KAPSCH TRAFFICCOM CANADA 802477 TRP-8100 User Manual

KAPSCH TRAFFICCOM CANADA INC. TRP-8100

User Manual

TRP-8100 Interior Transponder Mounting Instructions for passenger vehiclesThe TRP-8100 transponder mounts in passenger vehicles on the windshield. LEDs on the side of the transponder provide transaction feedback. Mount the transponder with the LEDs visible to the driver.Preferred Mounting LocationAlternate Mounting Locationtop of windshield6 in. 6 in.6 in.rear view mirrorcenterline of mirror2 in.centerline of mirror and transpondertransponderLEDsrear view mirrorapprox. 1 in.TRP-8100 Transponder Mounting InstructionsSelect a mounting location, ensuring the LEDs are visible to the driver.The preferred mounting location is centered and to the left behind the rear view mirror, leaving approximately 1 in. of the left side of the transponder visible.Requirements For reliable operation of the transponder, the vehicle must be equipped with only one transponder while passing through a toll facility. Other transponders present in or on the vehicle must be switched o or enclosed in an RF shield. The mounting location must provide direct line-of-sight communication between the transponder and the toll facility overhead antenna. Apply Dual Lock™ fasteners in accordance with 3M™ document 70-0709-4029-4.If the transponder cannot be mounted in the preferred mounting location, mount the transponder anywhere within the alternate mounting area shown below:Kapsch TracCom IVHS
TRP-8100 Transponder - Rear View1. Clean the mounting location in accordance with 3M document 70-0709-4029-4.2. Remove the protective backing from the two Dual Lock fasteners and press the transponder onto the mounting location, ensuring the status LEDs on the left side of the transponder are facing the driver. Maintain the pressure for approximately 15 seconds to ensure a good bond.801850-023 rev A1.©Kapsch TracCom IVHS. All rights reserved. Subject to alteration without notice.3. Remove the transponder by lifting any corner with sucient force to separate the Dual Lock strips. Do not reuse the Dual Lock strips if removing them from the windshield. Obtain new strips as required.Kapsch TracCom IVHS | 6020 Ambler Drive | Mississauga, Ontario L4W 2P1 | CANADA | Phone +1 905 624 3020 | Fax +1 905 625 619754 S. Commerce Way, Suite 100 | Bethlehem, PA 18017 | Phone +1 610 419 1479 | Fax +1 610 419 1489E-Mail ktc.ca.info@kapsch.net | ktc.us.info@kapsch.net | www.kapsch.netKapsch GroupThe Kapsch Group and its entities Kapsch TracCom, Kapsch CarrierCom and Kapsch BusinessCom are specialised in the future-oriented market segments of Intelligent Transportation Systems (ITS) and Information and Communication Technology (ICT). Kapsch. Always one ste p ahead.Dual Lock fasteners

Navigation menu