Keeson Technology MC121 CONTROL BOX User Manual MC121

Keeson Technology Corporation Limited CONTROL BOX MC121

User Manual

Issue department：Bedding Division Date： 2018-03-26 ProductFunction instruction Author： Kyle No： MC121 Version： 1.1 Page 1 of 3 1MC121Functioninstruction1. Electricalconfigurationdiagram：2. FunctionPicture1. Processoftest1.1. HEADportConnecttoheadactuator,controlbyremotesingle:Clickhead upbuttonontheremote,headactuatormovesout,stopwhenreleased；Clickheaddownbutton，headactuatormovesin,stopwhenreleased；Thisfunctiontakeseffectonlybypressingthecorrespondingbuttonontheremote.FCC ID:PCU-RF258GAIC:21319-RF258GA
Issue department：Bedding Division Date： 2018-03-26 ProductFunction instruction Author： Kyle No： MC121 Version： 1.1 Page 2 of 3 21.4. MULTIFUNCTIONportConnectwiththesameOtheraccessories;1.5. PowerLED&PAIRINGLEDPowersupplyforcontrolbox,PAIRINGLEDofcontrolboxflashesfor4times,andthenturnsoff,POWERLEDturnson。1.6. PowerConnecttothe29VDC;1.7. PairFunctionPowerupcontrolbox，pairingLEDwillbeflash，thecontrolboxentersintomodeofcodeparing；PressandholdtheparingLEDofRemote,thebacklightofparingLEDflashes,thebacklightofremoteflashes,theremoteentersintomodeofcodeparing;ThebacklightofparingLEDofremotestopsflashing,andtheparingledofcontrolboxstopflash,itindicatesthatthecodeparingissuccessful;Iffails,repeatalltheprocessesabove;1.8. FLATfunctionPressandreleasetheFLAT buttononremote，theheadandfootactuatorsmovestolowerposition(whentheactuatorisfree,canturnoffthevibrationmotorandturnofftheindicatorlightwhenpressonce)，stopwhenpressanybuton；Thisfunctiontakeseffectonlybypressingthecorrespondingbuttonontheremote.1.9. ZEROGpositionfunctionPressandreleaseZERO Gbuttononremote，theheadandfootactuatormovestopresetmemoryposition，stopwhenpressanybutton；1.3. MassageConnecttoheadmassage,controlbyremote:Clickheadmassage+button,headmassagestrengthensbyonelevel;Clickheadmassage‐button,headmassageweakenbyonelevel;Thisfunctiontakeseffectonlybypressingthecorrespondingbuttonontheremote.1.2. FOOTportConnecttofootactuator,controlbyremotesingle:Clickfoot up button，footactuatormovesout，stopwhenreleased；Clickfoot downbutton，footactuatormovesin，stopwhenreleased；Thisfunctiontakeseffectonlybypressingthecorrespondingbuttonontheremote.
Issue department：Bedding Division Date： 2018-03-26 ProductFunction instruction Author： Kyle No： MC121 Version： 1.1 Page 3 of 3 3Thisfunctiontakeseffectonlybypressingthecorrespondingbuttonontheremote.FCC：Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.ISED RSS Warning:This device complies with Innovation,Science and Economic Development Canada licenceexempt RSS standard(s). Operation is subject to the following two conditions:(1) this devicemay not cause interference, and(2) this device must accept any interference, including interference that may cause undesired operation of the device.Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio exempts de licence.L'exploitation est autorisée aux deux conditions suivantes:(1) l'appareil ne doit pas produire de brouillage, et(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,même si le brouillage est susceptible d'en compromettre le fonctionnement.ISED RF exposure statement: This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment.This equipment should be installed and operated with minimum distance 20cm between the radiator& your body.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Le rayonnement de la classe b repecte ISED fixaient un environnement non contrôlés.Installation et mise en œuvre de ce matériel devrait avec échangeur distance minimale entre 20 cm ton corps.Lanceurs ou ne peuvent pas coexister cette antenne ou capteurs avec d’autres.

Navigation menu