Lenovo Mobile Communication Technology A7010A48 Lenovo Mobile Phone User Manual
Lenovo Mobile Communication Technology Ltd. Lenovo Mobile Phone
User manual
Lenovo A7010 Quick Start Guide Lenovo A7010a48 Read this guide carefully before using your smartphone. Reading before using your smartphone For your safety Before assembling, charging or using your mobile device for the first time, please read the important product safety and legal information provided with your product. If your mobile device becomes unresponsive, try a reboot—press and hold the On/Off button until the screen goes dark and your device restarts. Usage This phone supports apps and services that may use a lot of data, so make sure your data plan meets your needs. Contact your service provider for details. Certain apps and features may not be available in all countries. Electronic label Your mobile device may use an electronic label that provides some regulatory information about the device. To see the electronic label, go to Settings > About phone > Regulatory information on your device. First glance 1 2 12 13 14 11 10 16 15 1 Receiver/Speaker 2 Front-facing camera 3 Light/Proximity sensor 4 Fill Light 5 Volume buttons 6 On/Off button 7 Touch screen 8 Speaker 9 Back button 10 Home button 11 Multitask button 12 Rear-facing camera 13 Flash 14 Fingerprint 15 Microphone 16 Micro USB connector Installing the Micro SIM and microSD cards A Micro SIM card provided by your carrier is required in order to use cellular services. Install the Micro SIM and microSD cards as shown. Micro Micro SIM SIM IM ro S Mic IM oS IM ro S Mic o SI Micr IM Step 1. Insert the Micro SIM cards into SIM1 slot and SIM2 slot. Tips: Both of the card slots support 2G, 3G and 4G data services. When two cards are inserted at the same time, the system supports only one of them to register for 3G or 4G data service. If you want to change the data service type of the card, go to Settings > SIM management > Data connection. ro S Mic o SI Micr o SI Micr Step2 . Insert the microSD card. Only Micro SIM cards work with your smartphone. Always turn off your smartphone first before you insert or remove a Micro SIM card. Insert or remove a Micro SIM card with your smartphone on may damage your Micro SIM card or smartphone permanently. Charging the battery Charge the battery as shown. Method 1. Connect your smartphone to a power outlet using the cable and USB power adapter that come with your smartphone. Method 2. Connect your smartphone to a computer using the cable that comes with your smartphone. Low battery power Fully charged Charging Turning on or turning off your smartphone Turn on: Press and hold the On/Off button until the Lenovo logo appears. Turn off: Press and hold the On/Off button for a few seconds, then tap Power off. Restart: Press and hold the On/Off button for about 10 seconds. Copyright and trademarks Certain features, services and applications are network dependent and may not be available in all areas; additional terms, conditions and/or charges may apply. Contact your service provider for details. All features, functionality, and other product specifications, as well as the information contained in this guide, are based upon the latest available information and believed to be accurate at the time of printing. Lenovo reserves the right to change or modify any information or specifications without notice or obligation. Note: The images in this guide are examples only. Lenovo and the Lenovo logo are trademarks of Lenovo in the United States, other countries, or both. Manufactured under license from Dolby Laboratories. Dolby, Dolby Atmos, and the double-D symbol are trademarks of Dolby Laboratories. Android, Google and other trademarks are owned by Google Inc. The Android robot is reproduced or modified from work created and shared by Google and used according to terms described in the Creative Commons 3.0 Attribution License. All other product or service names are the property of their respective owners. © Copyright Lenovo 2015. Product ID: Lenovo A7010 (Model A7010a48) Manual Number: 68XXXXXXXX-X RF Exposure Information (SAR) This phone is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the United States. During SAR testing, this device was set to transmit at its highest certified power level in all tested frequency bands, and placed in positions that simulate RF exposure in usage against the head with no separation, and near the body with the separation of 10 mm. Although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value. This is because the phone is designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you are to a wireless base station antenna, the lower the power output. The exposure standard for wireless devices employing a unit of measurement is known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. This device is complied with SAR for general population /uncontrolled exposure limits in ANSI/IEEE C95.1-1992 and had been tested in accordance with the measurement methods and procedures specified in IEEE1528. The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model phone is on file with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC ID: YCNA7010A48. For this device, the highest reported SAR value for usage against the head is 1.12 W/kg, for usage near the body is 1.06 W/kg. While there may be differences between the SAR levels of various phones and at various positions, they all meet the government requirements. SAR compliance for body-worn operation is based on a separation distance of 10 mm between the unit and the human body. Carry this device at least 10 mm away from your body to ensure RF exposure level compliant or lower to the reported level. To support body-worn operation, choose the belt clips or holsters, which do not contain metallic components, to maintain a separation of 10 mm between this device and your body. RF exposure compliance with any body-worn accessory, which contains metal, was not tested and certified, and use such body-worn accessory should be avoided. FCC Regulations This mobile phone complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This mobile phone has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiated radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. FCC Note: Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment. Learning more Getting support To get support on network service and billing, contact your wireless network operator. To learn how to use your smartphone and view its technical specifications, go to http://support.lenovo.com/. Downloading publications To obtain the latest smartphone manuals, go to: http://support.lenovo.com/ Accessing your User Guide Your User Guide contains detailed information about your smartphone. To access your User Guide, go to http://support.lenovo.com and follow the instructions on the screen.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : No Encryption : Standard V4.4 (128-bit) User Access : Print, Modify, Copy, Annotate, Fill forms, Extract, Assemble, Print high-res Create Date : 2015:12:07 16:17:48+09:00 Creator : Adobe Illustrator CS6 (Windows) Modify Date : 2015:12:08 14:39:45+08:00 Has XFA : No Page Count : 10 XMP Toolkit : Adobe XMP Core 5.4-c005 78.147326, 2012/08/23-13:03:03 Format : application/pdf Title : XXXXXXXXX Lenovo A7010a48 QSG for Moto Chile EN 110_74mm V1.0 20151207 FCC 填写数值 Metadata Date : 2015:12:07 16:19:36+08:00 Creator Tool : Adobe Illustrator CS6 (Windows) Thumbnail Width : 256 Thumbnail Height : 140 Thumbnail Format : JPEG Thumbnail Image : (Binary data 15589 bytes, use -b option to extract) Instance ID : uuid:30b349f1-272e-4d51-a60c-70d3e8d21b81 Document ID : xmp.did:6B4C23E4BA9CE51187C7A2700CF79D3E Original Document ID : uuid:5D20892493BFDB11914A8590D31508C8 Rendition Class : proof:pdf Derived From Instance ID : xmp.iid:6A4C23E4BA9CE51187C7A2700CF79D3E Derived From Document ID : xmp.did:6A4C23E4BA9CE51187C7A2700CF79D3E Derived From Original Document ID: uuid:5D20892493BFDB11914A8590D31508C8 Derived From Rendition Class : proof:pdf History Action : saved, saved History Instance ID : xmp.iid:2B09D2E15386E211B8309B1002AA9714, xmp.iid:6B4C23E4BA9CE51187C7A2700CF79D3E History When : 2013:03:06 19:49:20+08:00, 2015:12:07 16:17:45+08:00 History Software Agent : Adobe Illustrator CS6 (Windows), Adobe Illustrator CS6 (Windows) History Changed : /, / Startup Profile : Print Has Visible Overprint : True Has Visible Transparency : False N Pages : 1 Max Page Size W : 73.999962 Max Page Size H : 109.999487 Max Page Size Unit : Millimeters Font Name : HelveticaNeueLTStd-Lt, HelveticaNeueLTStd-LtIt, HelveticaNeueLTStd-Roman, HelveticaNeueLTStd-Md, HelveticaNeueLTStd-MdIt, HelveticaNeueLTStd-Bd, AdobeSongStd-Light Font Family : Helvetica Neue LT Std, Helvetica Neue LT Std, Helvetica Neue LT Std, Helvetica Neue LT Std, Helvetica Neue LT Std, Helvetica Neue LT Std, Adobe 宋体 Std Font Face : 45 Light, 46 Light Italic, 55 Roman, 65 Medium, 66 Medium Italic, 75 Bold, L Font Type : Open Type, Open Type, Open Type, Open Type, Open Type, Open Type, Open Type Font Version : OTF 1.029;PS 001.002;Core 1.0.33;makeotf.lib1.4.1585, OTF 1.029;PS 001.004;Core 1.0.33;makeotf.lib1.4.1585, Version 1.047;PS 001.103;Core 1.0.38;makeotf.lib1.6.5960, OTF 1.029;PS 001.002;Core 1.0.33;makeotf.lib1.4.1585, OTF 1.029;PS 001.103;Core 1.0.33;makeotf.lib1.4.1585, OTF 1.029;PS 001.102;Core 1.0.33;makeotf.lib1.4.1585, Version 5.016;PS 5.002;hotconv 1.0.67;makeotf.lib2.5.33168 Font Composite : False, False, False, False, False, False, False Font File Name : HelveticaNeueLTStd-Lt_7.otf, HelveticaNeueLTStd-LtIt_0.otf, HelveticaNeueLTStd-Roman_7.otf, HelveticaNeueLTStd-Md_7.otf, HelveticaNeueLTStd-MdIt_0.otf, HelveticaNeueLTStd-Bd_0.otf, AdobeSongStd-Light.otf Plate Names : Cyan, Magenta, Yellow, Black, PANTONE 485 C, PANTONE 424 C Swatch Groups Colorants L : 60.000000 Swatch Groups Colorants A : 53 Swatch Groups Colorants B : 21 Swatch Groups Colorants Red : 137 Swatch Groups Colorants Green : 211 Swatch Groups Colorants Blue : 0 Swatch Groups Colorants Tint : 100.000000 Swatch Groups Group Name : 明亮 Swatch Groups Group Type : 1 Swatch Groups Colorants Swatch Name: C=60 M=90 Y=0 K=0 Swatch Groups Colorants Mode : CMYK Swatch Groups Colorants Type : PROCESS Swatch Groups Colorants Cyan : 60.000002 Swatch Groups Colorants Magenta : 90.000004 Swatch Groups Colorants Yellow : 0.003099 Swatch Groups Colorants Black : 0.003099 Producer : Adobe PDF library 10.01EXIF Metadata provided by EXIF.tools