an outlet of the receiver. 3. Remove the plastic battery tab from the battery compartment in the back of the remote control to activate the 3V lithium pre-installed battery. Item: RC-019/TR-022 ELECTRICAL RATINGS Range Up to 120ft. 125Vac 60Hz 15 A General Purpose 125Vac 60Hz 15 A Resistive 1,000 W Tungsten 500 VA Electronic Ballast 120Vac 60Hz 8.3A Ballast. 1/2 HP IMPORTANT SAFEGUARDS Signal Word Definitions NOTE: These are general definitions only; all may not pertain to the actual product purchased. DANGER – Indicates an imminently hazardous situation, which, if not avoided, will result in death or serious injury. Usage of this signal word is limited to the most extreme situations. WARNING – Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury. CAUTION – Indicates a potentially hazardous situation, which, if not avoided, may result in minor/moderate injury or product/property damage. It also alerts against unsafe practices. When using electrical products, always follow basic safety precautions including the following: READ ALL INSTRUCTIONS BEFORE USE. WARNING: To reduce the risk of fire, electric shock, or serious personal injury • Do not immerse the product in liquids • This product is not intended for use by children and contains small parts that may pose a choking hazard to children under the age of three. Keep the product out of the reach of children and pets. • Do not use an electrical device or appliance with this product whose electrical specifications exceed those specified in the “Electrical Specifications” section of this manual. CAUTION: To reduce the risk of personal injury or product/ property damage: • This product is intended for non-commercial, non-industrial use in the remote control of single electrical outlet. Do not use this product for any other purpose. Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for Class B digital device, harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. TO USE 1. To set up the receiver (outlet) with connecting device. 2. To activate the Receiver, press the ‘ON’ Button of the Remote Control. The red LED of the Remote Control will illuminate momentarily and the LED of the Receiver will remain illuminated. 3. To turn the Receiver OFF, press the ‘OFF’ Button of the Remote Control. The LED on the receiver will shut off. Battery Handling and Usage WARNING: Keep batteries away from children and pets. • Follow the battery manufacturer’s safety and usage instructions. • Insert the battery observing the proper polarity (+/−) as indicated inside the Battery Compartment. CAUTION: Failure to properly align the battery polarity can cause personal injury and /or property damage. • Remove a spent or discharged battery from the product. Remove the battery when not using the product for an extended period. • Never throw batteries into a fire. Do not expose batteries to fire or other heat sources. • Dispose or recycle spent/discharged batteries in compliance with all applicable laws. For detailed information, contact your local solid waste authority. • Battery contains mercury. Do not put in trash. Recycle or manage as hazardous waste. Receivers Battery Replacement: 1. Remove the Battery Compartment Cover from the back of the Remote Control by sliding the Cover in the direction that its treads curve. 2. Remove the spent battery and place a new 3V lithium battery into the Battery Compartment, correctly observing the polarity indications (+/−) inside the Battery Compartment. 3. Replace the Battery Compartment Cover. 3V ON OFF Remote Control 3V 3V Lithium Battery SAVE THESE INSTRUCTIONS! Made in China
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : Yes XMP Toolkit : Adobe XMP Core 5.3-c011 66.145661, 2012/02/06-14:56:27 Create Date : 2015:08:19 14:04:53+08:00 Creator Tool : Adobe Illustrator CS6 (Macintosh) Modify Date : 2015:08:19 14:04:53+08:00 Metadata Date : 2015:08:19 14:04:53+08:00 Thumbnail Width : 240 Thumbnail Height : 256 Thumbnail Format : JPEG Thumbnail Image : (Binary data 28403 bytes, use -b option to extract) Producer : Adobe PDF library 10.01 Format : application/pdf Title : RC-019_TR-022_20150819 N Pages : 1 Has Visible Transparency : False Has Visible Overprint : False Max Page Size W : 225.072222 Max Page Size H : 238.188045 Max Page Size Unit : Millimeters Font Name : ArialMT, TrebuchetMS, TrebuchetMS-Italic, TrebuchetMS-Bold, Trebuchet-BoldItalic, Arial, ArialMT-Bold Font Family : Arial, Trebuchet MS, Trebuchet MS, Trebuchet MS, Trebuchet MS, Arial, ArialMT Bold Font Face : Regular, Regular, Italic, Bold, Bold Italic, Bold Font Type : Open Type, Open Type, Open Type, Open Type, Open Type, Unknown, Unknown Font Version : Version 5.06, Version 5.00x, Version 5.00x, Version 5.00x, Version 5.00x, 9.0d5e1, 9.0d5e1 Font Composite : False, False, False, False, False, False, False Font File Name : Arial.ttf, Trebuchet MS.ttf, Trebuchet MS Italic.ttf, Trebuchet MS Bold.ttf, Trebuchet MS Bold Italic.ttf, STHeiti Light.ttc, STHeiti Light.ttc Plate Names : Cyan, Magenta, Yellow, Black Swatch Groups Group Name : Default Swatch Group Swatch Groups Group Type : 0 Document ID : xmp.did:0780117407206811822AEA739945B5E4 Instance ID : uuid:f14e5000-1878-274b-9fce-c1e8d51332a9 Original Document ID : xmp.did:74117FE820071168A0178776EF64EE38 Rendition Class : proof:pdf Derived From Instance ID : uuid:9561c631-24fc-3146-bf8f-657e431474d9 Derived From Document ID : xmp.did:A87F650C4B206811822AD499DD9615B8 Derived From Original Document ID: xmp.did:74117FE820071168A0178776EF64EE38 Derived From Rendition Class : proof:pdf History Action : saved, saved History Instance ID : xmp.iid:74117FE820071168A0178776EF64EE38, xmp.iid:0780117407206811822AEA739945B5E4 History When : 2011:04:15 11:10:07+08:00, 2015:08:19 14:04:49+08:00 History Software Agent : Adobe Illustrator CS4, Adobe Illustrator CS6 (Macintosh) History Changed : /, / Page Count : 1 Creator : Adobe Illustrator CS6 (Macintosh)EXIF Metadata provided by EXIF.tools