Keymat Technology DS60 AXS Series S60 iClass SE PIN-Multiclass Contactless Reader User Manual DS60 xx 08KT

Keymat Technology Ltd AXS Series S60 iClass SE PIN-Multiclass Contactless Reader DS60 xx 08KT

Contents

Users manual - Datasheet

AXS Series – S60 Keypad DS60-xx-08KT Page 1 of 1 For more information visit www.storm-interface.com Rev 1 Sep 2015 © Copyright Storm Interface. 2015. All rights reserved This mullion format integrated keypad and contactless reader is rated for continuous outdoor use in exposed, unsupervised locations. Featuring genuine HID® iCLASS SE®, Seos®, contactless technology, this access control keypad offers enhanced security by dual factor authentication. Additionally available with HID® multiCLASS SE® for legacy 125kHz technology. Authorized access through a secured door or barrier can be gained by entry of a valid PIN and/or presentation of an authorised contactless credential. Installation - Fix the rear plate to the wall with 2 x screws - Make the wiring connections to the keypad - Set the rear halo illumination switch (default is ON, colour is blue) - Fit the keypad to the rear plate : locate at top and then push to engage clip - ( If you need to remove then use the supplied tool to disengage the clip) Wiring Connections Weigand Format for PIN Factory default is Weigand 4 bit burst format (for PIN). If you need other Weigand formats follow the sequence below. (to set site code on 26/32 bit refer to the S60 Engineering Manual) Press # on power up , LED FLASHES RED/GREEN Press #725 to enter format mode Press 1 for FORMAT Press 1 for 4 BIT FORMAT or 2 for 8 BIT FORMAT or 3 for 26 BIT FORMAT or 4 for 32 BIT FORMAT Press 0 to EXIT, LED STAYS RED Specification Card Compatibility iClass® , Mifare® , ISO15693, ISO14443A & B Card Read Range 2-11cm (depending on card) Credentials iClass®, SEOS®, Mifare Classic,Plus & Ultralight, Desfire 0.6 & EV1 Card Security V1 Security (Elite to special order only) Coupling Frequency 13.56 MHz Supply 12V DC +/- 15% at 500mA max Dimensions 205mm H x 45mm W x 21mm D (max) Tamper detection Either normally open or normally closed (set by wiring connections) Status Indication RED/GREEN as driven by the Controller (as supported by the controller) Performance Order Codes Operational Temp -35°C to +70°C DS601K20 AXS Series S60 iClass keypad, metal keys, mullion format Weather Resistant IP65 DS602W20 AXS Series S60i iClass keypad, illuminated keys, mullion format Vibration & Shock ETSI 6M3 Impact Resistance IK09 (10J Rating) DS601K2P AXS Series S60M Multiclass keypad, metal keys, mullion format Certification CE / FCC / IC / UL294 DS602W2P AXS Series S60iM Multiclass keypad, illuminated keys, mullion format. FCC ID 2AEEZ-DS60. Industry Canada IC 20014-DS60. This device complies with Part 15 of the FCC Rules and Industry Canada licence exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. HID ®, Seos® and iCLASS SE® are trademarks of HID Global Corporation / ASSA ABLOY AB. Storm, Storm Interface and Storm AXS are trademarks of Keymat Technology Ltd. Weigand 1 Weigand 0 TAMPER 0 V BEEPER LED +12 V

Navigation menu