LG Electronics USA 9SD751TVDA WIRELESS MOTION SENSOR User Manual
LG Electronics USA WIRELESS MOTION SENSOR
Contents
- 1. User Manual
- 2. Manual.pdf
User Manual
-1- -2- High ceiling spaces Like Warehouse, Storage areas, etc. Applications Simple installation just by pluging a sensor Easy adjustment using a rotary dial and a switch Wireless communication at 2.4 GHz Possible to be used for LG Lighting control system. Features - Wireless Highbay sensor detects motion and control LG LED Highbay efficiently. 17 mm 11 mm 75 mm • Do not install nearby inflammable material • Do not install in areas that have risks of flooding Do not store in a humid area. • Turn power off before install the product. • Do not disassemble the product. • Do not wipe the surface with inflammables such as alcohol, benzene and acetone. • Turn power off before install the product. 54 mm • Do not install nearby air conditioners and heaters. Violation of precautions may lead to light injury or product damage. CAUTION 25 mm 54 mm Dimensions Violation of warnings may lead to serious injury or death. WARNING Safety Precautions Specifications Model 9SD751TVDA Sensor Passive Infrared(PIR) Sensor Frequency 2405~2480 MHz, 16 ch Wireless range Line of sight 98 ft (30 m) Operating conditions For Indoor use only Temperature Operating : -4 to 122℉ (-20 to 50℃) Storage : -22 to 185℉ (-30 to 80℃) Humidity 0 to 85 % Rh Weight 1.1 oz (30 g) Dimensions (WHD) 2.6” x 2.1” x 1.0” (75 mm x 54 mm x 25 mm) installation height Typical 20 ft (6 m), up to 40 ft (13 m) Operating voltage 3.3 V DC (from LG LED lighting) Current consumption Max.80 mA FCC ID BEJ9SD751TVDA MFL68488801 WIRELESS HIGHBAY SENSOR 9SD751TVDA Disposal of your old appliance 1. When this crossed-out wheeled bin symbol is attached to a product it means the product is covered by the European Directive 2002/96/EC. 2. All electrical and electronic products shall be disposed of separately from the municipal waste stream via designated collection facilities appointed by the government or the local authorities. 3. The correct disposal of your old appliance will help prevent potential negative consequences for the environment and human health. 4. For more detailed information about disposal of your old appliance, please contact your city office, waste disposal service or the shop where you purchased the product. ※ Check out below address for more information. http://www.lg.com/global/sustainability/environment/ Please read this manual carefully before using the product. OWNER’S MANUAL Installation Plug the sensor to interface port on compatible LG LED lighting. WARNING Avoid metal and reinforced concrete walls etc, among sensors if you want to use it for LG Lighting control system. You have to plug the sensor completely. Troubleshooting Detection Area installation height : typical 20 ft (6 m), up to 40 ft (13 m) • Side view 0m 0ft diameter 20 ft (6.1 m) 10 12.2 40 6.1 20 • Check the settings by wireless setting tool. It is possible to select RED LED OFF. • Check the detection area. • Make sure installation state. you have to plug the sensor completely. • On specific operating temperature from 90℉(32℃) to 104℉(40℃), It may not detect motion. • Make sure installation state. you have to plug the sensor completely. • Check the delay time and dimming level non-occupancy. If delay times is too long or diming level is DIM state, lighting may be not OFF. 9.1 30 0m 0ft It is probably not detect motion. It is not flashes RED LED. Lighting is not OFF although nobody is occupancy. 6.1 20 6.1 20 LED operation Flashes once : occupancy detection Flashes twice : occupancy detection while Lighting System interworking Mode Flashes four times : setting completion by wireless setting tool On for 30 seconds after power-up : stability time Rapid flashes for 3 seconds : initialized Rapid flashes continuously : It is connected to non-compatible LG LED Lighting so it cannot work normally Very rapid flashed for 2 seconds : it is hold state about manual setting and network connection state. Motion detection is strange. It detects motion abnormally. diameter 40 ft (12.2 m) If you want to use it for larger areas than one detect area, install multiple sensors and set wireless connection. For further details, see xx page and contact the dealer that you purchased this product. • Check the installation environment. If there are air conditioner or heater, it should works abnormally. • Check the installation state. LED lighting plugged with sensor have to fix on ceiling and not shake. Adjustment • Delay time : occupancy It is possible to change a delay time from 30 sec to 20 min with the rotary dial. (default : 10 min) • Dimming level : non-occupancy It is possible to choose non -occupancy dimming level, OFF or DIM (default : OFF state) If you choose DIM, LG LED Lighting is dim when there is nobody. • initialized button Press the button over 5 seconds. If RED LED flashes rapidly for 3 seconds, it is initialized -3- -4- • Federal Communications Commission (FCC) Statement • FCC WARNING You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an nauthorized change or modification is made R&TTE Directive 1999/5/EC EMC Directive 2004/108/EC LOW VOLTAGE Directive 2006/95/EC The products described above comply with the essential requirements of the directives specified. This device is a 2.4GHz wideband transmission system, intended for use in all EU member states and EFTA countries. Contact office for compliance of this product: LG Electronics Inc EU Representative, Krijgsman 1, 1186 DM Amstelveen, The Netherlands This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation of the device of the device. Please note that this is NOT a Customer Service contact point. For Customer Service Information, see Warranty Card or contact the dealer that you purchased this product. • FCC Caution CE Notified Body statement. This is a class B product. In a domestic environment, this product may causes radio interference, in which case the user may be required to take adequate measures. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment and For indoor use only, use outdoors or in other modes not covered by this manual may violate the FCC regulation and violate the user authority to use the product. Indoor use only. • FCC RF Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. -5- LG Electronics hereby declares declares that this product is in compliance with the following Directives. -6-
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : Yes XMP Toolkit : 3.1-701 Format : application/pdf Title : 140508_MFL68488801_하이베이 센서_메뉴얼 Metadata Date : 2014:05:15 17:38:03+08:00 Modify Date : 2014:05:15 17:38:03+08:00 Create Date : 2014:05:09 18:17:05+10:00 Creator Tool : Adobe Illustrator CS6 (Windows) Thumbnail Width : 256 Thumbnail Height : 160 Thumbnail Format : JPEG Thumbnail Image : (Binary data 17807 bytes, use -b option to extract) Instance ID : uuid:f73453dd-9182-4422-91fa-a33e500b526f Document ID : xmp.did:51633AAF5AD7E311A614933F70F9CBA9 Original Document ID : uuid:5D20892493BFDB11914A8590D31508C8 Rendition Class : proof:pdf Derived From Instance ID : uuid:44f583c7-4011-4c77-8b8c-df3bba9a184b Derived From Document ID : xmp.did:D6A15B0859D6E3118200E81D3C871A5E Derived From Original Document ID: uuid:5D20892493BFDB11914A8590D31508C8 Derived From Rendition Class : proof:pdf History Action : saved, saved History Instance ID : xmp.iid:D6A15B0859D6E3118200E81D3C871A5E, xmp.iid:51633AAF5AD7E311A614933F70F9CBA9 History When : 2014:05:08 11:50:28+09:00, 2014:05:09 18:17:03+09:00 History Software Agent : Adobe Illustrator CS6 (Windows), Adobe Illustrator CS6 (Windows) History Changed : /, / Manifest Link Form : EmbedByReference Manifest Reference File Path : C:\Users\user\Desktop\하이베이센서수정_0509.png Startup Profile : Print Has Visible Overprint : True Has Visible Transparency : True N Pages : 1 Max Page Size W : 148.000958 Max Page Size H : 210.001652 Max Page Size Unit : Millimeters Font Name : ArialMT, Arial-BoldMT, YDIYGO330 Font Family : Arial, Arial, -윤고딕330 Font Face : Regular, Bold, Regular Font Type : Open Type, Open Type, TrueType Font Version : Version 5.10, Version 5.08, Version 2.00 Font Composite : False, False, False Font File Name : arial.ttf, arialbd.ttf, 윤고딕330_0.ttf Plate Names : Cyan, Magenta, Yellow, Black Swatch Groups Colorants Tint : 100.000000 Swatch Groups Group Name : Brights Swatch Groups Group Type : 1 Swatch Groups Colorants Swatch Name: C=60 M=90 Y=0 K=0 Swatch Groups Colorants Mode : CMYK Swatch Groups Colorants Type : PROCESS Swatch Groups Colorants Cyan : 60.000002 Swatch Groups Colorants Magenta : 90.000004 Swatch Groups Colorants Yellow : 0.003099 Swatch Groups Colorants Black : 0.003099 Producer : Adobe PDF library 10.01 Has XFA : No Page Count : 2 Container Version : 11 Creator Version : 16 Creator : Adobe Illustrator(R) 16.0 For : ��츮/���/Lighting������(uri.kim@lge.com), Bounding Box : -100 -596 858 1EXIF Metadata provided by EXIF.tools