LG Electronics USA WB2NB8 Bluetooth Module User Manual

LG Electronics USA Bluetooth Module

User Manual

User ManualPRODUCT NAME : Bluetooth 4.0 ModuleMODEL NAME : WB2NB8(TWBM-C302D)The information contained herein is the exclusive property of LG Innotekand shall not be distributed, reproduced or disclosed in whole or no in partwithout prior written permission of LG Innotek.
SPECIFICATIONPAGE :DOCUMENT No. : -REG. DATE : 2017. 10. 18MODEL NAME : WB2NB8(TWBM-C302D)REV. NO : 1.0REV. DATE : 2017. 10. 18Copyrightⓒ. 2017. All Rights Reserved.1 / 9Table of ContentsNo Description Page1 Features 22 Picture of Product 23 Installation Manual 34 Block Diagram 45 Absolute Maximum Ratings 46 Operating Test Conditions 57 Standard Test Conditions 58 Pin Description 69 Outline Drawing 710 Packing Information 8
SPECIFICATIONPAGE :DOCUMENT No. : -REG. DATE : 2017. 10. 18MODEL NAME : WB2NB8(TWBM-C302D)REV. NO : 1.0REV. DATE : 2017. 10. 18Copyrightⓒ. 2017. All Rights Reserved.2 / 92. Picture of Product1. FeaturesTWBM-C302D is the small size and low power module for Bluetooth 4.0.TWBM-C302D is based on Qualcomm CSR8510A10.Bluetooth 4.0 specification with EDR function / Class 1Size : 34mm x 19mm x 3.1 mmInternal PCB Printed AntennaUSB 2.0 interfaceApplication : DTV, DVR, HD DVD Player, Blue-ray Disk Player, STB< Top > < Bottom >
SPECIFICATIONPAGE :DOCUMENT No. : -REG. DATE : 2017. 10. 18MODEL NAME : WB2NB8(TWBM-C302D)REV. NO : 1.0REV. DATE : 2017. 10. 18Copyrightⓒ. 2017. All Rights Reserved.3 / 93. Installation ManualInstall the module like below on the Sound bar
SPECIFICATIONPAGE :DOCUMENT No. : -REG. DATE : 2017. 10. 18MODEL NAME : WB2NB8(TWBM-C302D)REV. NO : 1.0REV. DATE : 2017. 10. 18Copyrightⓒ. 2017. All Rights Reserved.4 / 95. Absolute Maximum Ratings4. Block DiagramParameter Min Max UnitStorage Temperature -10 +80 ℃Storage Humidity (40℃)- 90 %Caution : The specifications below the Table define levels at which permanent damage to the device can occur. Function operation is not guaranteed under these conditions. Operating at absolute maximum conditions for extend periods can adversely affect the long-term reliability of the device.• Other conditions1) Do not use or store modules in the corrosive atmosphere, especially where chloridegas, sulfide gas, acid, alkali, salt or the like are contained. Also, avoid exposure to moisture. 2) Store the modules where the temperature and relative humiditydo not exceed 5 to 40℃and 20 to 60%.Interface ConnectorCSR8510 A10Ant.(2402~2480 MHz)2.4GHz RadioROMPIOUSB26MHzMMUMCUI/O3.3VRAMEEPROMRF LPF
SPECIFICATIONPAGE :DOCUMENT No. : -REG. DATE : 2017. 10. 18MODEL NAME : WB2NB8(TWBM-C302D)REV. NO : 1.0REV. DATE : 2017. 10. 18Copyrightⓒ. 2017. All Rights Reserved.5 / 9Parameter Min Typ Max UnitAmbient Temperature 0 - 60 ℃Operating Humidity (40℃)- - 85 %Supply Voltage 3.135 3.3 3.465 VdcThe Test for electrical specification shall be performed under the following conditionOtherwise this following conditions, not guaranteed this performance.6. Operating Test ConditionsTemperature 25 ±5℃Humidity 65 ±5%Input power(VDD) Supply Voltage+3.3V +3.3V ±0.165V(5%)7. Standard Test Conditions7-1. Ambient condition7-2. Power supply voltages
SPECIFICATIONPAGE :DOCUMENT No. : -REG. DATE : 2017. 10. 18MODEL NAME : WB2NB8(TWBM-C302D)REV. NO : 1.0REV. DATE : 2017. 10. 18Copyrightⓒ. 2017. All Rights Reserved.6 / 98. Pin DescriptionNote.1) Recommend a Module install sequence for prevent operation failure- Supply 3.3V power - Connect to pins2) Connector : 12 Pin SMD Connector AAPIN No. Pin Name Type Pin Description1 3.3VA Input 3.3V Power Supply2 3.3VA Input 3.3V Power Supply3 NC - -4 GND - Ground5 GND - Ground6 USB+ Input / Output USB Communication signal USB D+7 USB- Input / Output USB Communication signal USB D+8 GND - Ground9 GND - Ground10 RESET Input Bluetooth Reset11 BT_WAKEUP Output Bluetooth Host Wake12 MCU_STBY Input / Output MCU Standby
SPECIFICATIONPAGE :DOCUMENT No. : -REG. DATE : 2017. 10. 18MODEL NAME : WB2NB8(TWBM-C302D)REV. NO : 1.0REV. DATE : 2017. 10. 18Copyrightⓒ. 2017. All Rights Reserved.7 / 99. Outline Drawing
SPECIFICATIONPAGE :DOCUMENT No. : -REG. DATE : 2017. 10. 18MODEL NAME : WB2NB8(TWBM-C302D)REV. NO : 1.0REV. DATE : 2017. 10. 18Copyrightⓒ. 2017. All Rights Reserved.8 / 910. Packing Information
SPECIFICATIONPAGE :DOCUMENT No. : -REG. DATE : 2017. 10. 18MODEL NAME : WB2NB8(TWBM-C302D)REV. NO : 1.0REV. DATE : 2017. 10. 18Copyrightⓒ. 2017. All Rights Reserved.9 / 9
FCC WARNING STATEMENTThis device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operationAny changes or modifications (including the antennas) to this device that are not expressly approved by the manufacturer may void the user's authority to operate the equipment.Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications, However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. Modifications not expressly approved by the manufacturer could void your authority to operate the equipment under FCC rules.FCC RF Radiation Exposure StatementThis equipment complies with FCC RF Radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. Information for OEM integratorThe OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user manual of the end product. The user manual which is provided by OEM integrators for end users must include the following information in a prominent location.“To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.” Label for end product must include “Contains FCC ID: BEJ-WB2NB8, IC: 2703H-WB2NB8" or "A RF transmitter inside, FCC ID: BEJ-WB2NB8, IC: 2703H-WB2NB8".
IC WARNING STATEMENTThis device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions : (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.This equipment complies with IC RF Radiation exposure limits set forth for an uncontrolledenvironment. This device and its antenna must not be co-located or operating in conjunctionwith any other antenna or transmitter.This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.Cet équipement est conforme aux limites établies par Industrie Canada en matière d'exposition aux radiofréquences dans un environnement non contrôlé. Cet appareil et son antenne ne doivent pas être colocalisés ou fonctionner en conjonction avec tout autre antenne ou émetteur.Cet équipement doit être installé et utilisé avec une distance minimale de 20cm entre le radiateur et votre corps.

Navigation menu