LG Electronics USA WCDH100 Wireless Charger User Manual 01 LG W280A ATT UG EN 161125 indd

LG Electronics MobileComm USA, Inc. Wireless Charger 01 LG W280A ATT UG EN 161125 indd

User Manual_WCD-H100

Download: LG Electronics USA WCDH100 Wireless Charger User Manual 01 LG W280A ATT UG EN 161125 indd
Mirror Download [FCC.gov]LG Electronics USA WCDH100 Wireless Charger User Manual 01 LG W280A ATT UG EN 161125 indd
Document ID3213745
Application IDBboerUrxLBD5JwTSosH5SQ==
Document DescriptionUser Manual_WCD-H100
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize54.2kB (677457 bits)
Date Submitted2016-11-30 00:00:00
Date Available2017-05-23 00:00:00
Creation Date2016-11-29 09:31:17
Producing SoftwareAcrobat Distiller 9.5.5 (Windows)
Document Lastmod2016-11-30 17:55:16
Document Title01_LG-W280A_ATT_UG_EN_161125.indd
Document CreatorAdobe InDesign CS5 (7.0.4)
Document Author: kwon

Charging Your Watch
Before using your watch for the first time, you should charge the battery.
Use the charging cord and cradle provided with your watch to charge its
battery.
The supplied charging cord will allow you to charge from a power outlet
or from a computer.
• When the battery power is low, the battery icon may show as empty. If
the battery charge is completely empty, the watch cannot be turned on
immediately after connecting the charger. Leave an empty battery to
charge for a few minutes before turning the device on. Some features
are not available while the battery is charging.
• To charge your device, always use the included power adapter, USB
cable, and charging cradle that come with your device. Using thirdparty charging solutions can cause fire, electric shock, injury, or damage
to your device or other property.
• Your device has an internal rechargeable battery. For your safety, do not
remove the embedded battery.
1 Connect the USB cable to the USB/Charger port on the charging
cradle.
USB/Charger port
Basic Functions
2 Plug the charger adapter into a power outlet.
• To charge from a power outlet, connect the USB plug on the
charging cord to the charger adaptor, then plug the charger
adaptor into an outlet.
• To charge from a PC, insert the USB plug on the charging cord into
a USB port on the PC.
• A power source connected a PC may result in a slower charging speed
due to a lower electric current than a power outlet.
3 Place the your device on the charging cradle as shown below.
• The charging cord is designed to only be used with the watch and is
not compatible with other devices.
• To maximize battery life, make sure that the battery is fully charged
before you use the device for the first time.
• Exposure to liquids or other foreign materials while using your device
may affect the charging cradle, causing it to disconnect from the watch
while charging.
• If the charging screen does not display after connection to a power
source, adjust your device’s position on the charging cradle.
Basic Functions
4 While your watch is charging, the screen will show the time, battery
percentage and charging progress (indicated by the ring around the
outside).
Charging progress
Time
Battery percentage
5 Once the battery is fully charged, remove it from the charging cradle.
• The watch may become warm while charging. If the device becomes
hotter than usual, discontinue charging until it cools.
Basic Functions
FCC NOTICE TO USERS
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications are not expressly approved by the manufacturer
(or party responsible) for compliance could void the user’s authority to
operate the equipment.
IMPORTANT NOTE:
To comply with the FCC RF exposure compliance requirements, no change
to the antenna or the device is permitted. Any change to the antenna or the
device could result in the device exceeding the RF exposure requirements
and void the user’s authority to operate the device.
This equipment should be installed and operated with a minimum distance
of 20 cm between the radiator and your body.
IC NOTICE TO USERS
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
IC Radiation Exposure Statement
This equipment complies with IC RF Radiation exposure limits set forth for an
uncontrolled environment. This device and its antenna must not be colocated or operating in conjunction with any other antenna or transmitter.
This equipment should be installed and operated with a minimum distance
of 20cm between the radiator and your body.
Cet équipement est conforme aux limites établies par Industrie Canada en
matière d'exposition aux radiations dans un environnement non contrôlé.
Cet équipement ne doivent pas être colocalisés ou fonctionner en
conjonction avec tout autre antenne ou émetteur.
Cet équipement doit être installé et utilisé avec une distance minimale de 20
cm entre le radiateur et votre corps.

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
Author                          : kwon
Create Date                     : 2016:11:29 09:31:17+09:00
Modify Date                     : 2016:11:30 17:55:16+09:00
Has XFA                         : No
XMP Toolkit                     : Adobe XMP Core 5.4-c005 78.147326, 2012/08/23-13:03:03
Metadata Date                   : 2016:11:30 17:55:16+09:00
Creator Tool                    : Adobe InDesign CS5 (7.0.4)
Format                          : application/pdf
Title                           : 01_LG-W280A_ATT_UG_EN_161125.indd
Creator                         : kwon
Document ID                     : uuid:0e78bcd9-4e36-4a33-a549-05e031e15680
Instance ID                     : uuid:8486ea5a-7fc0-4e65-af80-963d9210e4fb
Producer                        : Acrobat Distiller 9.5.5 (Windows)
Page Count                      : 4
EXIF Metadata provided by EXIF.tools
FCC ID Filing: ZNF-WCDH100

Navigation menu