MOBASE ELECTRONICS SYEBCM1611 Unit Assy-BCM & Receiver User Manual

SEOYON ELECTRONICS CO., LTD. Unit Assy-BCM & Receiver

User Manual

Title : NO.Date0. GENERAL0.1. MakeSEOYON ELECTRONICS0.2. Model No.- Transmitter- Receiver0.3. Name and address of manufacturerSEOYON ELECTRONICS424, Sinwon-ro, Danwon-gu, Ansan-si, Gyeonggi-do, Korea0.4. Address of assembly plantSEOYON ELECTRONICS424, Sinwon-ro, Danwon-gu, Ansan-si, Gyeonggi-do, Korea711, Baekseok-dong, Seobuk-gu, Cheonan-si, Chungcheongnam-do, KoreaRemote Keyless Entry TransmitterSYEC3TX1612Unit Assy-BCM & ReceiverSYECBCM1611Information Document
Title : NO.Date2. PRODUCT SPECIFICATION2.1 Remote Keyless Entry System2.1.1 KEY PART : TRANSMITTER is inside of the REMOTE KEY, and itsends the ROLLING CODE to the RECEIVER by Radio Frequency.2.1.2 RECEIVER : It receives the ROLLING CODE and decodes that,thereafter RECEIVER drives the actuator.2.2 SPECIFICATIONS2.2.1 TRANSMITTER2.2.2 RECEIVERITEM SPECIFICATIONRated supply voltage DC 3VOperating voltage range DC 2.5 ~ 3.2VOperating temperature range -20 ~+60℃Frequency 433.92MHzCode Rolling Code(Hopping Algorithm)Storage temperature range -30 ~ 80℃Modulation FSKBattery life 3 Year(20Cycle/Day)(Lithium 3V 1EA)Electric field strength 10mW (433.92MHz)Below than 4.0mAOperating Temperature - 35 ~ + 75℃Max Humidity 95%Standby Current (in alarm setting condition)SpecificationItemDC 9 ~ 16VOperating VoltageDC 12VRated Supply VoltageInformationInformation Document
Title : NO.Date2.3 Operating summary①TRANSMITTER's button is pushed.②TRANSMITTER sends the code by radio frequency.③RECEIVER gets the code and decodes it.④RECEIVER judges the code whether it is right code or not.⑤RECEIVER checks door lock or unlock Tail-Gate state.⑥RECEIVER drives the actuator.2.3.1 LOCK & UNLOCK①If LOCK or UNLOCK button is pushed for less than 1 sec, thenTRANSMITTER sends the LOCK or UNLOCK DATA.2.4 Caution①Danger of explosion if battery is incorrectly replaced.②Replace only with the same or equivalent type recommended by the manufacturer.③Dispose of used batteries according to the manufacturer's instructions.Information DocumentInformation Document
Title : NO.Date3. USER MANUAL3.1 NAME : BCM system- This system is BCM and inculdes RKE.- RKE in BCM system is intended for auto door lock or unlock or TAIL-GATE in vehicle.- This BCM system is to be installde on motor vehicles as *OE item.*OE : Original Equipment.*BCM : Body Control Module.*RKE : Remote Keyless Entry.3.2 SYSTEM CONSTRUCTION3.2.1 SYSTEM IN VEHICLE3.2.2 SYSTEM FOR TEST* Through the use of lamp, operating state is displayed by lamp.lamp 'ON' means that actuator is operated by door lock or unlock or tail-gate output signal.Information DocumentInformation DocumentInformation DocumentInformation DocumentANTENNAROLLING CODE(433.92MHz)ANTENNARECEIVERBATTERYlampROLLING CODE(433.92MHz)LOCK or UNLOCK or TAIL-GATE DATABATTERYDOORACTUATORRECEIVER
FCC Information This device complies with part 15 of the FCC Results. Operation is subject to the following two conditions : (1) This Device may not cause harmful interface, and (2) This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for CLASS B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try correct the interference by one or more of the following measures: 1.1. Reorient or relocate the receiving antenna. 1.2. Increase the separation between the equipment and receiver. 1.3. Connect the equipment into an outlet on a circuit different from that to which receiver is connected. 1.4. Consult the dealer or experienced radio/TV technician for help. WARNING Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate the equipment. “CAUTION : Exposure to Radio Frequency Radiation. Antenna shall be mounted in such a manner to minimize the potential for human contact during normal operation. The antenna should not be contacted during operation to avoid the possibility of exceeding the FCC radio frequency exposure limit. "ATTENTION: L'exposition aux rayonnements à fréquence radioélectrique. Antenne doit être montée de telle manière à minimiser le risque de contact humain pendant l'utilisation normale. L'antenne ne doit pas être contacté pendant le fonctionnement pour éviter la possibilité de dépasser la limite de l'exposition aux fréquences radio de la FCC.
IC Information This device complies with Industry Canada license-exempt RSS standard(s). Operation in subject to The following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: 1) l’appareil ne doit pas produire de brouillage; 2) l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

Navigation menu